Garmin Spectra LC302 Manual

Garmin Ikke kategoriseret Spectra LC302

Læs gratis den danske manual til Garmin Spectra LC302 (13 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 52 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 26.5 anmeldelser. Har du et spørgsmål om Garmin Spectra LC302, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/13
GARMIN SPECTRA ™ LED MODULE CONTROL
INSTALLATION INSTRUCTIONS
Important Safety Information
Important Safety Information
Important Safety Information
Important Safety InformationImportant Safety Information
WARNING
See the guide in the product box for product warnings and other Important Safety and Product Information
important information.
Failure to install this device according to these instructions could result in personal injury, damage to the vessel
or device, or poor product performance.
CAUTION
To avoid possible personal injury or damage to the device and vessel, disconnect the vessel's power supply
before beginning to install the device.
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
You must read all installation instructions before beginning the installation. If you experience difficulty during
the installation, go to .
support.garmin.com
Tools and Supplies Needed
Tools and Supplies Needed
Tools and Supplies Needed
Tools and Supplies NeededTools and Supplies Needed
• 16AWG (1.3mm2) wire to connect the wiring harness to power
• Inline fuse apporpriately-rated for the power source and connected LEDs ( ).
Connecting to Power, page4
• 20AWG (0.5mm2) wire to connect the wiring harness to lighting
You can purchase marine LED cable from your Fusion® or Garmin® dealer in 100m (328ft.) lengths
(010-13386-00).
• #2 Phillips screwdriver
• Appropriately sized marine-grade connectors for connecting the wiring harnesses to the speaker wire
• Wire cutters
• Drill and 2 mm (3/32in.) drill bit for mounting the LED control module
Getting Started
Getting Started
Getting Started
Getting StartedGetting Started
The Garmin Spectra LED control module allows you to control connected LED lights using compatible Garmin
chartplotters and compatible Fusion stereos connected to the same NMEA 2000® network. You can also control
connected LED lights using the ActiveCaptain® app.
The Garmin Spectra LED control module is designed for controlling only LED lighting. You must not use this
device to control navigation lights, non-LED lighting, or other devices.
This manual contains instructions for installing and performing the initial configuration for the Garmin Spectra
LED control module using a Garmin chartplotter or ActiveCaptain app. For complete instructions on using the
Garmin Spectra LED control module with a connected chartplotter or Fusion stereo, see the latest chartplotter or
stereo owner's manual.
GUID-6A3E1D9B-1E17-4069-BF5C-3C82F2202A9B v2September 2024
Downloading the Latest Chartplotter or Stereo Owner's Manual
Downloading the Latest Chartplotter or Stereo Owner's Manual
Downloading the Latest Chartplotter or Stereo Owner's Manual
Downloading the Latest Chartplotter or Stereo Owner's ManualDownloading the Latest Chartplotter or Stereo Owner's Manual
For complete operating and customization instructions for the LED lighting features, download the latest
version of the owner's manual for your chartplotter or stereo from the Garmin website.
1 Go to or scan this QR code.
garmin.com/manuals/
2 Enter the name of your chartplotter or stereo and select the appropriate model
from the results.
3 Owner's ManualSelect on the manuals page.
Mounting Considerations
Mounting Considerations
Mounting Considerations
Mounting ConsiderationsMounting Considerations
Selecting the correct mounting location is critical to optimize the performance of the Garmin Spectra LED
control module. When selecting a mounting location, observe these considerations.
• You should mount the device in an accessible location.
• You should not mount the device near fuel tanks or bilge areas where combustible fumes may accumulate.
• You should mount the device in a location with access to a common ground for other electronics.
• When controlling LED speakers, the controller should be mounted within 5M (16ft. 4in.) of the speakers.
• You must mount the device in a location where it is not submerged.
• You should mount the device on a flat, vertical mounting surface, with the wire harness connectors pointing
down.
• You should clear the mounting surface of dirt, debris, wax, or coatings.
• You should select a location away from sources that can interfere with the device's operation. Sources of
interference may include strong electromagnetic fields, such as power cables and electric motors.
Mounting the Device
Mounting the Device
Mounting the Device
Mounting the DeviceMounting the Device
Before you can mount the device, you must select a location in accordance with the mounting considerations.
You must use the included mounting screws or acquire pan-head screws of the appropriate length for the
mounting surface.
NOTICE
Do not use the Garmin Spectra LED control module as a template when drilling the mounting holes. Drilling
through the mounting holes may damage the device and void the warranty.
Do not apply grease or lubricant to the screws when fastening the device to the mounting surface. Grease or
other lubricants can cause damage to the device housing.
You must use pan-head screws to secure the device. Using countersunk screws can damage the device
housing.
1 With the wiring-harness connectors pointing down, hold the device on a flat, vertical mounting surface and
mark the locations for the pilot holes.
2 Remove the device from the mounting surface.
3 Using a 2mm (3/32 in.) drill bit, drill the pilot holes.
4 Fasten the included pan-head screws into the pilot holes.
5 Secure the device to the mounting surface by tightening the screws until they are snug.
NOTICE
Do not overtighten the screws because it may damage the device housing.
2

Produkt Specifikationer

Mærke: Garmin
Kategori: Ikke kategoriseret
Model: Spectra LC302

Har du brug for hjælp?

Hvis du har brug for hjælp til Garmin Spectra LC302 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Garmin Manualer

Garmin

Garmin Approach CT1 Manual

26 Februar 2025
Garmin

Garmin Spectra LC302 Manual

9 Januar 2025
Garmin

Garmin Spectra LC102 Manual

9 Januar 2025
Garmin

Garmin dēzl Headset 210 Manual

14 November 2024
Garmin

Garmin Inreach Messenger Plus Manual

11 November 2024
Garmin

Garmin GMM 170 Manual

4 Oktober 2024
Garmin

Garmin GMR 18 xHD Manual

4 Oktober 2024
Garmin

Garmin Edge Power Mount Manual

3 Oktober 2024
Garmin

Garmin GT30-TH Manual

3 Oktober 2024
Garmin

Garmin GMR 18 HD+ Manual

30 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Navman

Navman MiVue 540 Manual

2 August 2025
Pro User

Pro User PSI2000TX Manual

2 August 2025
Guede

Guede 5T Manual

2 August 2025
Navman

Navman EZY40 Manual

2 August 2025
Thule

Thule Chariot Ski kit Manual

2 August 2025
Hozelock

Hozelock 5102 Manual

2 August 2025
ART

ART 310 Manual

2 August 2025
Gorenje

Gorenje KAS53ZDCINVFT Manual

2 August 2025
Gorenje

Gorenje KAS35ZDCINVFT Manual

2 August 2025
Navman

Navman MY450LMT Manual

2 August 2025