Gemini 7590T2-1 Manual

Gemini Bilalarm 7590T2-1

Læs gratis den danske manual til Gemini 7590T2-1 (6 sider) i kategorien Bilalarm. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Gemini 7590T2-1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

Signature

..........................................................................................

By:

Sold on:

Car:

INSTALLATION CERTIFICATE

The undersigned, qualified installer, attests to have personally fitted the

here described vehicle security sistem following the manufacturer

instructions.

GEMINI Technologies S.p.A.

Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia

Tel. +39 0332 943211 - Fax +39 0332 948080

Web site: www.gemini-alarm.com AC 2666 rev. 00-03/06

END USER MANUAL

For all EU Countries

7590T2-1

TOTAL ALARM ARMING

The alarm can be activated by pressing key 1 on the remote or by inserting the

electronic key into the appropriate socket.

The operation is confirmed by an acoustic signal and a visual signal consisting

of one flash of the turn indicators lasting approximately one second.

During the flash, the following functions are enabled:

- Module output (PINK wire, +A).

- Led output.

- Activation of door-locking control (with the timing selected in programming

phase).

Neutral activation time lasts approx. 35” and it is indicated by the continuous

light of the LED. This time interval allows the user to get out of the vehicle

without causing false alarm conditions. During the first 25” of the neutral time, it

is possible to cut out the external sensors and stop the windows' upward travel

by pressing key no. 2 on the remote (Note: the stop window function requires

the installation of a special module see art. 2344 or the existence of the

COMFORT function in the car).

The activation of said functions (Cutting out the external sensors / stopping

window upward travel / comfort) is indicated by a brief flash of the turn

indicators.

sensor cutout is limited to a single alarm activation cycle.

Turn the ignition “ON”.

The status will stay on for 0,5 seconds. During this time, push the button

N°2 of the transmitter.

Leave the vehicle and push the button N°1 of the transmitter.

NEUTRAL TIME, SENSOR EXCLUSION , STOPPING WINDOW

UPWARD TRAVEL AND COMFORT FUNCTION

NOTE:

If the electronic key is used, all the functions described under points a) and b)

will be activated, whereas d) ACTIVATION OF DOOR-LOCKING CONTROL

will not occur (enabling the user to get out of the vehicle).

Moreover, by using the electronic key, a car entry time of approximately 10

seconds will be generated to allow the user to get into the car and deactivate

the alarm system with the electronic key without creating a false alarm.

While the user gets into the car, entry time is indicated by the continuous light of

the LED.

This function allows the user to arm the alarm system, excluding the siren

sound in case of a theft attempt.

To exclude the siren, proceed as follows:

The alarm will be armed with the optical and acoustic signals, which, as

previously described, will be not activated in case of a theft attempt.

the siren sound exclusion is bound to the single arming cycle.

ARMING WITH SIREN SOUND EXCLUSION

NOTE:

PAGE 2 PAGE 3

INTRODUCTION

FUNCTIONS

The 7590 system is a alarm control unit with built-in sensors and can be

installed on cars having a 12-volt battery with the negative pole earthed.

Arming and disarming of the alarm system with transmitters having

random rolling code.

Blinker.

Sirene sound intermittent or continuous (programmable).

Perimetric protection.

Volumetric protection (combined with an ultrasonic or hyperfrequency

module, excludable from arming).

Control for CDL, electrical windows and sun roof (vehicles equipped with

the system “Pack-comfort”).

Alarm memory indicated by optic/acoustic signals.

“PANIC” or “BOOT OPENING” function (programmable).

Anti distraction function (programmable).

Control for self-powered siren or supplementary siren.

Produkt Specifikationer

Mærke:	Gemini
Kategori:	Bilalarm
Model:	7590T2-1

Har du brug for hjælp?

Hvis du har brug for hjælp til Gemini 7590T2-1 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Bilalarm Gemini Manualer

23 September 2024

20 September 2024

15 September 2024

22 August 2024

14 August 2024

13 August 2024

13 August 2024

12 August 2024

12 August 2024

12 August 2024

Bilalarm Manualer

Nyeste Bilalarm Manualer

17 Juli 2025

10 Juli 2025

6 Juli 2025

9 April 2025

Audiovox Code Alarm CA 1055 Manual

29 August 2024

Audiovox CA1155E Manual

29 August 2024

Audiovox Code Alarm CA 1155 Manual

29 August 2024

HP Rotary Lock Manual

26 August 2024

Spy FM5000 Manual

23 August 2024

Jablotron CA-321 Accent Manual

22 August 2024