HOTEC H-U26C Manual

HOTEC Mikrofon H-U26C

Læs gratis den danske manual til HOTEC H-U26C (4 sider) i kategorien Mikrofon. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om HOTEC H-U26C, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Use

Hotec Wi

Mode

Thanks for purcha

microphone, pleas

instrucons

carefu

Email:

support@s

Website: www.sz

FB page:

https://w

Or scan the QR co

Hotec

is the registered trade

Ltd.

H-U26C

er Guide

ireless Microph

el: H

-U06C / H-U26C

asing Hotec UHF Wire

se read the following

ully before use.

-tecson.com

hotec.com

www.facebook.com/H

ode

emark of Shenzhen Tecson Trade

H-

hone

eless

Hotechome

and Technology Co.,

SYSTEM CONTENT

H-U06C

H-U06C Handheld microphone x 1

H-U06C Mini rechargeable receiver x 1

Charging cable x 1

AA battery x 2 (for microphone)

Rechargeable battery x 1 (for receiver)

Microphone foam x 1

An-rolling ring x 1

H-U26C

H-U26C Handheld microphone x 2

H-U26C Mini rechargeable receiver x 1

Charging cable x 1

AA baery x 4 (for microphone)

Rechargeable baery x 1 (for receiver)

Microphone foam x 2

An-rolling ring x 2

PRODUCT INTRODUCTION

Hotec UHF wireless microphone works at

902-928MHz, total 32 selectable frequencies

for choice for H-U06C and 64 frequencies for

H-U26C, 32 for each channel. The handheld

microphone system with mini rechargeable

baery is perfect for vocal transmission over

PA, mixer console, PA speaker and amplier.

The handheld microphone for H-U06C/H-U26C

is powered by AA baeries and the receiver is

baery.

PREPARATION BEFORE USE

a) Charge and install battery for mini receiver

Open the battery compartment of the

receiver to check if the rechargeable battery is

installed in place. Make sure the receiver is

fully charged before use. Charging me for

the mini receiver is about 4 hours. The

receiver works up to 10-15 hours aer fully

charged.

When the baery is low, the battery indicator

becomes red. It is blue color during charge

and the light will be off aer fully charged.

b) Install baeries for microphone

Open the battery compartment of the

handheld microphone, install the AA

batteries.

c) Check and make sure the microphone and

receiver are connected

Power on both mini receiver and the

handheld microphone. Make sure the mic and

receiver are paired. If you see the following

indicator color, the mic and receiver are

paired and you are ready to use aer you

connect it to your audio device.

For H-U06C, when the RF indicator is green,

the mic and receiver are paired and ready to

use.

For H-U26C, when the Channel A is connected

to the receiver, the RF indicator is green;

when Channel B microphone is connected,

the RF indicator is blue. When both mics are

connected, it is orange.

RECHARGEABLE MINI RECEIVER：

①

Power buon: Push the buon to ON

posion to power on the receiver; OFF to

power o the receiver.

Receiver for H-U06C/H-U26C

② Battery status indicator: When the battery is

low, the indicator will become red. When

charging, it is Red and the light will be o when

it is fully charged.

③ USB charging port: Charge the mini receiver

using any 5V1A or 5V2A USB adapter (USB

charging cable included, but USB adapter is not

included)

④ Gain: Gain I volume is slightly higher than

Gain II.

⑤ RF indicator: For H-U06C, when the

microphone and receiver is connected, the RF

indicator is green; for H-U26C, when channel A

microphone is connected with the receiver, it is

green; if channel B is connected, it is When

both are connected, it is green/red.

Baery

low

indicator

Red

Green

Charging

status

indicator

Blue

OFF

indicator

H-U06C

H-U26C

①

ON/FF: short p

o the handheld m

②

Battery level in

Handhe

Baery is low

Charged

In charging

Fully charged

Green

Mic and receiv

Green

Only CHA is co

receiver

Red

Only CHB is co

receiver

Green/Red

Both CHA and

connected wit

ress this buon to po

microphone

ndicator: This indicato

eld Microphone

ver are paired

onnected with

CHB are

th receiver

ower on /

or tells you

how much baery is le. Change the battery

when the battery level is low.

③Frequency point: this shows what frequency

the handheld mic works.

④ Frequency change buon: You can nd this

buon when open the battery compartment.

Short press this button to change the frequency

in case there is interference.

CONNECTION

Make sure your speaker, mixer or PA/amplier

has 1/4” microphone input and microphone

volume control.

Step 1: Plug the mini receiver into the

1/4”microphoneinput of your audio device like

speaker, mixer and amplier.

Step 2: Turn the microphone volume to minimum

before plug in the mini receiver to avoid feedback

or harsh loopback.

Produkt Specifikationer

Mærke:	HOTEC
Kategori:	Mikrofon
Model:	H-U26C

Har du brug for hjælp?

Hvis du har brug for hjælp til HOTEC H-U26C stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Mikrofon HOTEC Manualer

23 Juni 2025

23 Juni 2025

23 Juni 2025

23 Juni 2025

3 Juni 2025

Mikrofon Manualer

Nyeste Mikrofon Manualer

Cellular Line Talk Pro Manual

9 September 2025

Defender Talky-137 Manual

9 September 2025

Krux Epic 1000S Manual

9 September 2025

Reloop RWM-1 HH Manual

7 September 2025

Reloop RUF-10 HH Manual

7 September 2025

Reloop RWM-10 HS Manual

7 September 2025

Reloop RWM-1 HS Manual

6 September 2025

Reloop RUF-1 HH Manual

6 September 2025

Reloop RSM-120 Manual

6 September 2025

Reloop RWM-2 HH Manual

6 September 2025