
Please read the following instructions carefully before installing your Induction Dynamics
subwoofer series. If you have any
questions regarding installation that are not answered in the following directions, please contact your local sound contractor or
technical support team. Contact information can be found on the back of the manual.
Your speakers and amplier come in a high quality nish that is both attractive and durable. To clean, use a soft, damp cloth. If
your drivers become dusty, dust them with a paintbrush or a brush vacuum attachment. Do not use a strong or abrasive cleaner.
The grille is covered in acoustic cloth. To keep your grille clear of debris, we recommend you use a lint roller (like you would use
Do not use bass or loudness contour controls. Induction Dynamics’ subwoofers produce very low frequencies without these
controls. Use of these controls will make the bass sound “boomy”, obscure higher frequencies, and possibly cause damage
due to excessive cone excursion.
Amplifer location: The A2 amplier is best located in an equipment rack or shelving with other audio and video equipment. It is
not recommended for placement behind walls or other limited access locations, where service may be restricted.
The A3 amplier is built in to the SW1, SW2, SW3 and SW4. If you chose the A3 option, make sure to place your subwoofer in
an open area with plenty of ventilation. Do NOT build in to walls or place the subwoofer in a closed area.
Speaker Wiring: Use approved wire designed for in-wall or exposed use, as appropriate for your installation. For freestanding
speakers, we recommend using high-quality speaker wire that is 12 gauge or lower, with easily visible polarity coding to make
your connections. The following chart identies minimum gauge requirements for various lengths. See your local dealer or
installation contractor for more information.
Wire Length / Minimum Gauge