JUNG BTCLS-DISP Manual

JUNG Skærm BTCLS-DISP

Læs gratis den danske manual til JUNG BTCLS-DISP (4 sider) i kategorien Skærm. Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om JUNG BTCLS-DISP, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Safety instructions

Electrical equipment must only be installed and assembled by qualied electricians. Failure to comply with these instructions may result in damage to the device,

re or other hazards. This product is only intended for use in dry rooms.

These instructions are an integral part of the product and must remain with the end customer.

DANGER!

Electrical shock when live parts are touched. An electric shock can be fatal.

Operation

The lower half of the cover is used for operation. All operations are made via 8 sensor buttons. In standby mode the buttons are hidden and are displayed each

time you touch the lower area.

Switching on / Switching o

The Bluetooth Connect is switched on and o here (standby).

Note: After switching on, the Bluetooth Connect connects automatically to the last audio source if it can be reached. If the source is not available, e.g. because it is

not within range, the next audio source is connected. The Bluetooth Connect attempts to reach the taught-in audio sources in the sequence they were taught in.

While searching for the connection, the button illumination dims brighter and darker. The playback starts automatically depending on the device type / device

software.

Adjusting the volume

The volume is adjusted using the buttons. The Bluetooth Connect always starts with the volume that was last adjusted.

Teaching in the audio source

With a press of a button, the Bluetooth Connect switches to the learn mode and is then visible for a maximum of 30 seconds for audio players with an integrated

Bluetooth interface (e.g. smartphone or MP3 player). A connection can now be established via such a device and it can be taught in on the Bluetooth Connect.

Note: During the 30 seconds, the buttons will ash until the connection has been established.

In some operating systems, a device that has previously been taught-in can only be taught-in again if the existing connection was deleted in this device.

Selecting the audio source

With a long press of a button (> 2 s) the connection to the next taught-in and accessible audio source is established. Afterwards, the playback is started.

The search is indicated by dimming the button illumination brighter and darker. This procedure can last up to 40 seconds depending on the number of the taught-in

devices.

Selecting a track

The last/next track can be selected by a brief press of a button. The track sequence corresponds to the order of the audio source.

The sequence can normally be dened there according to albums, artists, genre or playlists.

Operating instructions

Description of device

The JUNG Bluetooth Connect BTC… consists of an operating cover and a ush-mounted power supply.

The audio source (e.g. smartphone or MP3 player) is connected and the device is operated via the operating cover.

The device is operated and set up via 8 sensor buttons.

The connections for mains voltage, loudspeakers and audio output are available on the power supply unit.

The Bluetooth Connect can be operated with one or two loudspeaker modules LSM….

The music signal is transmitted via Bluetooth, amplied internally and output to loudspeakers or an external amplier.