Honeywell HZ-385BP Manual

Honeywell Varmeapparater HZ-385BP

Læs gratis den danske manual til Honeywell HZ-385BP (37 sider) i kategorien Varmeapparater. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Honeywell HZ-385BP, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/37

SIGNATURE SERIES DIGITAL

CERAMIC HEATERS

IMPORTANT SAFETY

INSTRUCTIONS

When using electrical appliances, basic

precautions should always be followed to

reduce the risk of fire, electric shock, and injury

to persons, including the following:

1. Read all instructions before using this heater.

2. This heater is hot when in use. To avoid burns, do not

continually let bare skin touch hot surfaces. If provided,

use handle when moving this heater. Keep combustible

materials, such as furniture, pillows, bedding, papers,

clothes, and curtains at least 3 feet (0.9 m) from the

front of the heater and keep them away from the sides

and rear.

3. Extreme caution is necessary when any heater is used

by or near children or invalids and whenever the heater

is left operating and unattended.

4. Always unplug heater when not in use.

5. Do not operate any heater with a damaged cord or plug

or after the heater malfunctions, has been dropped or

damaged in any manner. Return heater to authorized

service facility for examination, electrical or mechanical

adjustment, or repair.

6. Do not use outdoors.

7. This heater is rated at 1500W, 120 VAC. It is not to be

used in wet or moist locations, such as bathrooms and

laundry areas. Never locate heater where it may fall into

a bathtub or other water container. Avoid the use of

extension cord because the extension cord may

overheat and cause a risk of fire. However, If an

extension cord must be used, it must be 14 gauge or

larger and rated no less than 1875 watts.

8. Do not run cord under carpeting. Do not cover cord with

throw rugs, runners, or the like. Arrange cord away from

traffic area where it will not be tripped over.

9. This appliance has a polarized plug (one blade is wider

than the other). To reduce the risk of shock, this plug is

intended to fit only one way in a polarized outlet. If the

plug does not fit securely in the outlet, reverse the plug.

If it still does not fit, contact a qualified electrician.

DO NOT attempt to defeat this safety feature.

10. This heater draws 12.5 amps during operation when in

the high setting. To prevent overloading a circuit, do not

plug the heater into a circuit that already has other

appliances working.

11. It is normal for the plug to feel warm to the touch;

however, a loose fit between the AC outlet (receptacle)

and plug may cause overheating and distortion of the

plug. Contact a qualified electrician to replace loose or

worn outlet.

12. To disconnect the heater, first turn controls to the OFF

position, then grip the plug and pull it from the wall

outlet. Never pull by the cord.

13. Do not insert or allow foreign objects to enter any

ventilation or exhaust opening as this may cause an

electric shock or fire, or damage the heater.

14. To prevent a possible fire, do not block air intakes or

exhaust in any manner. Do not use on soft surfaces, like

a bed, where openings may become blocked.

15. A heater has hot and arcing or sparking parts inside. Do

not use it in the areas where gasoline, paint, or

flammable liquids are used or stored.

16. Use this heater only as described in this manual. Any

other use not recommended by the manufacturer may

cause fire, electric shock, or injury to persons.

17. The output of this heater may vary and its temperature

may become intense enough to burn exposed skin. Use

of this heater is not recommended for persons with

reduced sensitivity to heat or an inability to react to

avoid burns.

18. This heater is intended for residential use only, and is

not intended for commercial or industrial use.

19.SAVE THESE

INSTRUCTIONS

Model HZ-385

Series

Intended for

floor use only

Model HZ-3750

Series

Intended for

floor use only

Model HZ-370

Series

Intended for both

table top and

floor use

The Honeywell trademark is used by Kaz, Inc. under license from Honeywell Intellectual Properties, Inc.

HZ-370_3750_385_OM.qxd 6/7/06 5:05 PM Page 1

SET-UP

• Remove the heater from the box and remove all packaging materials

• Place the heater on a firm, level, open surface free from obstructions at least 3 feet (0.9m) way from

any wall, furniture or combustible material.

S T E P 1 : P O W E R

• Plug the unit into your wall outlet. When the unit is plugged in, it will

beep.

• Press the Power button ( ) once to turn the heater on. The power

indicator light ( ) will illuminate. The heater will operate on high

power, continuous operation (Fig. 1)

• Press the power button a second time to turn the heater off.

S T E P 2 : H E A T S E T T I N G S

• When the heater is turned on it will automatically operate on max heat,

continuous run.

• Press the heat setting button ( ) once to change the heat setting from

max power to energy saver mode ( ). In this setting the heater will

operate at 900 watts and run continuously. (Fig. 2)

• Press the heat setting button a second time to change the heat setting

back to max power (1500 watts), continuous run.

NOTE: Unless the temperature set function is activated the heater will run

continuously.

S T E P 3 : T E M P E R A T U R E S E T F U N C T I O N

• To set the desired temperature, turn the temperature knob ( ),

the temperature display will change from the current room temperature

to display a default temperature of 75° F (23.8° C) (Fig. 3).

• The desired temperature can be set between 45° F (7.2° C) and 80° F

(26.6° C).

• Turn the temperature knob counterclockwise to decrease the desired

temperature or clockwise to increase the desired temperature.

• Once the desired temperature is set the current room temperature will

appear.

• The heater will turn off shortly after the Desired Temperature is reached

and the Temperature Display will blink.

• The heater will turn back on when the room temperature drops below

the Desired Temperature. The Temperature Display will then stop

blinking and will display the current room temperature.

Fig. 1

OPERATION

Fig. 2

Fig. 3

HZ-370 Series

HZ-3750 & HZ-385 Series

HZ-370 Series

HZ-3750 & HZ-385 Series

Timer Button

Power/Temperature

Contol Knob

Heat Setting Button

HZ-370 Series

Power/Temperature

Contol Knob

Timer Button

Heat Setting

Button

Oscillation Button

HZ-370_3750_385_OM.qxd 6/7/06 5:05 PM Page 2

Produkt Specifikationer

Mærke:	Honeywell
Kategori:	Varmeapparater
Model:	HZ-385BP

Har du brug for hjælp?

Hvis du har brug for hjælp til Honeywell HZ-385BP stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Varmeapparater Honeywell Manualer

Honeywell HZ-960 Manual

13 Januar 2025

Honeywell HZ-385BP Manual

12 Januar 2025

Varmeapparater Manualer

Nyeste Varmeapparater Manualer

Emerio FH-120669 Manual

15 Januar 2025

Profile Fogo Manual

14 Januar 2025

Vornado MVH Manual

13 Januar 2025

Termozeta TZR28 Manual

13 Januar 2025

Infiniton HS-2067PTC Manual

13 Januar 2025

Dimplex OFRC24TFNB Manual

12 Januar 2025

Kambrook KCE85 Manual

12 Januar 2025

Eurom Fireball 60T Manual

12 Januar 2025

Kambrook KFH600 Manual

12 Januar 2025

EWT Clima Futur 110LCD Manual

15 Oktober 2024