Insignia NS-IMP26SL0 Manual

Insignia Isterningmaskine NS-IMP26SL0

Læs gratis den danske manual til Insignia NS-IMP26SL0 (2 sider) i kategorien Isterningmaskine. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Insignia NS-IMP26SL0, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

PACKAGE CONTENTS

• Portable ice maker

• Ice basket (pre-installed)

• Ice shovel

• Quick Setup Guide

FEATURES

• Stores up to 1.5 lbs. (.68 kg) of ice

• Quick production cycle creates ice every 6 to 13 minutes

• Auto-detect prevents ice from overowing when the basket is full

• Two ice cube sizes help create the perfect drink

• Removable ice basket gives you convenient access

• Water recycling system with reservoir lets you place your ice maker anywhere

IMPORTANT SAFETY INFORMATION

• Read these instructions.

• Keep these instructions.

• Heed all warnings.

• Follow all instructions.

• Do not operate your ice maker with a damaged cord.

• Your ice maker requires a standard 110-120volt, 60Hz electrical outlet with a three-prong ground.

• Connect to a properly polarized outlet only. No other appliance should be plugged into the same outlet.

Make sure that the plug is fully inserted into the outlet.

• Do not run the power cord over carpeting or other heat insulators. Do not cover the cord. Keep the cord

away from trac areas, and do not submerge in water.

• We do not recommend the use of an extension cord because it may overheat and become a risk of re.

If you must use an extension cord, use No.14 AWG minimum size and rated no less than 1875 watts.

• Unplug your ice maker before cleaning or making any repairs or servicing.

• Exercise caution and use reasonable supervision when your ice maker is used near children.

• Do not use your ice maker outdoors.

• Place your ice-maker away from direct sunlight and make sure that there is at least 4 inches (10 cm) of

space between the back and sides of your ice maker and surrounding walls.

• Do not use any other liquid besides water to make ice cubes.

• Do not clean your ice maker with ammable uids. The fumes can create a re hazard or explosion.

• Do not tip over.

• If your ice maker is brought in from outside storage in winter, wait a few hours for it to warm up to room

temperature before plugging it in.

• To avoid a hazard due to instability of your ice maker, it must be placed on an even or at surface.

WARNING: This appliance must be grounded.

Before using your new product, please read these instructions to prevent any damage.

OVERVIEW

Control panel

UNPACKING YOUR ICE MAKER

Remove the exterior and interior packaging. Make sure that you unpack the

ice basket and ice shovel. If any parts are missing, contact Best Buy customer

service.

Note: Make sure that your ice maker is positioned so that the plug is accessible.

QUICK SETUP GUIDE

Portable

Ice Maker

NS-IMP26SL0 / NS-IMP26RD2 /

NS-IMP26MT2 / NSIMP26WH2

Ice maker

POWER indicator

Lights when your ice

maker is turned on.

ON/OFF button

Press to turn your ice

maker on or o.

ICE FULL indicator

Lights when the ice

basket is full.

ADD WATER indicator

Lights when you need

to add water.

SELECT button

Press to select the

ice cube size:

SMALL or LARGE

Ice cube size

Lights to indicate the

selected ice cube size.

Ice shovel

Use to remove ice from the basket.

Ventilation opening

Provides cooling. Do not block.

Water drain plug

Unplug to drain water.

Ice basket

Holds ice.

Cover

Lift to remove ice.

Ice scoop

Moves ice into the ice basket.

Ice full sensor

Senses when the ice maker is full.

V6 ENGLISH 23-0039

CLEANING AND MAINTENANCE

To clean your ice maker, follow the instructions in steps 3-5 in SETTING UP YOUR ICE

MAKER.

• Clean the ice maker at least once a week or every three days if your water quality

is poor.

CAUTION: Do not use bleach or vinegar to clean the internal components.

TIPS FOR SAVING ENERGY

• Locate your ice maker in the coolest area of the room, away from heat

producing appliances or heating ducts.

• Make sure that your ice maker is suciently ventilated, with adequate air

circulation behind it.

TROUBLESHOOTING

The ADD WATER indicator is on.

• Turn o your ice maker, open the cover, then remove the ice basket. Add water

up to the MAX line. Replace the basket, then close the cover. Turn on your ice

maker.

The ICE FULL indicator is on.

• Remove ice from the ice basket.

Ice cubes stick together.

• The ice cycle is too long for the room temperature. Stop your ice maker, and

restart it when the ice blocks melt. Select the small size ice cube selection.

• The water temperature may be too cold. Change the water in the inner tank.

The best water temperature is between 45°F ~ 90°F (7°C ~ 32°C).

The ice making cycle is normal, but no ice is made.

• The room temperature or water temperature may be too high. The room

temperature should be 50°F ~ 105°F (10°C ~ 40°C). The water temperature

should be 45°F ~ 90°F (7°C ~ 32°C).

• The refrigerant liquid may have leaked. Contact a qualied service technician

for repair.

• The pipe in the cooling system may be blocked. Contact a qualied service

technician for repair.

The ice maker will not stop.

• Direct sunlight or sunlight reection can cause the sensor to malfunction.

Move your ice maker.

My ice maker is noisy.

• Your ice maker makes noise during the freezing cycle and when it is dumping

ice. This is normal.

SPECIFICATIONS

Dimensions (H×W×D): 12.6 × 8.7 × 12.3 in. (32 × 22.1 × 31.2 cm)

Net weight: 15.7 lbs. (7.1 kg)

Protection type: 1

Power: 115V/60Hz

Wattage: 120W (25°C), 140W (40°C)

Ice making current: 1.7A

Ice harvest current: 2.0A

Refrigerant: R600 a/21 g

Design pressure:

High side: 290 psig

Low side: 88 psig

Enclosure: Silver, red, mint, or white

Ice cube weight:

Small: .25 oz. (7 g)

Large: .32 oz. (9 g)

Reservoir capacity: 2.11 qt. (2.0 l)

ONE-YEAR LIMITED WARRANTY

Visit www.insigniaproducts.com for details.

CONTACT INSIGNIA:

For customer service, call 1-877-467-4289 (U.S. and Canada)

www.insigniaproducts.com

INSIGNIA is a trademark of Best Buy and its aliated companies

Distributed by Best Buy Purchasing, LLC

7601 Penn Ave South, Richeld, MN 55423 U.S.A.

SETTING UP YOUR ICE MAKER

1 Place your ice maker on a level surface in a location where your ice maker is

protected from direct sunlight and other sources of heat (such as a stove,

furnace, or radiator).

2 Make sure that there is at least 4 inches (10 cm) of space between the back

and sides of your ice maker and the surrounding walls.

3 Clean the interior with diluted detergent, warm water, and a soft cloth, then

rinse with clear water.

4 Take out the ice basket and clean it.

5 Unplug the water drain cap to remove all water. Replace the water drain plug

before lling with water.

6 Before using your ice maker for the rst time, run two to three cycles of ice

and dispose of them to help remove any plastic odor or residue from the

manufacturing and shipping process.

USING YOUR ICE MAKER FOR THE FIRST TIME

WARNINGS:

• Your ice maker must be grounded. Do not defeat the safety purpose of the

grounding-type plug. A grounding-type plug has two blades and a third grounding

prong. The third prong is provided for your safety. If the provided plug does not t into

your outlet, consult an electrician for replacement of the obsolete outlet.

• Before plugging in your ice maker, wait one hour for the refrigerant uid to settle.

1 Make sure that the water drain plug is in place and secure.

2 Open the cover, remove the ice basket, then pour drinking water into the

reservoir. Make sure that the water level is below the MAX line.

WARNING: Fill with drinking water only

3 Replace the ice basket, then close the cover.

4 Plug the power cord into a power outlet.

5 Press the ON/OFF button. The power indicator lights.

6 Press the SELECT button to select the ice cube size. If the room temperature is

lower than 60°F (16°C), we recommend that you select the small cube size to

keep ice from sticking together.

Notes:

• When the ice basket is full, your ice maker automatically stops making ice and the ICE

FULL indicator lights.

• After ice is made and goes into the ice basket, the ice begins to melt. To save the ice,

remove it from the basket and freeze it. Otherwise, the ice melts, the water goes back

into the reservoir, and your ice maker recycles the water to make ice again.

• The ice making cycle lasts 6 to 13 minutes, depending on the selected ice cube size and

the ambient temperature. If the room is extremely hot, the cycle may take longer.

• While your ice maker is on, check the water level periodically. If the water level is too low,

your ice maker stops automatically and the ADD WATER indicator light will illuminate.

Turn o your ice maker, then ll the reservoir to the level mark. Wait at least three minutes

for the refrigerant liquid inside the compressor to settle, then turn on your ice maker.

• Change the water in the water reservoir every 24 hours to ensure that the water is fresh

and the ice tastes good.

• If your ice maker is not in use, drain all water left in the tank.

MAX line

Produkt Specifikationer

Mærke:	Insignia
Kategori:	Isterningmaskine
Model:	NS-IMP26SL0

Har du brug for hjælp?

Hvis du har brug for hjælp til Insignia NS-IMP26SL0 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Isterningmaskine Insignia Manualer

Insignia NS-IMN44BS4 Manual

30 September 2025

Insignia NS-IMC44S3 Manual

29 September 2025

Insignia NS-IMP26SL0 Manual

29 September 2025

Isterningmaskine Manualer

Nyeste Isterningmaskine Manualer

Klarstein Glacial Pro Manual

29 September 2025

Klarstein IceCraft Manual

29 September 2025

Klarstein FrostMaster Manual

28 September 2025

Klarstein Ice Galet Manual

28 September 2025

Klarstein Glacial XXL Manual

28 September 2025

Klarstein Partytime Manual

28 September 2025

Klarstein Bullet Manual

28 September 2025

Klarstein Spark Ice Manual

28 September 2025

Avantco HBN120-22 Manual

17 September 2025

Avantco KMC-H-322-HA Manual

17 September 2025