EDGE® EXTERNAL BATTERY PACK
Installation Instructions
Important Safety Information
WARNING
See the Important Safety and Product Information guide in the
GPS device product box for product warnings and other
important information.
A lithium-ion battery is used in this device.
If these guidelines are not followed, the battery may experience
a shortened life span or may present a risk of damage to the
device, fire, chemical burn, electrolyte leak, and/or injury.
• Do not disassemble, modify, remanufacture, puncture or
damage the battery pack.
• Do not expose the battery pack to fire, explosion, or other
hazard.
NOTICE
• Do not immerse the battery pack in water or other liquids.
• Do not leave the battery pack exposed to a heat source or in
a high-temperature location, such as in the sun in an
unattended vehicle. To prevent the possibility of damage,
remove the battery pack from the vehicle or store it out of
direct sunlight, such as in the glove box.
• Do not operate the battery pack outside of the temperature
ranges specified in the printed manual in the product
packaging.
• When storing the battery pack for an extended time period,
store within the temperature ranges specified in the printed
manual in the product packaging.
• Do not use a power and/or data cable that is not approved or
supplied by Garmin®.
• Contact your local waste disposal department to dispose of
the battery pack in accordance with applicable local laws and
regulations.
Device Overview
ÀStatus LEDs
ÁDevice key
ÂInput power Micro-USB port (under weather cap)
ÃOutput power USB-A port (under weather cap)
Charging the Battery Pack
NOTICE
To prevent corrosion, thoroughly dry the USB port, the weather
cap, and the surrounding area before charging or connecting to
a computer.
NOTE: The device will not charge when outside the charging
temperature range (Specifications, page 3).
1Pull up the weather cap from the Micro-USB port.
2Plug the small end of the USB cable into the Micro-USB port
on the device.
3Plug the large end of the USB cable into the USB wall
charger.
4Charge the battery pack completely.
The status LEDs flash blue while charging. The status LEDs
are solid blue when charging is complete. Charging a fully
depleted battery pack takes approximately four hours using
the USB cable and wall charger included with the battery
pack. The battery pack may charge slowly when using a
third-party USB cable or power source.
Tips for Using the Battery Pack
• Select the device key to check the battery charge level.
Each solid LED represents up to a 25% battery charge level.
When one LED is flashing, the battery pack has less than a
5% charge remaining.
• Connect your Edge® device to the battery pack.
Edge devices with electrical contacts start charging when
connected to the charging pins on the battery pack. For Edge
devices without electrical contacts, you must connect a USB
cable to the USB-A port on the battery pack. Go to
buy.garmin.com to purchase an accessory cable.
• Hold the device key for five seconds to stop charging a
connected Edge device.
You can select the device key to continue charging.
Installing the Lever Adapter
1Use the 2 mm hex key to remove the two screws À on the
bottom of the mount.
2Remove the quarter-turn adapter Á.
3Insert the lever adapter Â.
4Replace the screws, and use the 2 mm hex key to tighten the
screws.
Installing the Out-Front Mount
You can use the out-front mount to install the battery pack and
your Edge device.
1Select a secure location to mount the Edge device and
battery pack where they do not interfere with the safe
operation of your bike.
2 Installation Instructions
