J.W. SPEAKER 8700 Evolution J2 Manual

J.W. SPEAKER Højttaler 8700 Evolution J2

Læs gratis den danske manual til J.W. SPEAKER 8700 Evolution J2 (5 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 2 anmeldelser. Har du et spørgsmål om J.W. SPEAKER 8700 Evolution J2, eller vil du spørge andre brugere om produktet?

Side 1/5
J.W. Speaker Corporation • Germantown, WI U.S.A. • www.jwspeaker.com • speaker@jwspeaker.com • 262.251.6660
Rev: 11/15/2017
Model 8700 Evolution J2
LED Headlight Instruction Sheet
INSTRUCTION INFORMATION
Tools Needed
Phillips screwdriver
Flat blade screw driver
T15 Torx driver
Wire Functions (All)
ECE Versions Only
Black = Ground
White = High Beam
Yellow = Low Beam
Red = Front Position
Blue = Daytime Running Light (DRL)
In the Box (x2) Model 8700 Evolution J2 Headlights (Kit)
INSTRUCTIONS BEGIN ON THE NEXT PAGE
Page 1
Input Voltage
Operating Voltage
12V DC
9-16V DC
Pre-Installation Guidelines
To properly install this light you should have a good
understanding of automotive electrical procedures and
systems, and proficiency in the installation of headlights.
IF YOU DO NOT, PLEASE SEEK PROFESSIONAL ASSISTANCE.
1. Read all safety notes and mounting guidelines before installing
the product. Verify that all parts listed under “In the Box” are
present and complete.
2. Inspect the product for damage. install the product if DO NOT
there is any damage. Contact the authorized retailer where you
purchased it to initiate a warranty claim if there is damage.
3. Verify that all power supply and/or charging systems comply to
the specified voltage limits for the light.
PRODUCT WARRANTY:
If you have issues with a J.W. Speaker
product, please contact the authorized
retailer where you purchased it.
Regulatory Compliance
1. Loosen the Phillips head screws in the fasteners that secure
the top of the grill. Some model years have fasteners NOTE:
that have a center post to pry out instead of screws.
2. Carefully remove the 6 fasteners by prying them up at the
base using a flat blade screw driver. Save the 6 fasteners.
5. Use a T15 Torx driver to remove the 4 screws holding the
headlight retaining ring. Save the 4 screws.
6. Remove the retaining ring and headlight from the
mounting ring.
3. Carefully TOP remove the front grill by pulling the portion
forward until it unsnaps. Start near one headlight and work
across to the other light.
4. unsnap the clips at the bottom of the grill and Carefully
let it rest across the bumper. These clips may break if NOTE:
not treated with care.
Page 2
Installation Instructions
J.W. Speaker Corporation • Germantown, WI U.S.A. • www.jwspeaker.com • speaker@jwspeaker.com • 262.251.6660
Rev: 11/15/2017


Produkt Specifikationer

Mærke: J.W. SPEAKER
Kategori: Højttaler
Model: 8700 Evolution J2

Har du brug for hjælp?

Hvis du har brug for hjælp til J.W. SPEAKER 8700 Evolution J2 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Højttaler J.W. SPEAKER Manualer

Højttaler Manualer

Nyeste Højttaler Manualer