Hikvision DS-K7R01-433 Manual

Hikvision Sikkerhed adgangskontrolsystem DS-K7R01-433

Læs gratis den danske manual til Hikvision DS-K7R01-433 (2 sider) i kategorien Sikkerhed adgangskontrolsystem. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Hikvision DS-K7R01-433, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Wireless Keyfob

User Manual

UD20280B

Indicator

Open (Entrance)

Close/Pair

Press: Close Door

Hold for 10 s: Pair Keyfob

Open (Exit)

Remain Open

( )Hold for 1.5 s

Metal Hook

Disassembling Groove

Indicator Red Instruction:( )

F lash Once Press the Key:

F lash Twice Keyfob Paired:

Flash 2s: Low Battery

1 Disassemble the groove .

according to the arrow. 2 Remove the rear panel and .

you can see the battery slot.

Battery Slot

3 Place a supplied battery .

(Model: 12V23A) into the slot.

Pay attention to the polarity

on the device. Do not install the

battery in the wrong direction.

Battery

4 Assemble the rear panel.

back to the front panel .

Power On1Pair Keyfob2

One to One Mode- - :

By default, the keyfob is in one-to one mode. The keyfob s- '

DIP switch is towards 1 (OFF) In this mode the keyfob can . ,

only control one turnstile .

Power on the turnstile and make sure the turnstile is in the

normal mode. Set the DIP switch according to the turnstile's

user manual and make sure the turnstile has entered the

one-to one pairing mode.

Reboot the turnstile and make sure no other turnstiles have

paired with the keyfob within the available pairing distance .

Hold Close for more than 10 s and the keyfob starts " " ,

pairing.

After pairing completed the keyfob s indicator will flash , '

twice If pairing failed the indicator is off. , .

You can also . pair the keyfob via the client software For

details see the turnstile s user manual, ' .

One-to-Many Mode:

The keyfob s DIP switch is ON In this mode the keyfob can' . ,

control multiple turnstiles .

Power on the turnstile and make sure the turnstile is in the

normal mode. Set the DIP switch according to the turnstile's

user manual and make sure the turnstile has entered the

one-to-many pairing mode.

Reboot the turnstile. Hold "Close" for more than 10 s, and

the keyfob starts pairing .

After pairing, the keyfob's indicator will flash twice.

You can also pair the keyfob via the client software. For

details see the turnstile s user manual, ' .

1 Default ( ):

One-to One Pairing Mode-

ON:

One-to-Many Pairing Mode

DIP

1 Appearance

The pictures here are for reference only.

2 Quick Operation

About this Manual

The Manual includes instructions for using and managing the Product. Pictures, charts, images

and all other information hereinafter are for description and explanation only. The information

contained in the Manual is subject to change, without notice, due to firmware updates or other

reasons. Please find the latest version of this Manual at the Hikvision website

(https://www.hikvision.com/).

Please use this Manual with the guidance and assistance of professionals trained in supporting

the Product.

Trademarks

and other Hikvision's trademarks and logos are the proper ties of Hikvision in various

jurisdictions.

Other trademarks and logos mentioned are the proper ties of their respective owners.

Disclaimer

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS MANUAL AND THE PRODUCT

DESCRIBED, WITH ITS HARDWARE, SOFTWARE AND FIRMWARE, ARE PROVIDED “AS IS” AND

“WITH ALL FAULTS AND ERRORS”. HIKVISION MAKES NO WARRANTIES, EXPRESS OR IMPLIED,

INCLUDING WITHOUT LIMITATION, MERCHANTABILITY, SATISFACTORY QUALITY, OR FITNESS

FOR A PARTICULAR PURPOSE. THE USE OF THE PRODUCT BY YOU IS AT YOUR OWN RISK. IN NO

EVENT WILL HIKVISION BE LIABLE TO YOU FOR ANY SPECIAL, CONSEQUENTIAL, INCIDENTAL,

OR INDIRECT DAMAGES, INCLUDING, AMONG OTHERS, DAMAGES FOR LOSS OF BUSINESS

PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA, CORRUPTION OF SYSTEMS, OR LOSS OF

DOCUMENTATION, WHETHER BASED ON BREACH OF CONTRACT, TORT (INCLUDING

NEGLIGENCE), PRODUCT LIABILITY, OR OTHERWISE, IN CONNECTION WITH THE USE OF THE

PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR

LOSS.

YOU ACKNOWLEDGE THAT THE NATURE OF INTERNET PROVIDES FOR INHERENT SECURITY

RISKS, AND HIKVISION SHALL NOT TAKE ANY RESPONSIBILITIES FOR ABNORMAL OPERATION,

PRIVACY LEAKAGE OR OTHER DAMAGES RESULTING FROM CYBER-ATTACK, HACKER ATTACK,

VIRUS INSPECTION, OR OTHER INTERNET SECURITY RISKS; HOWEVER, HIKVISION WILL

PROVIDE TIMELY TECHNICAL SUPPORT IF REQUIRED.

YOU AGREE TO USE THIS PRODUCT IN COMPLIANCE WITH ALL APPLICABLE LAWS, AND YOU

ARE SOLELY RESPONSIBLE FOR ENSURING THAT YOUR USE CONFORMS TO THE APPLICABLE

LAW. ESPECIALLY, YOU ARE RESPONSIBLE, FOR USING THIS PRODUCT IN A MANNER THAT DOES

NOT INFRINGE ON THE RIGHTS OF THIRD PARTIES, INCLUDING WITHOUT LIMITATION, RIGHTS

OF PUBLICITY, INTELLECTUAL PROPERTY RIGHTS, OR DATA PROTECTION AND OTHER PRIVACY

RIGHTS. YOU SHALL NOT USE THIS PRODUCT FOR ANY PROHIBITED END-USES, INCLUDING THE

DEVELOPMENT OR PRODUCTION OF WEAPONS OF MASS DESTRUCTION, THE DEVELOPMENT

OR PRODUCTION OF CHEMICAL OR BIOLOGICAL WEAPONS, ANY ACTIVITIES IN THE CONTEXT

REL ATED TO ANY NUCLEAR EXPLOSIVE OR UNSAFE NUCLEAR FUEL-CYCLE, OR IN SUPPORT OF

HUMAN RIGHTS ABUSES.

IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE

LATER PREVAILS.

Data Protection

During the use of device, personal data will be collected, stored and processed. To protect data,

the development of Hikvision devices incorporates privacy by design principles. For example,

for device with facial recognition features, biometrics data is stored in your device with

encr yption method; for fingerprint device, only fingerprint template will be saved, which is

impossible to reconstruct a fingerprint image.

As data controller, you are advised to collect, store, process and transfer data in accordance

with the applicable data protection laws and regulations, including without limitation,

conducting security controls to safeguard personal data, such as, implementing reasonable

administrative and physical security controls, conduct periodic reviews and assessments of the

effectiveness of your security controls.

Factors may affect the usage:

1. (Obstacles Wall etc, .);

2. People are walking near the turnstile

or the keyfob;

3. .There are metals near the turnstile

首次使用，请先激活设备

3 Specification Regulatory Information

FCC Information

Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

FCC compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body.

FCC Conditions

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may

cause undesired operation.

This product and - if applicable - the supplied accessories too are marked with "CE" and comply therefore with the

applicable harmonized European standards listed under the RE Directive 2014/53/EU, the EMC Directive

2014/30/EU, the RoHS Directive 2011/65/EU.

2006/66/EC (battery directive): This product contains a battery that cannot be disposed of as unsorted municipal

waste in the European Union. See the product documentation for specific battery information. The battery is

marked with this symbol, which may include lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg). For

proper recycling, return the battery to your supplier or to a designated collection point. For more information see:

www.recyclethis.info

2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal

waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of

equivalent new equipment, or dispose of it at designated collection points. For more information see:

www.recyclethis.info

Safety Instruction

These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss.

The precaution measure is divided into Warnings and Cautions:

Warnings: Neglecting any of the warnings may cause serious injury or death.

Cautions: Neglecting any of the cautions may cause injury or equipment damage.

Warning

All the electronic operation should be strictly compliance with the electrical safety regulations, fire prevention regulations and other

related regulations in your local region.

Please use the power adapter, which is provided by normal company. The power consumption cannot be less than the required

value.

Do not connect several devices to one power adapter as adapter overload may cause over-heat or fire hazard.

Please make sure that the power has been disconnected before you wire, install or dismantle the device.

When the product is installed on wall or ceiling, the device shall be firmly fixed.

If smoke, odors or noise rise from the device, turn off the power at once and unplug the power cable, and then please contact the

service center.

If the product does not work properly, please contact your dealer or the nearest service center. Never attempt to disassemble the

device yourself. (We shall not assume any responsibility for problems caused by unauthorized repair or maintenance.)

Caution

identifies the battery holder itself and identifies the positioning of the cell(s) inside the battery holder.

No naked flame sources, such as lighted candles, should be placed on the equipment.

Do not drop the device or subject it to physical shock, and do not expose it to high electromagnetism radiation. Avoid the equipment

installation on vibrations surface or places subject to shock (ignorance can cause equipment damage).

Do not place the device in extremely hot (refer to the specification of the device for the detailed operating temperature), cold, dusty

or damp locations, and do not expose it to high electromagnetic radiation.

The device cover for indoor use shall be kept from rain and moisture.

Exposing the equipment to direct sun light, low ventilation or heat source such as heater or radiator is forbidden (ignorance can cause

fire danger).

Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not a malfunction

however), and affecting the endurance of sensor at the same time.

Please use the provided glove when open up the device cover, avoid direct contact with the device cover, because the acidic sweat of

the fingers may erode the surface coating of the device cover.

Please use a soft and dry cloth when clean inside and outside surfaces of the device cover, do not use alkaline detergents.

Please keep all wrappers after unpack them for future use. In case of any failure occurred, you need to return the device to the factory

with the original wrapper.

Transportation without the original wrapper may result in damage on the device and lead to additional costs.

Working voltage 12 V

Working

temperature -10 ℃ to 55 ℃

Working humidity 10% to 90%

(No condensing)

Protective level IP40

Battery

Support

Life span: Above 4 month

(If use 100 times per day,

25 °C)

Key lifes pan ＞ 500,000 times

Transmission

distance 15 m

Indicator Red LED light

Frequency 433MHz

Dimension 80 mm × 36 mm × 20 mm

DS-K7R01-433 Wireless Keyfob

Working voltage 12 V

Working

temperature -10 ℃ to 55 ℃

Working humidity 10% to 90%

(No condensing)

Protective level IP40

Battery

Support

Life span: Above 4 month

(If use 100 times per day,

25 °C)

Key lifes pan ＞ 500,000 times

Transmission

distance 50 m (Open area)

Indicator Red LED light

Frequency 868MHz

Dimension 80 mm × 36 mm × 20 mm

DS-K7R01-868 Wireless Keyfob

Produkt Specifikationer

Mærke:	Hikvision
Kategori:	Sikkerhed adgangskontrolsystem
Model:	DS-K7R01-433

Har du brug for hjælp?

Hvis du har brug for hjælp til Hikvision DS-K7R01-433 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Sikkerhed adgangskontrolsystem Hikvision Manualer

Hikvision DS-K3B211LX Manual

4 August 2025

Hikvision DS-K6B630TDLX Manual

4 August 2025

Hikvision DS-K1A8503 Manual

27 Juli 2025

Hikvision DS-K3BC430LX Manual

27 Juli 2025

Hikvision DS-K1T673TDX-T Manual

27 Juli 2025

Hikvision DS-K5671-ZV Manual

27 Juli 2025

Hikvision DS-K3B411BLX Manual

8 Juli 2025

Hikvision DS-K3B501SX Manual

8 Juli 2025

Hikvision DS-K2702WX Manual

8 Juli 2025

Hikvision DS-K1T690MF Manual

8 Juli 2025

Sikkerhed adgangskontrolsystem Manualer

Nyeste Sikkerhed adgangskontrolsystem Manualer

Geovision GV-AS2120 Manual

11 September 2025

Geovision GV-SR1352 Manual

10 September 2025

Geovision GV-AS110 Manual

10 September 2025

Geovision GV-AS1010 Manual

10 September 2025

Geovision GV-AS210 Manual

10 September 2025

Viking K-1270 Manual

29 August 2025

Viking K-1205-IP Manual

29 August 2025

Viking K-1205-EWP Manual

29 August 2025

Dnt BioAccess PRO Manual

23 August 2025

Eminent EM8622 Manual

16 August 2025