PARAMETER
Washing Capacity
Max.spin speed
Net Weight
Dimension(WXDXH)
Rated Voltage
Heating Power
Washing Power
Model
10.0kg
1400rpm
7 kg4
595X6 0X845mm6
220 -240V
1 00W6
1 0W5
HWFE1014VA HWFE1014VA HWFE1014VA/ S/ T
Load the clothes to be washed in the drum and close the door.
Add the detergent into the relevant compartments for the type
of program you are going to select, Add detergent as described
in . Auto Dosing operation guide
1.Press the button“On/Off” .
Add Detergent, Close the Door and Set the Program
3.Select washing temperature and spin speed by pressing
“Temp.”and “Spin” buttons.
2.Press program selection button to required program, start up and
default the program as “Cotton”.
4.Press “Prewash” ,“Extra Rinse”,“Quicker”,“Eco”button
to select additional functions.
5.After starting the program, display window displays program
length (hours: minutes), washing temperature and additional
function options in sequence.
·
At standby state, press “Prewash” ,“Extra Rinse”,“Quicker”,
“Eco” button to select additional function for current program.
Select the function , and then corresponding icon .lights up
After starting up, program cannot be changed.
If tap is not opened, or water pressure is over low, inlet water
fault icon will display, and display screen will prompt “F01” to
give alarm.
Inlet water warning
If the pipe is squeezed, drainage will not be smooth. In case of
failing to completely drain for long time, drainage fault icon will
display, and display screen will prompt “F03” to give alarm.
Drainage warning
·After completing program, door lock unlocks automatically.
During pause, if door opening condition can be met halfway,
the door lock will unlock and its indicator light will go out.
·When door lock indicator light flashes, door shall not be opened
forcibly so as to avoid personal injury.
After the program starts the Door Lock icon will light up and
the door will be locked.
Door Lock Icon
Addition function selection
Pre-wash
Delay End function allows to run the machine at the consumers’
convenience, for example, at night when electricity is cheaper.
Delay Function End
•The delay time must be longer than the wash program length
as the delay time is the time program will finish. For example:
if the selected program time is 02:28, the delay time selected
must be between 03:00 and 24:00.
Washing machine displays “---” after startup, indicating that it
is weighing automatically. It will adjust program length (hours:
minutes) automatically according to weight of clothes.
When the machine is in the state of holding, pause or operation,
press buttons for seconds, the Mute icon “Spin ”+Favourite 3
will light up. All the buzzing will be turned off except the alarms.
When the machine is in the mute state, press “ ” Spin+Favourite
buttons for seconds, the Mute icon will turn off. All the buzzing 3
will be activated.
Mute Function
Automatic weighting
To strengthen the safety of children, this machine is equipped
with Child Lock function.
When the programme starts, press button for “Temp. ”+Spin
3 seconds. Child Lock icon will light up, and then Child
Lock is set up. Repeat the same operation, the Child Lock
will be released.
•When the Child Lock is set, all function buttons will be
shielded.
•When you turn the machine off by pressing the “On/Off”
button, child lock is released.
•
After completing program, child lock will automatically
unlock.
Child Lock
After you have selected your options and placed detergent
withinthe detergent dispenser, turn on the water tap and press
the button. The screen will display the current “Start / Pause”
program progression with icons from left to right. It also
displays the remaining program time.
To Start the Program
1.Press the “On/Off ”
button for 2 seconds to
turn off the
machine.
2.Press the “ ” button to turn on the machine. On/Off
Select the new program and options.
3.Press “Start / Pause”
to start the new program without adding
any extra detergent.
To Cancel the Program or Reselect the Options
When programme finished its running, it will display . “End”
If no operation is taken in 2 minutes, the machine will turn
off automatically.
1.Press button for 2 seconds to turn off the machine;“On/Off”
2.Close the tap;
3.Open the door and take the washed clothes out;
4.Slightly open the door to remove moisture in the drum.
End of the Program
Reload in Process
1.Select to turn on or off softener/detergent release and set
the release volume;
2.It is active in the standby mode. After this key being
pressed, the softener/detergent volume will be selected
in a cycle mode in accordance with Automatic Large-
- - -Medium Little off;
3.The softener/detergent release selection will be memorized,
that is, after selection and operation by the user, the release
volume for the next time will be that of selected in the last
time;
4.When the user uses the machine for the first time, it is
defaulted that the softener/detergent release is turned on
and the release volume is automatic;
5.When the softener/detergent release is turned on, if it is
detected that the amount of softener/detergent in the release
box is too small, the softener adding indicator on the
display will be turned on, and the selected volume indicator
will flash in a frequency of 2 Hz.
S oftener /detergent release
If you want to reload clothes in the process of washing, please
press button.“Start/Pause”
•If reload icon light up, the door can be opened in the
process, remaining time and the Door Lock icon in display
will flash. Then the Door Lock icon will go out, and the door
can be opened.
•If reload icon doesn’t light up, the Door Lock icon
doesn’t flash, it indicates that current temperature is over 50 ℃
or you have passed the time for reloading in the process, namely
no clothes allowed to load into the machine.
T reduced by 5 and the main wash timehe temperature be actual ℃
be reduced after the function is selected.
Extra Rinse
After set the function of , the program runs the Extra Rinse
rinsing process once again before running the softening, and
the total running time of the program increases accordingly.
•
Only under the standby mode, this button is valid for
selecting the reservation time.
•
After the reservation function is selected, the time will
increase 1h when each time the reservation button is pressed.
Before reservation, if the program time does not satisfy the
integral multiple of 1h, it shall be completed by pressing the
reservation key for the first time, and then the time increases
1h when each time the reservation button is pressed. If the
reservation is selected, before the program runs, the current
reservation can be canceled by turning the button to select
other programs.
•
When the reservation process is operated, the icon of
‘reservation time’ will be on. When the reservation process
startup flash, the icon of ‘reservation time’ will .
2033652-X08080789A
Select the function to conduct pre-wash so as to enhance washing
effects and better remove stains. This function is suitable for
heavy dirt clothes.
ECO
· The ECO indication lamp is on after the function is selected, and
the indication lamp will be off after the program ends.
·The ECO function is only added under the standby state of its
applicable program, that is, before the program is started. After the
program is started, the function cannot be selected.
·
Favourite
1.Press the “On/Off ” button to turn on the machine;
2.Select the washing program;
3.Select parameters(washing temperature ,spin speed,etc);
4.Press Favourite button for 3 seconds;
5.Favourite is stored(only one program can be stored),select
Favourite when using this program,press “Start / Pause”to start;
6.When the user uses it for the first time, if he/she has never long
pressed the Favorite to collect programs, he/she can short button
press the Favorite and then the cotton linen program and its button
default settings will be collected by default;
7.Short press Favourite button,then the symbol is on.Repeat the
same operation or press other s to exit this program, the button
symbol is off;
8.After selecting other functions,long press 3 seconds t override o
the original program.
Quicker
After pressing this function button,the program time will be
shortened according to the setting,and the program time will be
increased back to the original setting by pressing the Quicker button
again.After the program starts,the indicator light is always on.
Th function is only added under the standby state of its applicable is
program, that is, before the program is started. After the program is
started, the function cannot be selected.
After this is selected determined main washing time function , the
will be reduced by 15 mins.
Long press the Delay End button,the reservation time jumps
fast.
•