JBL Control 68HP Manual

JBL Højttaler Control 68HP

Læs gratis den danske manual til JBL Control 68HP (4 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om JBL Control 68HP, eller vil du spørge andre brugere om produktet?

Side 1/4
How to use Release Key to adjust height of speaker:
2.
Insert key into
small hole at
top of Gripple.
Push in 1/4” to
release the
cable.
4.
Remove key
and re-secure
the load.
1.
Make sure the
load is supported.
CAUTION: Installation must be done by qualied persons using safe rigging standards.
Use equipment only in accordance with manufacturer’s instructions. Do not alter or modify.
Do not use equipment if the equipment is not functioning correctly or if the equipment is defective
4. Snap secondary support safety cable hook hanger
onto one of the side holes in the top bracket of the
speaker, and attach the top to a dierent ceiling support
point of the building structur e, per Steps 1 & 2. After
height adjustment is nal, trim any unneeded extra cable
tail wires with trimmer suitable for 2 mm (0.077 in)
diameter stranded aircraft-type cable.
SPEAKER
INSTALLATION
INSTRUCTIONS
using Suspension Systems:
3. With speaker supported, snap main
support hook hanger onto the center hole
in the top bracket of the speaker. Adjust
to proper height by pulling cable through
either end of Gripple.
Detail
3
3.
Adjust
height.
Detail
Fittings are suitable for use in Air Handling Spaces
in accordance with Section 300.22 (C) and (D)
of the National Electrical Code, and rules
12-010 (3), (4), and (5), and 12-020 of the
Canadian Electrical Code, Part 1.
File No. E228153
Luminaire Fittings
File No. E251132
Conduit & Cable Hardware
2. Pass tail end of cable through the
other channel of the Gripple (see
inset detail).
1. Thread Gripple onto cable (see inset
detail). Pass over ceiling anchor point
(as shown) or through other secure
anchor point of the building structure.
Installer is responsible for ensuring that
anchor point is secure to building
structure.
4
MANUFACTURER’S RECOMMENDATIONS
Load – Do not exceed the Safe Working Load (SWL) of the
Gripple. The SWL of the Gripple product included with this
loudspeaker is 45 kg (100 lbs).
No lifting – Do not use for lifting, such as in a crane or pulley
situation.
No movement – Gripple hangers are to be used to suspend
static loads only. Do not use to suspend moving services, or
services likely to be subject to movement.
No joining – Gripple hangers must not be spliced together
using a Gripple fastener, or any other joining device. A Gripple
hanger assembly must comprise one length of cable and one
Gripple fastener only. If a longer length is needed, do not
attempt to join two assemblies together.
Limitations of use – All Gripple hangers, accessories, and
other Gripple products must only be used for suspending items
recommended by the manufacturer.
Painting – If painting, ensure that a Gripple Décor Cover is
applied to the Gripple fastener before painting to protect from
the ingress of paint. Do not move the Gripple fastener on the
cable after painting.
Building codes – Compliance with local codes, and where
applicable national codes, is the buyer and/or installers
responsibility.
Not for re-use – Gripple hangers are designed for permanent
installations, not for re-use.
Lubricants Do not apply oil or any other lubricant to any part
of the assembly.
Not for seismic bracing – For Gripple products that have been
tested and approved for seismic restraint applications, please
refer to the Gripple Seismic product line.
Round duct/pipes – When wrapping around duct or other round
pipes, do not exceed an angle of 60 degrees between the top of
the pipe and the Gripple.
Environment Standard Gripple hangers may be used only in
dry locations. Stainless steel Gripple hangers may be used in
certain indoor corrosive environments such as properly
ventilated swimming pool arenas.
Failure to observe these usage instructions may result in
product malfunction, resulting in property damage and bodily
injury. At time of shipment Gripple products are warranted to
conform to the manufacturer's published specications and to
be free from defects in material and workmanship. No other
warranty, whether expressed or implied, including any
warranty of merchantability or tness for purpose, whether
expressed or implied, shall exist in connection with the sale or
use of any Gripple product.
C60 INST INSTR 08/10
For further technical assistance in the use of this Gripple suspension product, please contact:
Gripple Inc. 1611 Emily Lane Aurora, IL 60502 1-630-406-0600 www.gripple.com
JBL Professional
8500 Balboa Blvd
Northridge, CA 91329
USA
See Other Side for Speaker Installation Instructions


Produkt Specifikationer

Mærke: JBL
Kategori: Højttaler
Model: Control 68HP

Har du brug for hjælp?

Hvis du har brug for hjælp til JBL Control 68HP stil et spørgsmål nedenfor, og andre brugere vil svare dig




Højttaler JBL Manualer

JBL

JBL Stage 250 Manual

7 April 2025
JBL

JBL Conceal C62 Manual

7 April 2025
JBL

JBL Conceal C83 Manual

7 April 2025
JBL

JBL SCL-2 Manual

4 April 2025
JBL

JBL PRX935 Manual

25 Februar 2025
JBL

JBL PRX925 Manual

25 Februar 2025
JBL

JBL 4349 Manual

11 Januar 2025

Højttaler Manualer

Nyeste Højttaler Manualer