Intermatic PF1102M Manual

Intermatic Ikke kategoriseret PF1102M

Læs gratis den danske manual til Intermatic PF1102M (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 52 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 26.5 anmeldelser. Har du et spørgsmål om Intermatic PF1102M, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

INSTALLATION

OPERATION &

SERVICE MANUAL

Model: PF1102 FREEZE PROTECTION CONTROL

IN RAINPROOF (TYPE 3R) ENCLOSURE

Model: PF1102M FREEZE PROTECTION CONTROL MECHANISM

SUITABLE FOR POOL/SPA EQUIPMENT CONTROL

INPUT VOLTAGE: 240 VOLT - 60 HZ.

ELECTRICAL RATING: 3 HP - 240 VOLT AC.

DANGER! To Reduce the Risk of Injury:

...do not permit children to operate the Control Unit or use the Pool/Spa unless they are closely supervised at all times.

...test GROUND FAULT protection regularly. If it fails to reset, DO NOT USE THE POOL or SPA! Contact a qualified

service technician.

...always disconnect electricity before servicing this control or the equipment(s) connected to it. THIS CONTROL IS NOT

TO BE USED AS A POWER DISCONNECT.

READ, FOLLOW & SAVE THIS INSTRUCTION MANUAL

GENERAL INFORMATION

Model PF1102 Freeze Protection Control is self-contained in an indoor-outdoor, beige, rainproof

enclosure and designed to be connected to a timing or switching device. Together, they control as well

as protect the Pool/Spa equipment and

plumbing against freeze damage. The Control,

if wired according to instructions, turns ON

the Filter Pump when the air

temperature (where this Control is

located) drops below the temperature

set by the thermostat dial (between

32˚F and 45˚F). Nevertheless, the

Control is not intended to be a

substitute for the insulation, coverings or

maintenance.

Model PF1102M is a mechanism only,

functions just like Model PF1102 and

fits (snaps into) any Intermatic Pool

Panel, Models T10000R, T30000R or

T40000R Series. Both models are

designed to operate on 240 Volt, 60

cycle only.

FREEZE PROTECTION

FOR POOLS, SPAS

AND WATER FEATURES

INSTALLATION - MODEL PF1102

1. Select the proper

outdoor

location for the

Freeze Protection Control and prepare the

necessary conduit run(s) required by the

installation layout.

2. Hang enclosure on a flat vertical surface or

other support, preferably next to the Switching

Device, using hardware

suitable for the purpose.

3. Properly terminate

conduits at both ends

and pull-in the

conductors as specified by

the installation layout.

4. Follow wiring diagram on page 4 of this manu-

al and make LINE and LOAD (Pump) connec-

tions as shown. Wiring the Freeze Control,

first identify each lead by its color (Line:

Black

and

Red

, LOAD:

Blue

and

Yellow

), then

make wire connections by using twist on wire

connectors.

a. If the control device is an Intermatic 240 Volt

Time Switch, follow diagram on top of page

4 of this manual. Make connections to Time

Switch terminal block as shown in the insert

above for the proper wire termination.

b. If the control device is a Time Switch made

prior 1984 by Intermatic or made by another

manufacturer or it is other than a time switch

(air switch, contactor, etc.), first identify the

LINE and LOAD terminals (leads) of the

control and wire the two devices in

Parallel

as shown on bottom of page 4.

Make sure the installation is properly grounded.

5. If the Freeze Protection Control is installed in

a location where it is exposed to direct sun most

of the day, extend 8 inches of the copper

capillary tube of the thermostat into an open

ended (plastic or metal) conduit about 10 inches

long, installed at bottom of the enclosure.

Handle capillary tube with care!

6. TEST INSTALLATION:

a. Turn the thermostat dial to its lowest setting

and place crushed ice (in plastic bag) inside

capillary coil of Thermostat.

b. Turn ON power to Control Panel, wait one

minute, then slowly turn thermostat dial

counterclockwise until Filter Pump starts.

c. Turn power OFF to Control, remove ice,

and check wiring. Tighten terminal screws if

necessary. Reinstall front plate.

d. Turn power ON to Control and set the

Time Switch and the Thermostat. See

OPERATION instructions below.

1. Install mechanism in any Intermatic Pool Panel

with only one Time Switch by snapping it into the

unused mounting bracket, furnished with the

Panel.

2. Follow steps 4 to 6 above, complete the

installation.

INSTALLATION - MODEL PF1102M

PRESSURE PLATE

TERMINAL SCREW

MAKE SURE INSULATION

CLEARS PRESSURE PLATE

CONDUCTOR

IMPORTANT SAFETY INSTRUCTIONS

When installing and operating this Product and other associated equipment, basic safety precautions should always be

followed.

1. This Control must be installed by a qualified person, according to National and Local Electrical Codes.

2. Install this Control not less than 5 feet (3 meters in Canada) from inside edge of pool and 1 foot (30cm) above ground. USE

COPPER CONDUCTORS ONLY rated minimum 75˚ C.

3. Do not exceed the maximum ratings of individual components, wiring devices, and current carrying capacity of conductors.

4. For Control grounding, bonding, installing and the wiring of underwater lights, refer to Article 680 of the National Electrical Code

or Article68 of the Canadian Electrical Code.

5. The Control should not operate any equipment which would cause bodily injury or property damage should it be activated

unexpectedly.

Produkt Specifikationer

Mærke:	Intermatic
Kategori:	Ikke kategoriseret
Model:	PF1102M

Har du brug for hjælp?

Hvis du har brug for hjælp til Intermatic PF1102M stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Intermatic Manualer

Intermatic ET2825CR Manual

31 Juli 2025

Intermatic EI230W Manual

30 Juli 2025

Intermatic WH40 Manual

30 Juli 2025

Intermatic R8806P101C Manual

30 Juli 2025

Intermatic LC4527 Manual

30 Juli 2025

Intermatic Arista ALC-4B-BT Manual

30 Juli 2025

Intermatic ET2105CR Manual

30 Juli 2025

Intermatic RC4G Manual

30 Juli 2025

Intermatic FD46H Manual

30 Juli 2025

Intermatic FM1D20-24U Manual

30 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Navman MiVue 540 Manual

2 August 2025

Pro User PSI2000TX Manual

2 August 2025

Guede 5T Manual

2 August 2025

Navman EZY40 Manual

2 August 2025

Thule Chariot Ski kit Manual

2 August 2025

Hozelock 5102 Manual

2 August 2025

ART 310 Manual

2 August 2025

Gorenje KAS53ZDCINVFT Manual

2 August 2025

Gorenje KAS35ZDCINVFT Manual

2 August 2025

Navman MY450LMT Manual

2 August 2025