JBL L100 Classic MkII Manual

JBL Højttaler L100 Classic MkII

Læs gratis den danske manual til JBL L100 Classic MkII (2 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 11 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 6 anmeldelser. Har du et spørgsmål om JBL L100 Classic MkII, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

L100 Classic MkII

3-Way Bookshelf12-inch (300mm) Loudspeaker

Quick Start Guide

Overview

For more information on the set-up and operation of this

product refer to the product page on the jbl.com/specialty-audio/

website. Should further assistance be required feel free to

contact customer support at the numbers below.

Inside the US and Canada: +1 888.691.4171

Outside the US and Canada: +44 1707 668 012

Box Contents

1x L100 Classic Edition LoudspeakersMkII

2x Quadrex Foam Grilles

1x Quick Start Guide (This Document)

Placement and Positioning

●

Before deciding where to place your speakers, survey your room and think

about placement, using the illustration as a guide.

●

Avoid placing the speakers near power amplifiers, heat registers or other objects

that generate large amounts of heat.

●

Avoid placing speakers in humid or dusty locations.

●

Avoid placing speakers in direct sunlight or other intense light.

●

Refer to the illustration for distances from walls, between the speakers, and

angle to the listening position.

●

The speakers should be raised so that the tweeter is approximately at ear level.

The JS-120 or JS-150 speaker stand (sold separately) can be used to achieve

the proper listening height and angle.

●

Angle the speakers towards the listening position closer to the listeners ears for

a stronger center image and away from the listening position further from the

listeners ears for a more spacious image.

Specifications

Type: 12-inch (300mm) 3-way Bookshelf Loudspeaker

Low Frequency Driver: 12-inch (300mm) cast-frame Pure Pulp cone woofer with Dual

Spider (JW300SW-8)

Mid Frequency Driver:

5-1/4 inch (130mm) Polymer-coated, Pure Pulp cone

(JM125PC-8)

High Frequency Driver: 1-inch (25 mm) Titanium dome tweeter mated to acoustic lens

and wave guide (JT025Ti2-4)

Recommended

Amplifier Power:

25-200 Watts RMS

Impedance: 4 ohms

Loudspeaker Sensitivity: 90dB

Frequency Response: 40Hz-40kHz (-6dB)

Crossover Frequency: 450Hz, 3.5kHz

Finish:

Natural Walnut veneer with Black, Orange, or Blue Quadrex

Foam Grille

Dimensions (With Grille):

25. x 15.4 x 14. (6 mm x 389. mm x 3-inch -inch 4-inch 42.9 9

3 mm) 65.1

Controls: Attenuators for MF and HF Drivers

Input Type: Dual sets of Gold-plated Binding Posts

Product Weight (Each): 63

lb (2 kg) each8.6

Shipping Weight: 7

3 1 lb (33. kg) each

Shipping Units of Measure: Single Speaker

Recommended stand height: 7in (180mm)

Recommended Stand: JBL JS-120 or JS-150 (Sold Separately)

JBL L100 Classic MkII Quick Start Guide | Rev 3. 20230501 | Part No. 950-0624-0010

Pg 1 of 2

20in

(51cm)

20in

(51cm)

6ft (1.8mm) to

8ft (2.4mm)

Angle speaker to suit

listening preference.

See Postioning Bullet

Listening Position

40° to 60°

Wiring and Connections

IMPORTANT! Wiring Precautions

●

Ensure that the positive (+) and negative (-) bare wire or spades touch when connected to the binding posts as this will short out the amplifierDO NOT

channel.

●

Ensure that the appropriate polarity is maintained from amplifier to speaker to ensure proper phase for both speakers.

4 Post / Dual Sets of Binding Posts Terminal Wiring

Options

2- Wire Connections

Basic single-wire connection from amplifier.

We recommend using HF Positive and LF Negative.

B-Wire Connections

Two-wre connection from single amplifier.

Remove terminal straps before connecting.

Bi-Amp Connections

Two-wire connection from multiple amplifiers.

Remove terminal straps before connecting.

Positive + Red

Negative - Black

Positive + Red

Negative - Black

Positive + Red

Negative - Black

Controls and Adjustments

This speaker features level controls that can be used to adjust the level of

the mid-range driver and tweeter independently from the level of the woofer.

The default setting of 0dB represents a flat balance between all three drivers,

however in some cases there may be a need to adjust the level of the tweeter

and/or mid-range driver.

Mid Frequencies (MF Level) Adjustments

●

For rooms where the mid frequencies sound more forward, lower the

relative MF level by turning the knob counterclockwise..

●

For rooms where the mid frequencies require more presence, raise the

relative MF level by turning the knob clockwise.

High Frequencies (HF Level) Adjustments

●

For rooms where the high frequencies sound bright, lower the relative HF

level by turning the knob counterclockwise.

●

For rooms where the high frequencies sound dim, raise the relative HF

level by turning the knob clockwise.

JBL L100 Classic MkII Quick Start Guide | Rev 3.0 20230501 | Part No. 950-0624-001 | Features, Specifications, and Appearance subject to change without notice.

Harman International Industries, Incorporated.

8500 Balboa Blvd, Northridge CA 91329 United States.

European Representative: Harman International Industries, Incorporated.

EMEA Liaison Office, Danzigerkade 16G, 1013 AP Amsterdam, The Netherlands.

UK Business Address: Ground Floor, Westside 2, London Road, Apsley, Hemel Hempstead, Hertfordshire, HP3 9TD, United Kingdom.

JBL is a trademark of Harman International Industries, Incorporated registered in the United States and other countries.

Features, Specifications, and Appearance subject to change without notice.

Pg 2 of 2

MkII