Jawbone Up2 Manual

Jawbone Up2

Læs gratis den danske manual til Jawbone Up2 (7 sider) i kategorien . Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 12 anmeldelser. Har du et spørgsmål om Jawbone Up2, eller vil du spørge andre brugere om produktet?

Side 1/7
6/29/2015 https://help.jawbone.com/articles/en_US/PKB_Article/setupup2
https://help.jawbone.com/articles/en_US/PKB_Article/setupup2 1/7
JAWBONESUPPORT>SETUP UP2
Setup UP2
Step 1: Charge your band*
1. Your band takes approximately one hour to fully
charge. Connect the charging cable to your band by aligning the pins on the
charger with the band. A magnet will hold the charger in place.
2. Insert the charging cable into the USB drive on
your computer or a standard USB wall adapter.
3. Icons on the face of the band will light up and
pulse while the band is charging.
6/29/2015 https://help.jawbone.com/articles/en_US/PKB_Article/setupup2
https://help.jawbone.com/articles/en_US/PKB_Article/setupup2 2/7
4. When the band is fully charged the icons will stop
pulsing and the runner icon will glow solid.
* Band shown is an UP3.
Step 2: Size it for your wrist*
1. The band should be worn on your non-dominant
wrist. Place the band on your wrist and rest your wrist on a flat surface.
2. Thread the strap through the loop and tighten the
strap so that all of the sensors are touching your skin. The band should be snug,
but not tight.


Produkt Specifikationer

Mærke: Jawbone
Kategori:
Model: Up2

Har du brug for hjælp?

Hvis du har brug for hjælp til Jawbone Up2 stil et spørgsmål nedenfor, og andre brugere vil svare dig