GE GXSM01HWW Manual


Læs gratis den danske manual til GE GXSM01HWW (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om GE GXSM01HWW, eller vil du spørge andre brugere om produktet?

Side 1/12
1
GE Shower Filter
USE AND CARE/INSTALLATION INSTRUCTIONS
Shower Filter—GXSM01HWW
SAFETY PRECAUTIONS
Check with your local public works department for plumbing
codes. You must follow these guidelines as you install the Water
Filtration System. The Commonwealth of Massachusetts
plumbing code 248 shall be adhered to. Consult with your
licensed plumber for installation of system.
Install or store where it will not be exposed to temperatures
below freezing or exposed to any type of weather. Water
freezing in the system will damage it.
SPECIFICATION GUIDELINES
Your Water Filtration System will withstand up to 125 pounds
per square inch (psi) water pressure. If your house water supply
pressure is higher than 125 psi, install a pressure reducing valve
before installing the Water Filtration System.
WARNING: Do not use with water that is
microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
Discard all unused and packaging material after installation.
Small parts remaining after installation could be a choke
hazard.
Your new GE shower filter comes complete with all the necessary hardware for most installations. Each filter gives you up to
6 months of filtered water. The filter should be changed after 6 months of use or 10,000 gallons, whichever comes first.
215C1180P001 49-50164-1 (06--06 JR) 147095 Rev. A
GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
For service in the U.S., contact us at: or call 800.GE.CARES.ge.com
In Canada, call toll free, 866.777.7627.
This system is Tested and Certified by NSF International against
NSF/ANSI Standard 177 for the reduction of the claims specified on
the Performance Data Sheet.
Service Service Temperature
Model Flow Rate Life Pressure Range
GXSM01HWW 2.5 gpm 10,000 gallons 20–125 psi 40°–160°F
(9.5 lpm) (37,900 liters) (1.4–8.6 bar) (4.4°–71.1°C)
or 6 months*
*Filter life varies with local water conditions.
INCLUDED COMPONENTS
Shower Unit
Filter
Use and Care/Installation Instructions
TOOLS NEEDED
None
Ref. No. Part No. Part Description
001 GXSM01HWW Shower Filter System (includes filter)
002 FXSCH Replacement Filter
0999 49-50164 Use and Care/Installation Instructions
For replacement parts and pricing in the U.S.: 800.626.2002.
In Canada: 866.777.7627.
PARTS LIST
Swivel collar
Shower pipe
Shower head*
INSTALLATION INSTRUCTIONS
Remove shower filter from shrink wrap packaging.
Remove label off the bottom of the filter base.
Remove the existing shower head from the shower pipe.
Hold the unit in the final mounting position and connect the
shower filtration system to the shower pipe by turning the swivel
collar to tighten onto the threads of the shower pipe.
Connect the shower head (removed in step 3) on the shower
filtration system.
Slowly turn on the cold water and check for leaks. Tighten
if necessary.
6
5
4
3
2
1
Remove the label
*Shower head not included.
2
OPERATION
To receive filtered water, open the water supply.
CLEANING THE SYSTEM
Use a damp cloth and mild soap for cleaning. Do not use
harsh chemicals, detergents, abrasives, solvents or cleaning
fluids, since they will damage the system.
FILTER CARTRIDGE REPLACEMENT
Turn off the water to the filtration system.
Remove the filter housing by turning counterclockwise.
Be sure to support the shower pipe and the filter housing and base
during the filter removal to avoid damage to the system.
NOTE: Some water may drip from the system during filter cartridge
removal.
Pull the filter cartridge straight out of the housing and dispose.
Remove the label at the bottom of the new filter; insert new filter
cartridge into the filter base.
Put the housing back on the base by turning the housing clockwise
until it locks into place.
Slowly turn on the water and check for leaks.
6
5
4
3
2
1
O-ring
Filter base
Filter cartridge
Filter housing
O-ring
TROUBLESHOOTING TIPS
Problem Possible Causes What To Do
Shower filter unit won’t Swivel collar not tight enough. Tighten the swivel collar.
stay in position
Leaking around the Missing gasket in tightening nut. Use Teflon Tape on shower pipe threads.
shower pipe area Swivel collar not tight enough. Tighten the swivel collar.
Gasket not seated in the swivel Make sure gasket is seated in the swivel collar, then tighten
collar. the swivel collar.
Housing leaking Filter housing not secured to Make sure housing is securely attached to the base.
the base.
Missing O-ring on filter housing. Return to the store.
Filter cartridge housing fits Missing O-ring on replacement Return to the store.
loosely to the base filter.
Leaking around shower head Missing gasket in shower. Use Teflon Tape on shower filter threads.
Troubleshooting Tips
Save time and money! Review the chart below
first and you may not need to call for service.
Remove the label


Produkt Specifikationer

Mærke: GE
Kategori: Ikke kategoriseret
Model: GXSM01HWW

Har du brug for hjælp?

Hvis du har brug for hjælp til GE GXSM01HWW stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret GE Manualer

GE

GE GFC325N Manual

9 December 2024
GE

GE ZXR7510C Manual

6 Oktober 2024
GE

GE GXITD Manual

16 September 2024
GE

GE ZWSP42D Manual

19 August 2024
GE

GE ZGW124ENSS Manual

13 August 2024
GE

GE GNULQ Manual

9 August 2024
GE

GE ZX27CTYSS Manual

6 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer