Kenwood NXR-710 Manual

Kenwood Radiokommunikation NXR-710

Læs gratis den danske manual til Kenwood NXR-710 (16 sider) i kategorien Radiokommunikation. Denne vejledning er vurderet som hjælpsom af 35 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 18 anmeldelser. Har du et spørgsmål om Kenwood NXR-710, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
◆ Government law prohibits the operation of unlicensed radio
transmitters within the territories under government control.
◆ Illegaloperationispunishablebyneand/orimprisonment.
◆ Referservicetoqualiedtechniciansonly.
◆ Thisrepeaterisintendedforuseasaxedbasestationwith
the antenna located outdoors on the rooftop or on an antenna
tower.
◆ This repeater is designed for a 13.2 V DC power source!
Never use a 24 V DC or higher source to power the repeater.
◆ Use only the supplied DC cord.
◆ Do not remove the ferrite core attached to the DC cord. Doing
so may cause interference with radio communications.
THANK YOU!
We are grateful you purchased this Kenwood repeater. We
believe this easy-to-program repeater will be highly effective in
your communications system, and will keep personnel operating
atpeakefciency.
PRECAUTIONS
• Donotexposetheunittorainormoisture;topreventreor
electric shock.
• Donotopentheunitunderanycircumstances;toavoidrisk
of electric shock.
• Donotexposetheunittolongperiodsofdirectsunlight,nor
place it close to heating appliances.
• Donotplacetheunitinexcessivelydustyand/orhumid
areas, nor on unstable surfaces.
• If you detect an abnormal odor or smoke coming from the
unit, disconnect the power from the unit immediately. Contact
your Kenwood service center or dealer.
NOTICES TO THE USER
The AMBE+2TM voice coding Technology embodied in this product
is protected by intellectual property rights including patent rights,
copyrights and trade secrets of Digital Voice Systems, Inc. This voice
coding Technology is licensed solely for use within this Communications
Equipment.TheuserofthisTechnologyisexplicitlyprohibitedfrom
attemptingtoextract,remove,decompile,reverseengineer,or
disassemble the Object Code, or in any other way convert the Object
Code into a human-readable form. U.S. Patent Nos. #5,870,405,
#5,826,222, #5,754,974, #5,701,390, #5,715,365, #5,649,050,
#5,630,011, #5,581,656, #5,517,511, #5,491,772, #5,247,579, #5,226,084
and #5,195,166.
Firmware Copyrights
Thetitletoandownershipofcopyrightsforrmwareembeddedin
Kenwood product memories are reserved for Kenwood Corporation.
UNPACKING AND CHECKING EQUIPMENT
Note: The following unpacking information is for use by your Kenwood
dealer, an authorized Kenwood service center, or the factory.
Carefully unpack the repeater. We recommend that you identify
the items listed in the following table before discarding the
packing material. If any items are missing or have been damaged
duringshipment,leaclaimwiththecarrierimmediately.
Item Part Number Quantity
Hardwarexture J21-8559-XX 1
Front glass B10-2635-XX 1
Name plates B11-1259-XX 1
Cushion G13-1801-XX 4
Cushion G13-1802-XX 4
Foot J02-0475-XX 2
Foot J02-0492-XX 2
Grommet J59-0302-XX 2
Handle K01-0418-XX 1
Screws N30-4006-XX 2
Screws N35-3006-XX 5
DC cord E30-3427-XX 1
Lead wire with connector (15 pin) E31-3228-XX 1
Fuse F05-1537-XX 1
Instruction Manual B62-2200-XX 1
INSTALLATION
To install the handles onto the front panel of the repeater, align
the handles with the holes on the front panel, then secure the
handles using the supplied screws.
Please consult your dealer for installing the repeater and
antenna.
MICROPHONE
Connect an optional KMC-30, KMC-35, KMC-27A, KMC-27B,
or KMC-9C Kenwood microphone to the MIC jack on the front
panel.
NOTIFICATION
This equipment complies with the essential requirements of Directive
1999/5/EC.
The use of the warning symbol means the equipment is subject to
restrictions of use in certain countries.
This equipment requires a licence and is intended for use in the
countries as below.
AT BE DK FI FR DE GR IS
IE IT LI LU NL NO PT ES
SE CH GB CY CZ EE HU LV
LT MT PL SK SI BG RO
ISO3166
© B62-2200-00 (E)
09 08 07 06 05 04 03 02 01 00
VHFDIGITALBASE-REPEATER/UHFDIGITALBASE-REPEATER
INSTRUCTION MANUAL
NXR-710/NXR-810
Information on Disposal of Old Electrical and Electronic Equipment and
Batteries (applicable for EU countries that have adopted separate waste
collection systems)
Products and batteries with the symbol (crossed-out wheeled bin) cannot
be disposed as household waste.
Old electrical and electronic equipment and batteries should be recycled at
a facility capable of handling these items and their waste byproducts.
Contact your local authority for details in locating a recycle facility nearest
to you.
Proper recycling and waste disposal will help conserve resources whilst
preventing detrimental effects on our health and the environment.
Notice: The sign "Pb" below the symbol for batteries indicates that this
battery contains lead.
REPEATER OPERATION
Note: Please consult your dealer for programming the repeater.
When power is applied to the unit, the POWER indicator lights:
・ Green when using the DC jack.
Rotate the VOLUME control to adjust the audio.
The BUSY indicator lights green while receiving a signal and the
TX indicator lights red while transmitting.
■ Rear Panel
q TX OUT jack
ConnectaTXantennaoraduplexertothisreceptacle.
w CONTROL I/O jack
Connect a repeater controller or a remote panel to this
DB-25 interface.
e REF IN jack
Connecttoa10MHzexternaloscillator.
r RX IN jack
ConnectanRXantennaoraduplexertothisBNC
receptacle.
CONTROLS AND FUNCTIONS
■ Front Panel
qwr
y
u
i
o
e
t FUSE
Insert 15 A blade fuse into this fuse holder.
y DC 13.2V jack
Connect a 13.2 V DC power supply to this jack.
u N SYNC 1 / 2 jack
This jack is currently not used. Future functions include
connecting another repeater or optional device.
i TEST/SPKR jack
Testinput/outputjack.Connectanexternalspeakerto
this jack.
TRANSCEIVER OPERATION
■ Receive
Adjust the volume to your desired level. You may need to
readjust the volume if you are having interference while
receiving a message from your dispatcher or another member
inyoureet.
The BUSY indicator lights green while a signal is being
received.
■ Transmit
1 Listen to the channel before transmitting, to make sure it
is not being used.
2 Press the microphone PTT switch, then speak in your
normal speaking voice.
The TX indicator lights red while transmitting.
3 Whenyounishspeaking,releasethePTT switch.
q Speaker
w CH/STATUS Display
Two 7-segment digits display the channel number, name,
or status.
e VOLUME control
Rotate to adjust the audio.
r POWER switch
t POWER indicator
Lights green when power is supplied to the DC 13.2V
jack.
y MIC jack
Connect a microphone to this 8-pin modular jack.
u Programmable Function keys
Press these keys to activate their programmable
functions.
i BUSY indicator
Lights green while a signal is being received.
o TX indicator
Lights red while transmitting.
CH/STATUS
VOLUME
BUSY
TX POWER
MIC
N SYNC
REF IN RX IN
TX OUT CONTROL
I/O
TEST/SPKR
DC 13.2V
FUSE 15A
t
qwrt
y
u
e
i

Produkt Specifikationer

Mærke: Kenwood
Kategori: Radiokommunikation
Model: NXR-710

Har du brug for hjælp?

Hvis du har brug for hjælp til Kenwood NXR-710 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Radiokommunikation Kenwood Manualer

Kenwood

Kenwood NX-3320 Manual

8 Juli 2024
Kenwood

Kenwood TH-K40E Manual

8 Juli 2024
Kenwood

Kenwood TK-3401D Manual

6 Juli 2024
Kenwood

Kenwood TM-D710GA Manual

6 Juli 2024
Kenwood

Kenwood TK-2160 Manual

6 Juli 2024
Kenwood

Kenwood TK-7360 Manual

5 Juli 2024
Kenwood

Kenwood NXR-800 Manual

5 Juli 2024
Kenwood

Kenwood NX-1300-E2 Manual

5 Juli 2024
Kenwood

Kenwood TK3202E Manual

5 Juli 2024
Kenwood

Kenwood TK-2400 Manual

5 Juli 2024

Radiokommunikation Manualer

Nyeste Radiokommunikation Manualer

President

President Harry III Manual

15 Januar 2025
President

President Johnson Manual

15 Januar 2025
President

President MPB-12000 Manual

15 Januar 2025
President

President Jackson II Manual

14 Januar 2025
President

President Jimmy Manual

14 Januar 2025
President

President EMPEROR NINJA Manual

14 Januar 2025
President

President James Manual

14 Januar 2025
Rexon

Rexon RM-03N Manual

20 September 2024
Simrad

Simrad RS8400 Shipmate Manual

17 September 2024
Intek

Intek MT-5050 Manual

25 August 2024