Jonard Tools RJ11 Manual


Læs gratis den danske manual til Jonard Tools RJ11 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 47 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 24 anmeldelser. Har du et spørgsmål om Jonard Tools RJ11, eller vil du spørge andre brugere om produktet?

Side 1/1
Tel Fax jonard.com 914.793.0700 | 914.793.4527 |
Premier Tool Manufacturer Since 1958
Instructions - RJ11-100 | Data Sheet
Instructions:
1. Cut the telephone cable where you want to terminate the cable
2. Strip the telephone cable’s jacket about 1” long, exposing the internal wires
3. Separate the wires inside and order them black, red, green, then yellow, while the RJ11 connector’s tab is on the
bottom
4. Insert the wires through the connector so they are sticking out the other end & the wedge of the connector is
contacting the jacket of the cable
5. Insert the wired connector fully into the pass-through RJ11 slot of a crimping tool so that the wires at the end of
the connector are sticking out
6. Squeeze the handles of the tool to crimp the connector and flush cut the ends of the wires


Produkt Specifikationer

Mærke: Jonard Tools
Kategori: Ikke kategoriseret
Model: RJ11

Har du brug for hjælp?

Hvis du har brug for hjælp til Jonard Tools RJ11 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Jonard Tools Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer