Hotpoint FZA36P Manual

Hotpoint Fryser FZA36P

Læs gratis den danske manual til Hotpoint FZA36P (20 sider) i kategorien Fryser. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Hotpoint FZA36P, eller vil du spørge andre brugere om produktet?

Side 1/20
FREEZER - MODEL
FZA34, FZM34-FZA36P-FZA36G
INSTRUCTIONS FOR INSTALLATION & USE
GETTING STARTED:
To ensure that your freezer runs reliably and efficiently follow these steps.
Choose a location for your
freezer, away from any
heat sources and allow
adequate ventilation -
30mm (11/4inches)
gap above.
Level the freezer by
adjusting the front feet.
This will stop rocking or
vibration and keep the
door aligned.
Plug in and switch on.
Allow the freezer to cool
before placing food
inside.
The high temperature
light will stay on until the
freezer has cooled down.
All food in the freezer
should be covered.
Move the freezer into
position, using the sides
of the cabinet. Take care
to avoid damaging the
refrigerant circuit pipe
work on the rear.
Before plugging in and
switching on, leave the
freezer in its final
location for at least 15
minutes to allow it to
settle.
If you are freezing fresh
food, turn on fast freeze by
pressing the switch 24
hours before placing the
food inside.
Place the fresh food
inside.
Read the rest of these instructions to get the best from your appliance
and remember to fill in your guarantee registration.
Keep this Book in a safe place for quick reference.
STEP 1 STEP 2
STEP 3 STEP 4
STEP 5 STEP 6
SAFETY &
INSTALLATION CONTROLS USEFUL ADVICE
CLEANING &
MAINTENANCE
TROUBLESHOOTING
SERVICE &
GUARANTEE
Your freezer is now
working.
If after 24 hours your
freezer is not operating as
you want, refer to the
TROUBLESHOOTING
section.
STEP 7
NB.The spanner is for illustration
only and is not supplied with the
freezer.
Remember to turn fast freeze off
after 24 hours, however if you
forget to do so it will automatically
cancel after 48 hours.
For Your Safety
For your safety, read the following advice:
The freezer cooling system contains a small amount of gas which is environmentally
friendly but flammable. To avoid any risk :-
Install the freezer following the installation instructions and ensure
that ventilation openings are kept clear of obstruction.
Take care when installing or moving the freezer to avoid damaging
the pipes on the rear.
If you suspect a leak, do not switch on the freezer, but open the
windows and doors to ventilate the room.
Do not use any electrical devices inside the freezer, for instance for
defrosting.
Do not use any mechanical devices for defrosting other than any which may
have been supplied with the freezer, as they may cause damage.
Only use this freezer for storing domestic foodstuffs.
When installing your freezer :-
Ensure that the mains cable is not trapped underneath or behind the freezer
when you install or move it.
Do not stack any other appliance on top of this freezer as they may
damage the freezer or become unstable.
When using your freezer :-
Do not sit or stand on top of your freezer.
Do not store poisonous, flammable or dangerous substances in your freezer.
Do not use aerosol sprays for defrosting or cleaning your freezer.
If you sell the freezer, pass on this booklet to the new owner.
2
SAFETY &
INSTALLATION


Produkt Specifikationer

Mærke: Hotpoint
Kategori: Fryser
Model: FZA36P

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint FZA36P stil et spørgsmål nedenfor, og andre brugere vil svare dig