Kendall Howard 5500-3-004-35 Manual

Kendall Howard Tabel 5500-3-004-35

Læs gratis den danske manual til Kendall Howard 5500-3-004-35 (2 sider) i kategorien Tabel. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Kendall Howard 5500-3-004-35, eller vil du spørge andre brugere om produktet?

Side 1/2
®
Tools Needed:
Step 1:
Step 2:
Step 3:
Screwdriver
What’s Included:
QTY 1: Right
Leg Assembly
QTY 1: Le
QTY 1: Modesty
Panel
QTY 1: Table Top
QTY 4:
Levelers
QTY 4:
End Caps
QTY 1: Modesty
Panel Grommet
QTY 1:
Surface
Grommet
QTY 25:
1/4-20”
Screws
Step 4:
A. Posion table top with smooth surface facing down.
B. -Line up leg assemblies with pre drilled hole paern.
(Note: Shorter side of legs face back of the table.)
C. - Fasten to table top with 1/4 20” screws.
*If installing the Cable Management Enclosure, leave out
the back two screws in the legs.
A. Aach modesty panel to the back edge of the right and le
leg assemblies. (Ensure the grommet opening is closest to
the work surface.)
B. - Fasten with 1/4 20” screws.
*If not installing the Cable Management Enclosure, ll in
addional threaded holes in modesty panel with addional
screws.
*If installing the
Cable Management
Enclosure, proceed
to mount that to the
modesty panel
before assembling
the panel to the
training table.
A. Insert levelers into the threaded inserts in the boom
of the leg assemblies.
B. Insert end caps into base of each leg.
A. Set the training table height on each leg assembly by
unscrewing and sliding the leg to the desired posion.
B. Re- insert screws to secure.


Produkt Specifikationer

Mærke: Kendall Howard
Kategori: Tabel
Model: 5500-3-004-35

Har du brug for hjælp?

Hvis du har brug for hjælp til Kendall Howard 5500-3-004-35 stil et spørgsmål nedenfor, og andre brugere vil svare dig