Intermatic RC939 Manual

Intermatic Fjernbetjening RC939

Læs gratis den danske manual til Intermatic RC939 (2 sider) i kategorien Fjernbetjening. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Intermatic RC939, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
Libertyville, Illinois 60048
www.intermatic.com
RC939 THREE-CHANNEL RADIO
TRANSMITTER
Installation Operation & Service Manual
SAFETY SECTION
Warning
• Ingestion Warning: This product contains a button cell or coin battery.
• DEATH or serious injury can occur if ingested.
• A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
• KEEP new and used batteries OUT OF REACH of CHILDREN
• Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.
• Risk of injury or death. Always plug three-prong plug into a properly grounded outlet. Never attempt to defeat this safety feature.
• Do not use timer to control devices that could have dangerous consequences due to inaccurate timing, such as sun lamps, sauna, heaters, crock pots, etc.
• Unplug timer before replacing batteries.
• Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate.
• Even used batteries may cause severe injury or death.
• Replace only with CR2032 (3 V) Batteries.
• Call a local poison control center for treatment information.
• Non-rechargeable batteries are not to be recharged.
• Do not force discharge, recharge, disassemble, heat above (manufacturer’s specified temperature rating) or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.
• Ensure the batteries are installed correctly according to polarity (+ and -).
• Do not mix old and new batteries, different brands or types of batteries, such as alkaline, carbon-zinc, or rechargeable batteries.
• Remove and immediately recycle or dispose of batteries from equipment not used for an extended period of time according to local regulations.
• Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.
PRODUCT DESCRIPTION
The RC939 Radio Transmitter is used to control Intermatic model RC613 series radio receivers.
In order for the transmitter to function, it must rst be linked to an RC613 series receiver. The
transmitter can then operate the receiver to provide remote ON/OFF control of devices connected
to the receiver.
INITIAL SETUP
Verifying Receiver Operation
Before linking the transmitter to your receiver, perform this procedure to verify that the RC613
receiver is operating properly.
1. Press the red button on the receiver multiple times. The receiver will click and the
connected device will turn ON and OFF to indicate the receiver is working and is
wired properly.
2. If the receiver does not click when pressing the red ON/OFF button, make
sure there is 120 VAC power to the receiver module.
3. If the receiver module clicks but the connected device doesn’t operate,
make sure the connected device is functional and is correctly wired to the
receiver module.
Linking an RC939 Transmitter Button with the RC613 Receiver
NOTE: The transmitter must be within 6 feet of the receiver during setup.
1. On the remote (RC939), use a paper clip to press and release the button on
the lower right-hand side. The red LED on the remote should be solid red now.
2. On the receiver (RC613), press and hold the blue CODE SET button for 3
seconds. See Figure 3.
3. Now, with one-second intervals, tap the button that you want to program
on the remote repeatedly until you hear the relay click inside the receiver.
(Press at 7 times) least
4. Now press a different button on the remote to save your setting.
(Red LED should go out)
5. Test the button you just programmed. If it is not working, make sure the red
LED on the remote is off and go back to step 1.
Note: To clear any existing codes, press and hold the blue CODE SET button on
the receiver for 20 seconds, then release. (This will eliminate all stored codes)
Figure 1 RC939 Radio Transmitter
Red LED
Program Button
Choose any one of
these buttons
to link to a receiver
Figure 2 Side view of transmitter
Figure 3 RC613 Receiver

Produkt Specifikationer

Mærke: Intermatic
Kategori: Fjernbetjening
Model: RC939

Har du brug for hjælp?

Hvis du har brug for hjælp til Intermatic RC939 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Fjernbetjening Intermatic Manualer

Intermatic

Intermatic RC-LRSR-WH Manual

30 Januar 2025
Intermatic

Intermatic RC613L Manual

30 Januar 2025
Intermatic

Intermatic RC613R Manual

30 Januar 2025
Intermatic

Intermatic RC2163BFE Manual

30 Januar 2025
Intermatic

Intermatic RC2343PT Manual

30 Januar 2025
Intermatic

Intermatic RC613 Manual

30 Januar 2025
Intermatic

Intermatic RC939 Manual

30 Januar 2025

Fjernbetjening Manualer

Nyeste Fjernbetjening Manualer

Danfoss

Danfoss MPCAN Manual

10 November 2025
Vivanco

Vivanco RC-21966 Manual

9 November 2025
SmallRig

SmallRig Wireless Remote Controller 3902 Manual

3 November 2025
Abus

Abus Comfion FUBE80000 Manual

31 Oktober 2025
Abus

Abus Smartvest Pro FUBE45010 Manual

30 Oktober 2025
Philips

Philips SRU3030/10 Manual

28 Oktober 2025
Rotel

Rotel RKP-200 Manual

15 Oktober 2025
One For All

One For All URC 4916 Manual

8 Oktober 2025
Fusion

Fusion MS-ARX70B Manual

6 Oktober 2025
APart

APart DIWAC Manual

5 Oktober 2025