Hughes & Kettner Red Box Mk II Manual

Hughes & Kettner Ikke kategoriseret Red Box Mk II

Læs gratis den danske manual til Hughes & Kettner Red Box Mk II (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 28 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 14.5 anmeldelser. Har du et spørgsmål om Hughes & Kettner Red Box Mk II, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

HUGHES

KETTNER

RED

BOX

The RED BOX enables you to connect your

consolewithout the problems of miking. The

uitar amplifier directly to a sta

abinetulator

circuitry

of the RE

e or studio mixing

BOX authentically

recreates the sound of a

miked-up

guitar cabinet loaded with four 12” loudspeakers.

Advantages:

No phase cqnceiiation through interaction with other open microphones.

None of the extraneous noises a microphone would pick up

(stage rumble. bleed-through from other instruments).

No need to lug and position an extra mike and mike stand on stage,

uncluttered stage appearance.

Reduced set-up time, consistent sound.

Instructions:

VERY IMPORTANT: Turn off power to the amp before making

any

connections to

the RED BOX. Failure to do so can result in non-warranty damage to the RED BOX.

Also VERY IMPORTANT: If

you connect a tube amp to the SPEAKER IN jack, you

must also connect a speaker (or at least a dummy load) to the RED BOX

SPEAKER THRU jack. Failure to do so may damage the amp. (Just like revving an

engine in neutral without a load at maximum RPM’s can damage an engine).

First, install a 9-volt battery Power from this battery is automatically turned on

by the insertion of a standard

1/4"

plug into either the LINE IN or SPEAKER IN,

and is turned back off simply by removing the plug.

Connections:

A tube output stage plays a major role in the creation of an amplifier’s tone.

With tube amps it is therefore recommended that the RED BOX be connected

to the amplifier’s loudspeaker output (and the RED BOX SPEAKER THRU be

connected to the speaker). With transistor amplifiers, however, for the sake of

the best dynamics and signal-to-noise ratio, the preamp signal (LINE OUT) is

preferred.

Transistor amp

Tube amp

Technical specifications:

Operational voltage : 9 volts DC

Power consumption : 1 mA

LINE IN

maximum 2.3 volts, impedance 20 Kohms

LINE OUT: balanced, impedance 200 ohms

Gain

OdB

Adapter (optional)

: Ring =

Tip =

-.9

to 20 volts DC

HUGHES

KETTNER

VERTRUEB

HUGHES

KETTNER INC.

W.-GERMANY

35 SUMMIT AVENUE

C T

Produkt Specifikationer

Mærke:	Hughes & Kettner
Kategori:	Ikke kategoriseret
Model:	Red Box Mk II

Har du brug for hjælp?

Hvis du har brug for hjælp til Hughes & Kettner Red Box Mk II stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Hughes & Kettner Manualer

Hughes & Kettner Spirit of Vintage Manual

15 December 2025

Hughes & Kettner TubeMeister 5 Manual

15 December 2025

Hughes & Kettner TubeMeister 36 Head Manual

23 September 2025

Hughes & Kettner WARP 112 Manual

17 September 2025

Hughes & Kettner Statesman DUAL EL34 Manual

17 September 2025

Hughes & Kettner Statesman DUAL 6L6 Manual

16 September 2025

Hughes & Kettner Vortex 212 Manual

16 September 2025

Hughes & Kettner TubeMeister 36 Manual

16 September 2025

Hughes & Kettner Statesman DUAL EL84 Manual

16 September 2025

Hughes & Kettner Triplex Manual

16 September 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

TOTO TSMX Manual

17 December 2025

Gamdias Aura GC2 Manual

17 December 2025

Vaxcel T0777 Manual

17 December 2025

Vaxcel T0696 Manual

17 December 2025

Vaxcel T0735 Manual

17 December 2025

Grundig Miami 49 VLX 9670 BP Manual

17 December 2025

Silverstone UC01 Manual

17 December 2025

Liteline P-4020 Manual

17 December 2025

Vaxcel T0376 Manual

17 December 2025

Vaxcel T0779 Manual

17 December 2025