Jensen CD1211 Manual


Læs gratis den danske manual til Jensen CD1211 (20 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 15 anmeldelser. Har du et spørgsmål om Jensen CD1211, eller vil du spørge andre brugere om produktet?

Side 1/20
CD1211
Owner's Manual
/
TUNE
CD1211 CD RECEIVER
SCAN
MONO
EQ
AUX IN
AM/FM/CD Receiver
CD1211
2
PREPARATION
Getting Started
Congratulations on your purchase of the Phase
Linear CD1211 Mobile AM/FM/CD Receiver. It’s
a good idea to read all of the instructions before
beginning the installation. We recommend
having your Phase Linear CD1211 installed by
a reputable installation shop.
Contents
Installation Instructions.............................. 3
Wiring ........................................................ 6
Operating Instructions ............................... 7
Tuner Operation ...................................... 10
CD Player Operation ............................... 12
Remote Control ....................................... 14
Care and Maintenance ............................ 15
Troubleshooting....................................... 16
Specifications .......................................... 17
Installation Requirements
This unit is designed for installation in cars,
trucks and vans with an existing radio opening.
In many cases, a special installation kit will be
required to mount the radio to the dashboard.
These kits are available at electronics supply
stores and car stereo specialty shops. Always
check the kit application before purchasing to
make sure the kit works with your vehicle. If you
need a kit but cannot locate one, call our
customer support line at 1-800-323-4815.
(U.S.A. and Canada only.)
Tools and Supplies
The following tools and supplies are needed to
install the radio.
Torx type, flathead and Philips screwdrivers
Wire cutters and strippers
Tools to remove existing radio (screwdriver,
socket wrench set or other tools)
Electrical tape
Crimping tool
Volt meter/test light
Crimp connections
18 gauge wire for power connections
16-18 gauge speaker wire
Speaker Requirements
Only connect speakers rated with a load
impedance of 4 ohms. Speakers with a load
impedance of less than 4 ohms could damage
the unit.
Disconnect Battery
Before you begin, disconnect the battery
negative terminal.
Toll-Free Installation Assistance
If you require assistance, contact Technical
Support at 1-800-323-4815 from 8:30 a.m. to
7:00 p.m. EST Monday through Friday and from
9:00 a.m. to 5:00 p.m. EST on Saturday.
(U.S.A. and Canada only.)


Produkt Specifikationer

Mærke: Jensen
Kategori: Ikke kategoriseret
Model: CD1211

Har du brug for hjælp?

Hvis du har brug for hjælp til Jensen CD1211 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Jensen Manualer

Jensen

Jensen CAR701-4 Manual

24 Oktober 2024
Jensen

Jensen BUCAM300J Manual

28 September 2024
Jensen

Jensen VM9114 Manual

20 September 2024
Jensen

Jensen CD1211 Manual

17 September 2024
Jensen

Jensen JC7DM Manual

28 August 2024
Jensen

Jensen VM9116 Manual

7 August 2024
Jensen

Jensen VM9115 Manual

5 August 2024
Jensen

Jensen SD1411 Manual

2 August 2024
Jensen

Jensen CD6112 Manual

27 Juli 2024
Jensen

Jensen SD1513 Manual

26 Juli 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer