Honeywell HBD1PR1 Manual

Honeywell Overvågningskamera HBD1PR1

Læs gratis den danske manual til Honeywell HBD1PR1 (2 sider) i kategorien Overvågningskamera. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om Honeywell HBD1PR1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

HBD1PR1 HBD3PR1/ True Day/Night

Indoor/Outdoor IR Bullet IP Camera

Quick Installation Guide

Document - — A — 800 21232V1 Rev 10/2015

Thank you for a / purchasing HBD1PR1 HBD3PR1

camera. Follow the

instructions in this guide to

install and set up

your camera. For instructions

on configuring the

camera, refer to the

Performance Series IP

Cameras User Guide on

the andsoftware

documentation CD that came

with your camera. If

you require additional

assistance, please call the

number shown

below.

Cautions and Warnings

WARNING To ensure compliance with electrical safety standards this product is

intended for use with a Listed Power Adapter marked with “Limited Power Source”, “LPS”,

on the unit, output rated 12 V DC, minimum 0.33A, Tma=60Deg.C or from Power over

Ethernet (PoE) provided by Listed Information Technology Equipment meeting the IEEE

802.3af PoE standard.

The Ethernet connection is not intended to be connected to exposed (outside plant)

networks. Do not connect two power sources to the camera at the same time.

Invisible LED radiation (850 nm). Avoid exposure to beam.

Regulatory Statements

Information to the User: This has equipment been and tested found to comply with the limits afor

Class B digital device, pursuant to part 15 of the Rules. FCC These limits are designed to provide

reasonable against protection harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment is and off on, the user encouraged to try to correct the

interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the the separation between equipment and receiver.

•

Connect the equipment into an outlet a that on circuit different from to which the receiver is

connected.

•

Consult the dealer or an experienced radio/TV technician for help.

Note Changes or modifications not party expressly approved by the responsible for compliance

could void the user’s authority to operate the equipment.

This B Class digital apparatus complies Canadian with ICES- 003.

Cet appareil numérique de B la Classe est conforme à la - Canada. norme NMB 003 du

Important Safeguards

•

Read and keep these instructions.

•

Do not aim the camera toward a bright light source for extended periods to prevent damage to

the imager. Avoid operating the unit under or close to unstable light sources (may cause

flickering), or close to fluorescent lamps or objects reflecting light.

•

Do not touch the camera lens.

•

Do not drop the camera or subject it to physical shock.

•

Do not use a strong or abrasive detergent when cleaning the camera.

•

Avoid operating or storing the unit in extremely humid, dusty, hot/cold environments, where the

operating temperature is outside the recommended range of - 4°F to 140°F (– 20°C to 60°C).

Note Do not apply power to the completing installation. camera before

Note Confirm the installation surface can support at least three times the weight of the camera plus

the bracket.

Document - – A – 5 1 800 21232V1 Rev 10/201

Before You Begin

Before you begin, that check you have received all of the parts If any parts are listed below. missing

or your damaged, contact dealer immediately.

HBD1PR1/HBD3PR1 True Day/Night Indoor/Outdoor IR Bullet IP Camera

Mounting the Camera

Position the camera so that the screw holes on the base align with the screw holes on the

mounting template and the holes for the wall anchors.

Insert the three -self tapping screws through the holes in the bullet camera’s base, into the wall

anchors, and then tighten them to secure the camera in place.

•

Camera

•

Documentation CD

•

Quick install guide

Required tools:

•

A Phillips screwdriver

•

Self- tapping screws (×3)

•

Plastic 3) wall anchors (×

•

Mounting template

Connecting the Wires

1. Connect the Ethernet cable to the RJ- 45 port on the camera.

2. If the other end of the Ethernet cable is NOT connected to a PoE - - (Power over Ethernet) switch

or NVR, connect the power connector of the camera to a 12 VDC power source.

•

A drill with an appropriately sized drill bit for pre- drilling holes for the screw anchors.

Installation and servicing should be performed only by qualified

and experienced technicians to conform to all local codes and to maintain your

warranty.

Adjusting the Field of View

1. Using a Phillips screwdriver, loosen but do not remove the locking screw on the mounting

bracket arm.

2. Adjust the camera to the desired field- -of view angle, and then retighten the locking screw to

secure the camera in place.

Note When the camera body and mounting bracket are at a 90 degree angle, and the locking screw is

tight, do not rotate the camera body more than 360 degrees.

Logging On to the Camera

Camera connected to a PoE port of the Honeywell Embedded NVR can be configured with the NVR

directly.

To log on to the camera with a PC, install the Honeywell Config Tool from the software and documentation

CD, find the camera and open the web browser with the Honeywell Config Tool. The default user name is

admin (case- sensitive) and the default password is 1234.

Preparing the Mounting Surface

Place the mounting template on the mounting surface where you want to install the camera.

Drill a hole and pull the cables through the mounting surface.

Use the drill to pre drill holes for the wall anchors, then insert the wall anchors and - three

secure them in place.

Document - – A – 5 800 21232V1 Rev 10/201

© 5 this publication 201 Honeywell International Inc. All rights reserved. No part of may be reproduced by any means without written permission from Honeywell. The information in this publication is believed to be accurate in all respects. However,

Honeywell cannot assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to Revisions editions change without notice. or new to this publication may be issued such to incorporate changes.

www.honeywell.com/security

+1 800 323 4576

(North America only)

www.honeywell.com/security/uk

+1 44 (0) 1928 754 028

(Europe only)

www.asia.security.honeywell.com

+86 21 22196888

(Asia Pacific only)

RJ- 45

Produkt Specifikationer

Mærke:	Honeywell
Kategori:	Overvågningskamera
Model:	HBD1PR1
Kode for international beskyttelse (IP):	IP66
Type:	IP-sikkerhedskamera
Dybde:	165 mm
Højde:	70 mm
Vægt:	380 g
Produktfarve:	Hvid
Formfaktor:	Kugle
Understøttede videotilstande:	720p
Relativ luftfugtighed ved drift (H-H):	10 - 100 %
Ethernet LAN-porte (RJ-45):	1
Ethernet LAN:	Ja
Driftstemperatur (T-T):	-30 - 60 °C
Maksimal opløsning:	1280 x 960 pixel
Sikkerhedsalgoritmer:	802.1x RADIUS
Beskyttelsesfunktioner:	Vandtæt
Understøttede grafikopløsninger:	352 x 240,352 x 288,704 x 480,704 x 576,1280 x 720 (HD 720)
Forbindelsesteknologi:	Ledningsført
Strømforbrug (maks.):	4.8 W
Kabelteknologi:	10/100Base-T(X)
Netværksstandarder:	IEEE 802.3af
Servicekvalitet support (QoS):	Ja
Strømkilde type:	PoE
Monteringstype:	Væg
Understøttet placering:	Indendørs & udendørs
Antal brugere:	20 bruger(e)
Understøttede mobile operativsystemer:	Android, iOS
Hvidbalance:	Auto, Manual
Sensortype:	CMOS
Samlet antal megapixels:	1.3 MP
Plug and play:	Ja
Progressiv scanning:	Ja
Strøm over Ethernet (PoE):	Ja
Dag/nat funktion:	Ja
Minimumsbelysning:	0.8 Lux
Optisk sensorstørrelse:	1/3 "
Antal effektive pixels (HxV):	1280 x 960 pixel
Zoom kapacitet:	Ja
Maksimale blænderåbning tal:	2.1
Nattesyn:	Ja
LED type:	IR
Billedhastighed:	20 fps
Forstærkningskontroltype:	Auto/manuel
HTTPS -kryptering:	Ja
DC udgangsspænding:	12
Antal kameraer:	1
Brændviddeområde:	3.6 - 3.6 mm
Kameraets lukkerhastighed:	1/30000 s sek./side
Bevægelsessensor:	Ja
Nattesyn, afstand:	30 m
Fast fokus:	Ja
Kompensation for baggrundslys:	Ja
Objektivets synsvinkel, vandret:	71 °
Highlight Compensation (HLC):	Ja
Digital Wide Dynamic Range (DWDR):	Ja
3D NR (støjreduktion):	Ja
Smart IR:	Ja