JBL GSB8 Manual


Læs gratis den danske manual til JBL GSB8 (8 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 39 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 20 anmeldelser. Har du et spørgsmål om JBL GSB8, eller vil du spørge andre brugere om produktet?

Side 1/8
Installation Guide
GSB8 & GSB12 -In Ground Landscape Subwoofers
CAUTION: Installation must be done by qualified persons using safe
installation standards.
The installer is responsible for proper and selection and use of hardware to
install the speakers in a safe and durable manner.
Wire Connection
CABLE-- B - 1- - - s The GS speakers come with a captive multi conductor meter long cable with bare wire end for connection via an
external installer-provided weather proof - junction box.
o Connection Method Use professional wire nuts or other safe, long- term connectors that are appropriate for the
installation conditions and that are sized properly for wire gauge(s) and number of wires to be connected for the
together in the connector.
Important: Cut off all unused wires in a way that ensures that none of them will short to any of the
other wires.
Δ Code Requirements -- Typical wiring entails - -protected connections inside installer provided water
proof junction box, with cable entering junction box via water-tight fitting that is sized appropriately for
wire jacket diameter (see However, always wire in accordance with code requirements. below).
CABLE
BASE PLATE with TABS 4 x EDGE
CABINET
PORT CAP
PORT
HANDLES (x2)
o Color Connection Code
Low- Impedance (6, for GSB8 and GSB12)
Black N (- P = egative ) and Red = ositive (+)
High-Impedance (70V or 100V distributed systems):
Wiring Charts:
GSB8
Cable Wire Color
↓ Ω -For Low Z Input (6 )
Blue
N/C
Black
From Amp – (negative)
Black with White Stripe
N/C
Gray
N/C
Green
N/C
Yellow
N/C
Red
From Amp + (positive)
N/C = No Connection. Cut, insulate and tie
GSB12
Cable Wire Color
↓ Ω For -Low Z Input (6 )
Blue
N/C
Black
From Amp – (negative)
Black with White Stripe
N/C
Gray
N/C
Green
N/C
Yellow
N/C
Red
From Amp + (positive)
N/C = No Connection. Cut, insulate and tie
Instructions:
o For high- impedance systems (70V/100V), tie together Blue and Black and insulate
this connection.
o Common (negative from amplifier) = Black with white stripe
o GSB8 -- Positive (positive from amplifier):
Gray = 25W @ 70V or 50W @ 100V
Green = 50W @ 70V or 1 00W @100V
Yellow = 100W @ 70V ( )N/C at 100V
o GSB12 -- Positive (positive from amplifier):
Gray = 50W @ 70V or 100W @ 100V
Green = 100W @ 70V or 200W @100V
Yellow = 200W @ 70V (N/C at 100V)
o Wire Gauge – 4 The wire gauge is 1 AWG (approx. 1.6 mm2) , UL1569. The cable jacket diameter is 11 mm (0.43 in.).


Produkt Specifikationer

Mærke: JBL
Kategori: Højttaler
Model: GSB8

Har du brug for hjælp?

Hvis du har brug for hjælp til JBL GSB8 stil et spørgsmål nedenfor, og andre brugere vil svare dig