Kicker KXMA800.8 Manual

Kicker Modtager KXMA800.8

Læs gratis den danske manual til Kicker KXMA800.8 (13 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 52 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 26.5 anmeldelser. Har du et spørgsmål om Kicker KXMA800.8, eller vil du spørge andre brugere om produktet?

Side 1/13
KXMA800.8
Manual del Propietario | Español
AMPLIFICADOR DEL LA SERIE KXM.8
Benutzerhandbuch | Deutsch
VERSTÄRKER DER KXM.8-SERIE
Manuel d’utilisation | Française
AMPLIFICATEUR DE SÉRIE KXM.8
KXM
AMPLIFIERS
Owner’s Manual
2
KXM.8 SERIES AMPLIFIERS
OWNER’S MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER ampli er. Make sure there are no
items behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm)
of open ventilation for the ampli er. If possible, mount the amplifi er in the climate-controlled passenger
compartment. Drill four holes using a 7/64” (3mm) bit and use the supplied #8 screws to mount the
ampli er.
Wiring: The KXM ampli ers RCA inputs will receive either high or low level signals from your car stereo’s
source unit. A high-level signal can be run from the source unit’s speaker outputs to the stereo RCA
input on the end panel of the ampli er using the KICKER KISL as shown. Alternatively, the signal can be
delivered to the ampli er using the low-level RCA outputs on the source unit. Keep the audio signal cable
away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it at a
90 degree angle.
PERFORMANCE
MODEL: KXMA800.8
IMPORTANT SAFETY WARNING
PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER, OR SUBWOOFER
IN A DISTORTED, CLIPPED OR OVER-POWERED MANNER CAN CAUSE YOUR AUDIO
SYSTEM TO OVERHEAT, POSSIBLY CATCHING FIRE AND RESULTING IN SERIOUS
DAMAGE TO YOUR COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO 4
INCHES (10CM) OPEN VENTILATION. SUBWOOFERS SHOULD BE MOUNTED WITH AT
LEAST 1 INCH (2.5CM) CLEARANCE BETWEEN THE FRONT OF THE SPEAKER AND ANY
SURFACE.
Model: KXMA800.8
RMS Power
@ 14.4V, 4 stereo, 1% THD+N
@ 14.4V, 2 stereo, 1% THD+N
@ 14.4V, 4Ω mono, ≤ 1% THD+N
50 x 8
100 x 8
200 x 4
Length [in, cm] 14-3/4, 37.4
Specifi cations common to all models:
Height [in, cm] 2-1/8, 5.5
Width [in, cm] 8-5/16, 21
Frequency Response [Hz] 10Hz–20kHz
Signal-to-Noise Ratio [dB] 95dB
Input Sensitivity 250mV–10V
Selectable Electronic Crossover Off; Variable HP, 10–500Hz; Variable LP, 40–500Hz; 400Hz–
5,000Hz with 10X Switch (bandpass capable); Slope: 24dB/
octave"
KickEQ™ Bass Boost 0–18dB @ 40Hz


Produkt Specifikationer

Mærke: Kicker
Kategori: Modtager
Model: KXMA800.8

Har du brug for hjælp?

Hvis du har brug for hjælp til Kicker KXMA800.8 stil et spørgsmål nedenfor, og andre brugere vil svare dig