Frigidaire RNAB081J1JBRG Manual

Frigidaire Ismaskine RNAB081J1JBRG

Læs gratis den danske manual til Frigidaire RNAB081J1JBRG (24 sider) i kategorien Ismaskine. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Frigidaire RNAB081J1JBRG, eller vil du spørge andre brugere om produktet?

Side 1/24
AUTOMATIC ICE MAKER
INSTALLATION INSTRUCTIONS
P/N: 240394908
The following items will be required to install the ice maker kit:
¼ inch copper supply line with shut off valve
¼ inch brass compression nut and ferrule
Freezer shelf (Some models not equipped with shelf). If your model does not have one, contact your dealer to order
one.
The copper tubing and shut off valve are available in a kit from your local hardware or plumbing supply store. Coil enough
tubing at the back of the unit to allow movement for cleaning.
WARNING
To avoid electric shock, which can cause death or severe personal injury, disconnect the refrigerator from electrical
power before connecting a water supply line to the refrigerator.
Connect the ice maker to a potable water supply only.
CAUTION
To Avoid Property Damage:
Copper tubing is recommended for the water supply line. Water supply tubing made of ¼ inch plastic should not be
used since it greatly increases the potential for water leaks. The manufacturer will not be responsible for any damage
if plastic tubing is used for the supply line.
DO NOT install water supply tubing in areas where temperatures fall below freezing.
Chemicals from a malfunctioning water softener can damage the ice maker. If the ice maker is connected to softened
water, ensure that the softener is maintained and working properly.
WARNING
Ice maker kit should be installed only by an authorized service technician.
2
Tools Required:
Plastic Putty Knife PhillipsTM Screwdriver
¼ inch Socket Wrench or Nut Driver Needle Nose Pliers
Adjustable Wrench Power Drill with PhillipsTM bit
Small Kitchen Knife
Use This Page to Identify Parts
1. Ice Maker 2. Ice Container 3. Plastic Water Supply Tubing
OR
4. Screws - Qty 2 5. Screws - Qty 2 7. Leveling Bracket - Qty 16. Leveling Bracket Screw -
Qty 1
8. Steel Clamp - Qty 1 10. Water Valves - Qty 19. Plastic Clamp - Qty 2
OR
12. Tube Seal - Qty 111. Water Inlet Tube - Qty 1


Produkt Specifikationer

Mærke: Frigidaire
Kategori: Ismaskine
Model: RNAB081J1JBRG

Har du brug for hjælp?

Hvis du har brug for hjælp til Frigidaire RNAB081J1JBRG stil et spørgsmål nedenfor, og andre brugere vil svare dig