Kenwood KRK-10 Manual

Kenwood Radio KRK-10

Læs gratis den danske manual til Kenwood KRK-10 (25 sider) i kategorien Radio. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Kenwood KRK-10, eller vil du spørge andre brugere om produktet?

Side 1/25
CABLE
INSTRUCTION MANUAL
PRECAUTIONS
• The following product is exclusively for use with transceivers.KENWOOD
• To prevent possible accidents and damages, do not attempt to use this product with
other types of transceivers.
ABOUT PRODUCT
USB PROGRAMMING INTERFACE CABLE
• This product is the cable to connect transceivers and the PC.KENWOOD
• Install the UART driver or USB driver from the supplied CD to the PC.
PROGRAMMING INTERFACE CABLE
• This product is the cable to connect transceivers and the PC.KENWOOD
FILTERED CIGARETTE LIGHTER CORD
• The cigarette lighter cable allows you to supply power to your transceiver
from the cigarette lighter of your automobile.
• The cigarette lighter cable is equipped with a 2 A fuse. When the fuse
blows, replace it with a fuse of the same rating.
To cigarette
lighter socket To transceiver
3.4 mm
Fuse (2A)
CAUTION:
12 V DC ONLY
Serious damage may result to your transceiver if this cable is connected to a voltage
source greater than 16 V. Some vehicles have battery voltages of 24 V or greater.
REMOTE CONTROL KIT
• These products are the connection cable kits for installing the operation
panel of KENWOOD mobile transceivers separately.
B5A-1082-00
© 2015
CABLE
MODE D'EMPLOI
PRÉCAUTIONS
• Le produit suivant doit uniquement être utilisé avec les émetteurs-récepteurs
KENWOOD.
• Pour éviter tout dommages et accidents potentiels, n'essayez pas d'utiliser ce produit
avec d'autres types d'émetteurs-récepteurs.
À PROPOS DU PRODUIT
CÂBLE D'INTERFACE DE PROGRAMMATION USB
• Ce produit est un câble permettant de connecter les émetteurs-récepteurs
KENWOOD aux ordinateurs.
• Installez le pilote UART ou le pilote USB sur l'ordinateur à partir du CD fourni.
CÂBLE D'INTERFACE DE PROGRAMMATION
• Ce produit est un câble permettant de connecter les émetteurs-récepteurs
KENWOOD aux ordinateurs.
CORDON ALLUME-CIGARES
• Le cordon allume-cigares vous permet d'alimenter votre émetteur-récepteur
à partir de l'allume-cigare de votre voiture.
• Le cordon allume-cigare est muni d'un fusible 2 A. Quand le fusible grille,
remplacez-le avec un fusible de même valeur.
À la douille
allume-cigare À l'émetteur-récepteur
3,4 mm
Fusible (2A)
ATTENTION :
12 V CC UNIQUEMENT
L'émetteur-récepteur peut être endommagé si ce cordon est connecté à une source de
tension de plus 16 V. Certains véhicules ont une batterie d'une tension de 24 V ou plus.
KIT TÉLÉCOMMANDE
• Ce produit est un kit de connexion permettant d'installer un panneau de
commande pour émetteur-récepteur séparé.KENWOOD
B5A-1082-00
© 2015


Produkt Specifikationer

Mærke: Kenwood
Kategori: Radio
Model: KRK-10

Har du brug for hjælp?

Hvis du har brug for hjælp til Kenwood KRK-10 stil et spørgsmål nedenfor, og andre brugere vil svare dig