HQ EL-PIR80 Manual

HQ Lys EL-PIR80

Læs gratis den danske manual til HQ EL-PIR80 (66 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 56 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 28.5 anmeldelser. Har du et spørgsmål om HQ EL-PIR80, eller vil du spørge andre brugere om produktet?

Side 1/66
EL-PIR80
Radar sensor light
1
The sensor light has an active motion detector, the integrated HF sensor emits high-
frequency electro-magnetic wave (5.8GHz) and receives their echo. The sensor
detects the change in echo from even the slightest movement in the light’s detection
zone. A microprocessor then triggers the “switch light ONcommand. Detection is
possible through doors, panes of glass or thin walls.
Detection zones for ceiling mounting
1) Minimum reach 1m dia.
2) Maximum reach 8m dia.
Detection zones for wall mounting
3) Minimum reach 1m dia.
4) Maximum reach 8m dia.
Important: persons or objects moving towards the light are detected best!
Installation procedures
1. Take down the glass shade by turning it anti-clockwise (see g.1)
2. Hold base against the wall and mark drill holes, paying attention to any existing
wiring in the wall;
3. Drill the holes, insert wall plugs (6mm dia);
4. Put the power wire and load wire through the base holes;
5. Screw the base into place (see g. 2);
6. Connect the mains power supply and the load wire to the connection terminal
according to connection-wire mark.
7. Adjust knob to setting;
8. Fit glass shade and turn it clockwise (see g. 3).


Produkt Specifikationer

Mærke: HQ
Kategori: Lys
Model: EL-PIR80

Har du brug for hjælp?

Hvis du har brug for hjælp til HQ EL-PIR80 stil et spørgsmål nedenfor, og andre brugere vil svare dig