Jensen VM9214BT Manual


Læs gratis den danske manual til Jensen VM9214BT (12 sider) i kategorien DVD afspiller. Denne vejledning er vurderet som hjælpsom af 41 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 21 anmeldelser. Har du et spørgsmål om Jensen VM9214BT, eller vil du spørge andre brugere om produktet?

Side 1/12
1
VM9214BT
VM9214BT Head Unit
Single DIN Sleeve
Wiring Harness
Parking Brake Sensor Extension Wire
Mounting Hardware
Cosmetic Trim Ring
3.5mm to 3.5mm Media Adaptor Cable
Owners Manual
Installation Guide
What’s in the Box
You will need these tools and supplies to install your VM9214BT:
Torx type, at-head and Philips screwdrivers
Wire cutters and strippers
Tools to remove existing radio (screwdriver, socket wrench set or other tools)
Electrical tape
Crimping tool
Volt meter/test light
Crimp connections
18 gauge wire for power connections
16 – 18 gauge speaker wire
Tools and Supplies
Installation Guide
Instruccionnes de Instalación
Instructions d’installation
WARNING! Never install this unit where operation and viewing could interfere with safe driving
conditions.
Para obtener instrucciones en Español, diríjase a la página 5. Pour des instructions en Francais, référez-vous à la page 9.
EJECT
A / V
INPUT
VM9214BT
DISP
M
U
T
E
2
TAB
DASHBOARD
DASHBOARD
TAB
Optional Equipment
NAV102: Allows you to access navigation features. All installation and operating instructions are included
with the navigation module.
Rear Camera
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to in-
stallation.
NOTE: If the VM9214BT is to be installed in a car equipped with an on-board drive or navigation computer, do
not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these
conditions, use extra caution during installation to avoid causing a short circuit.
Pre-installation
Remove the four screws that attach the mounting sleeve to the
radio and remove the sleeve.
Install the mounting sleeve.
a. Install mounting sleeve into the dashboard or optional
adapter. Do not force the sleeve into the opening or cause
it to bend or bow.
b. Locate the series of bend-tabs along the top, bottom and
sides of the mounting sleeve. With the sleeve fully insert-
ed into the dashboard opening, bend as many of the tabs
outward as necessary so that the sleeve is rmly secured
to the dashboard.
c. Install support strap to make the unit more stable.
Place the radio in front of the dashboard opening so the wiring
can be brought through the mounting sleeve.
CAUTION! Be careful not to damage the car wiring.
1
2
3


Produkt Specifikationer

Mærke: Jensen
Kategori: DVD afspiller
Model: VM9214BT

Har du brug for hjælp?

Hvis du har brug for hjælp til Jensen VM9214BT stil et spørgsmål nedenfor, og andre brugere vil svare dig




DVD afspiller Jensen Manualer

Jensen

Jensen CDR5620 Manual

19 September 2024
Jensen

Jensen VM9214BT Manual

24 Juli 2024
Jensen

Jensen VM9424 Manual

21 Juli 2024
Jensen

Jensen CDR6221 Manual

14 Maj 2023
Jensen

Jensen CDR7011 Manual

22 Februar 2023

DVD afspiller Manualer

Nyeste DVD afspiller Manualer