JK Audio RemoteAmp Manual

JK Audio Øreprop RemoteAmp

Læs gratis den danske manual til JK Audio RemoteAmp (4 sider) i kategorien Øreprop. Denne vejledning er vurderet som hjælpsom af 39 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 20 anmeldelser. Har du et spørgsmål om JK Audio RemoteAmp, eller vil du spørge andre brugere om produktet?

Side 1/4
RemoteAmp
Headphone / Earpiece Amplifier
JK Audio
User Guide
2
Input
The input XLR accepts line level signals from your mixer,
distribution amplifier or phone line hybrid. The balanced
input XLR is wired:
Pin 1 Ground
Pin 2 Signal +
Pin 3 Signal -
This is a transformer balanced input. If you are using an
unbalanced source, you must connect your signal lead to
pin 2 and then connect your ground to pins 1 and 3. Do
not connect a powered input to this device.
Output
The 1/8” earpiece jack is current limited to prevent exces-
sive signals into your earpiece. This mono jack will power
earpieces with an impedance of 150 ohms or greater. If
you would like to use light-weight stereo headphones that
are typically 8 to 36 ohms, wired with a 1/8" stereo jack,
you will need to use an adapter to plug into the 1/4" stereo
headphone jack. Or you can solder a jumper wire across
the top of the 150 ohm resistor, R2.
The 1/4” headphone jack is wired for either a stereo or
mono plug. If a stereo headphone plug is used, you will
hear signal in both the left and right ears.
A 1/4" mono plug can also be used without any problem,
however, if you plan to always use a 1/4" mono plug, you
might consider a simple modification to the RemoteAmp.
Description


Produkt Specifikationer

Mærke: JK Audio
Kategori: Øreprop
Model: RemoteAmp

Har du brug for hjælp?

Hvis du har brug for hjælp til JK Audio RemoteAmp stil et spørgsmål nedenfor, og andre brugere vil svare dig