JBL Control 85M Manual

JBL Højttaler Control 85M

Læs gratis den danske manual til JBL Control 85M (7 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 53 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 27 anmeldelser. Har du et spørgsmål om JBL Control 85M, eller vil du spørge andre brugere om produktet?

Side 1/7
Twist the top part of the enclosure in a
clock-wise direction until it disengages
from the bottom part.
Lift o the top section.
Control 85M/88M Mushroom Landscape Speaker
Installation Instructions
12
Before nal assembly and installation of the Landsape speaker, it is important to prepare the installation site. The speaker is
designed to be able to sit below grade, with the lower half burried in the soil no deeper than the boundary point where the
two parts of the speaker meet. Another installation method is to place the speaker on the surface and use ground cover
materials to “berm up to the boundary between the two sections, being careful not to cover the ared waveguide in the upper
half of the speaker, or the speaker can be installed on the top surface of wooden decks or cement slabs. There are three
recessed pathways on the bottom of the speaker to allow for entrance and exit when using mutiple speakers on distributed
lines.
Anchoring the speaker for stability and security can be accomplished using after-market stakes placed through one, two or all
three pre-drilled holes located at the base of each of the legs on the bottom section.
The second gland nut can be installed by drilling a 22 mm
(7/8 in, 0.875 in) hole on the side of the bottom half of the
enclosure, in one of three recesses on the underside of the
enclosure, or other locations as needed, while taking care
that the location chosen does not interfere with the
locking parts so both halfs of the enclosure will mate and
close properly.
Attach one of the two included Gland Nuts into the open
hole on the seal plate as shown above.
Install the gland nut into the hole as shown
above in #6 and feed external wire from
outside through the gland nut and up through
the center hole in the lower half of the speaker
as shown above.
3
4
5
Close-up view of tap setting for the Control 85M and
Control 88M. **Adjusting tap setting required before
powering up system.
88M
85M
6
Continue to extend external wire up through the gland
nut installed on the seal plate and attach to pre-existing
wires from the top section of the speaker with included
gel-lled wire nuts.
7
** To achieve a watertight
seal with these gland nuts,
use only round jacketed
cable with outside diameter
(O.D.) between 4.0mm (0.16”)
and 9.0 mm (0.36”).
IMPORTANT: WIRE SIZE


Produkt Specifikationer

Mærke: JBL
Kategori: Højttaler
Model: Control 85M

Har du brug for hjælp?

Hvis du har brug for hjælp til JBL Control 85M stil et spørgsmål nedenfor, og andre brugere vil svare dig




Højttaler JBL Manualer

JBL

JBL Stage 250 Manual

7 April 2025
JBL

JBL Conceal C62 Manual

7 April 2025
JBL

JBL Conceal C83 Manual

7 April 2025
JBL

JBL SCL-2 Manual

4 April 2025
JBL

JBL PRX935 Manual

25 Februar 2025
JBL

JBL PRX925 Manual

25 Februar 2025
JBL

JBL 4349 Manual

11 Januar 2025

Højttaler Manualer

Nyeste Højttaler Manualer