Installation Instructions and
User Guide - IXL Eco Ventflo
Model: 10332 IXL Eco Ventflo Ceiling Exhaust Fan with Draught Shutters 200,
Model: 10333 IXL Eco Ventflo Ceiling Exhaust Fan with Draught Shutters 250,
(Electric Rating: 230-240 V. 50Hz)
1K Marine Parade, Abbotsford, Victoria 3067 Australia. Free Call: 1300 727 421
www.ixlappliances.com.au
| service@ixl.com.au
New Zealand - Free Call: 0800 727 421 | www.ixlappliances.co.nz | service@ixlappliances.co.nz
IXL and Ventflo are registered trademarks of Alver Pty Ltd in Australia and New Zealand used under licence by
IXL Home Pty Ltd.
Made in China
IXL Home
Installation
Important considerations before installing
• Remove protective sheet from the product before installation (Fig.5)
• Joists, beams and rafters shall not be cut or notched to install the appliance.
• For the exhaust fan to work efficiently, replacement air of a volume equivalent to what is being
extracted must be able to enter the room. In general this air would be drawn under the door or
through a slightly open window. If the room is airtight the fan will function poorly.
• This product is designed for installation in flat ceiling only. Do not mount it on a sloping ceiling
or vertical wall.
Fig. 7
Fig. 6
1. Locating the unit – Before commencing any
cutting, check in the ceiling space that there are
no obstructions such as ceiling joists and that
there is sufficient clearance for the housing.
Check that the electrical wiring can be routed
from the wall switches to the mounting location.
2. Prepare the ceiling – Using the template provided,
mark the ceiling with a pencil outline and cut out
the required hole (10332 needs 242mm dia. &
10333 needs 295mm dia. hole).
3. Remove the grille (simply turn anti-clockwise to
unlock), see (Fig.6)
4. Plug the fan into the power point.
a. Before inserting the fan into the opening, push the
three bar clamps all the way out to hold the fan in
the ceiling. Push the fan into the ceiling opening
and secure the exhaust fan by tightening the
screws securely (Fig.7)
b. For thicker ceilings (13mm or more), remove the
three bar clamps. Use wood screws (not supplied)
to secure the fan to the ceiling. Locate screws in
the 3 holes in the outer lip of the fan frame.
5. Using a screwdriver (or a battery driver with a low
torque setting) partially tighten the screws. This
will move the mounting clips into the open position
and hold the unit to the ceiling.
6. Rotate the unit so that the grille direction lines on
the body are aligned with the walls. These lines
show the orientation of the fascia grille when
installed.
7. Do not over tighten the screws as this can
damage plasterboard.
8. Fit grille onto unit. Once fitted the grille can be
adjusted to better align with the walls.
1. Turn the power switch on/off to make sure the unit runs.
2. Running the fan can exhaust steam and odours quickly and efficiently.
Note: Shut off power urgently when any abnormalities occur in operation. Then call a licensed
electrician or IXL service person for inspection and necessary service work.
Do not insert fingers or thin bars into the grille when the unit is operating. This could cause harm
to yourself and the appliance.
The unit must not be installed in a place that suffers from severe water leakage.
3. When the unit is switched off, the draught shutters when closing, will make a slight sound.
This is normal operation.
1. Shut power off before cleaning or maintenance.
2. Remove grille and wipe it with care using a damp soft cloth with a mild detergent if necessary.
Ensure the motor or other electrical parts can’t touch the water.
3. The grille can be cleaned in a dishwasher on low heat setting ~45°C and only wash on the top shelf.
4. Replace the grille from the dishwasher after it is thoroughly dry.
Cleaning
Use
Two Year Replacement Warranty
This Warranty against defects for your newly purchased IXL product is proudly prepared by IXL
Home Pty Ltd of 1K Marine Parade, Abbotsford, VIC 3067, phone 1300 727 421.
1. IXL Home Ventilation products come with guarantees that do not exclude the following consumer
entitlements under the Australian Consumer Law:
a. replacement or refund for a major failure and compensation for any other reasonably
foreseeable loss or damage; and
b. to have the goods replaced if goods fail to be of acceptable quality and the failure does
not amount to a major failure.
2. IXL Home warrants that your product and related supply will be free from defects in materials
and workmanship during the warranty term.
Your warranty term is two years commencing from the date of purchase.
3. Subject to Point 1, IXL Home will during the warranty term provide a replacement of an
equivalent current model where the balance of the warranty period from the original date of
purchase will take effect.
4. To the fullest extent permitted by law and subject always to Point 1, IXL Home will not be
liable for:
a. any loss or damage arising from loss of use, loss of profits or revenue; or
b. for any indirect or consequential loss or damage resulting from any breach of this warranty
against defects.
5. Defective IXL Home products may be replaced by a refurbished product of the same type.
Limitations to Your IXL Warranty
6. Subject to Point 1, this Warranty:
a. will only be provided to the original purchaser where the original purchase was made from
a IXL Home Authorised Dealer or Reseller and proof of such purchase can be presented at the
time of service;
b. only applies to IXL Home products purchased in Australia and New Zealand from an IXL Home
Authorised Dealer or Reseller;
c. will not apply where the defect in or failure of the product is attributable to misuse, abuse,
accident or non-observation of the manufacturer’s instructions. This product must be used
in accordance with the manufacturer’s instructions;
d. will not cover faults due to normal wear and tear with reasonable use nor consumable
components such as globes, filters, glass items etc;
e. will not cover any damages or problems caused to this product by natural forces eg. storm,
fire, flood, and earthquake; or by intrusion or accumulation (or both) of foreign matters eg.
dust, soil, and moisture. IXL Home recommends that you take out appropriate insurances to
protect your product to this end;
f. will not apply if this product is installed in a mobile dwelling eg. caravan or boat;
Warranty
g. will not apply if this product is removed from the location where it was first installed;
h. covers use of this product for domestic use only;
i. will not be restarted or extended upon replacement of the product or a part.
How to make a claim under your IXL Warranty
7. To make a claim under this Warranty you will need to:
a. contact IXL Home customer service department on 1300 727 421 or service@ixl.com.au
to provide details and register your claim enabling a IXL Home assessment;
b. submit proof of purchase with your claim eg. tax invoice or purchase receipt;
c. where a property has been constructed by a builder/developer and it is fitted with IXL
products, please submit proof of purchase by way of the certificate of occupancy, with
your claim.
8. IXL Home will contact you to make arrangements for a replacement product.
Privacy
The privacy of your personal information has always been important to us. To learn more about
how we collect, keep and use your personal information, please obtain a copy of our privacy
statement by visiting our website at:
www.ixlappliances.com.au or by contacting us via email on service@ixl.com.au
or by telephone on 1300 727 421.
UNLOCK
LOCK
Fig. 5
Protective
Sheet
Remove before installation
Tape Sealed
