Kicker KMA600.1 Manual

Kicker Modtager KMA600.1

Læs gratis den danske manual til Kicker KMA600.1 (10 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 35 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 18 anmeldelser. Har du et spørgsmål om Kicker KMA600.1, eller vil du spørge andre brugere om produktet?

Side 1/10
KMA600.1
Manual del Propietario | Español
AMPLIFICADOR DEL LA SERIE KMA.1
Benutzerhandbuch | Deutsch
MONOVERSTÄRKER DER KMA.1-SERIE
Manuel d’utilisation | Française
AMPLIFICATEUR DE SÉRIE KMA.1
KMA
AMPLIFIERS
Owner’s Manual
2
KMA.1-SERIES AMPLIFIERS
OWNER’S MANUAL
INSTALLATION
Mounting: Choose a dry, structurally sound location to mount your KICKER amplifi er. Make sure there
are no items behind the area where the screws will be driven. Choose a location that allows at least 4”
(10cm) of open ventilation for the ampli er. Drill four holes using a 7/64 (3mm) bit and use the supplied
#8 screws to mount the ampli er.
Wiring: The KMA ampli ers RCA inputs will receive either high or low level signals from your source
unit. A high-level signal can be run from the source unit’s speaker outputs to the stereo RCA input on the
end panel of the ampli er using the KICKER KISL as shown (see page 3). Alternatively, the signal can be
delivered to the ampli er using the low-level RCA outputs on the source unit. Keep the audio signal cable
away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it at a
90 degree angle.
PERFORMANCE
MODEL: KMA600.1
IMPORTANT SAFETY WARNING
PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER, OR SUBWOOFER IN A DISTORTED, CLIPPED
OR OVER-POWERED MANNER CAN CAUSE YOUR AUDIO SYSTEM TO OVERHEAT, POSSIBLY CATCHING FIRE
AND RESULTING IN SERIOUS DAMAGE TO YOUR COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO
4 INCHES (10CM) OPEN VENTILATION. SUBWOOFERS SHOULD BE MOUNTED WITH AT LEAST 1 INCH (2.5CM)
CLEARANCE BETWEEN THE FRONT OF THE SPEAKER AND ANY SURFACE.
Model: KMA600.1
RMS Power
@ 14.4V, 4Ω mono, 1% THD+N
@ 14.4V, 2Ω mono, 1% THD+N
300W x 1
600W x 1
Length [in, cm] 8-1/16, 20.5
Height [in, cm] 2-5/16, 5.9
Width [in, cm] 7-1/8, 18
Frequency Response ± 1dB 25Hz-200Hz
Signal-to-noise Ratio >95dB, A-weighted, re: rated power
Input Sensitivity Low Level: 125mV–5V
High Level: 250mV10V
Electronic Crossover Variable Lo-pass 50Hz–200Hz, 12dB/octave
KickEQ™ Bass Boost 0-12dB @ 40Hz
Subsonic Filter 25Hz, 24dB/octave
Remote Bass Yes


Produkt Specifikationer

Mærke: Kicker
Kategori: Modtager
Model: KMA600.1

Har du brug for hjælp?

Hvis du har brug for hjælp til Kicker KMA600.1 stil et spørgsmål nedenfor, og andre brugere vil svare dig