Kramer T10F-22M Manual

Kramer Ikke kategoriseret T10F-22M

Læs gratis den danske manual til Kramer T10F-22M (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om Kramer T10F-22M, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

The T10F 22MKramer - Inner Frame

Congratulations on purchasing your Kramer Inner Frame for the T10F 22M- TBUS-10XL Table

Connection bus.

The includesT10F 22M- Inner Frame :

• An opening for 1 - SID X1 or other MegaTOOL

• 2 s power socket opening

• 1 blank insert

• 1 pass through

insert

Note that you can install the optional T-2INSERT (P/N: 80-00006699) inside

a single power socket opening.

Figure 22M1 -: T10F - ) Inner Frame (P/N: 80 000028

Installing the Wall Plate Inserts

Before installing the inner frame, you need to wall plate insertsinstall .

Go to to check for uphttp://www.kramerelectronics.com - -to date user

manuals and the omplete list of Kramer wall plate and module c inserts

connectors.

You can rearrange or remove any of the blank inserts mounted on the inner frame and replace

them with Kramer wall or connector modules for interfacing A/V type signals. plate inserts

To mount a Kramer insert or connector module:

1. Unscrew the two screws that fasten the blank insert to the inner frame and remove the

blank insert.

2. Place the required Kramer wall plate insert over the opening, insert the two screws to fix

the Kramer insert in place, and tighten them.

Installing the -SID X1 or other MegaTOOL

To install , as shown inthe SID-X1 Figure 2:

1. Fasten each of the supplied TOOL brackets to their location (one on each side).

2. Insert the SID-X1, from underneath, through the MegaTOOL opening.

3. . Fasten the screws (one on each side) through the inner frame holes and TOOL brackets

Figure 2 : Installing the SID-X1

Installing the Inner Frame

To install the inner frame:T10F 22M-

1. Place the assembled inner frame inside the TBUS-10XL enclosure.

2. Set the required height using your fingers to bring the inner frame to the desired position,

and then screw and tighten it in place using the height adjustment screws supplied with the

inner frame.

Connecting the Cables

When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and so on):

1. Insert the cables to their appropriate connectors from underneath.

2. . Secure the cables to the tie holes on the TBUS-10XL

Do not secure the cables too tightly or too loosely. Leave a small amount of slack.

After the is connected to mains power and the proper cables, it is ready for use.TBUS-10XL

Adjusting the Height of the Inner Frame

If needed, you can adjust the possible heights to accommodate inner frame to several one of the

large or bulky cables. To adjust, perform the following:

1. Remove the height adjustment screws, while supporting the frame from underneath with

your fingers.

2. Raise or lower the connecting surface to the required height, insert the screws, and tighten

them in place.

K R A M E R ELE C T R O N I C S LT D .

Installation

Instructions

MODEL:

T10F 22M-

Inner Frame

For the latest information on our products and a list of Kramer

distributors, visit our Web site where updates to this user manual may be

found.

We welcome your questions, comments, and feedback.

Web site: www.kramerelectronics.com

E-mail: info@kramerel.com

P/N: 2900-300 Rev 225 1

P/N:

2900- 300225

Rev:

SAFETY WARNING

Disconnect the unit from the power

supply before opening and servicing

Produkt Specifikationer

Mærke:	Kramer
Kategori:	Ikke kategoriseret
Model:	T10F-22M

Har du brug for hjælp?

Hvis du har brug for hjælp til Kramer T10F-22M stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Kramer Manualer

Kramer VP-8x8AK Manual

22 Juli 2025

Kramer VP-41 Manual

22 Juli 2025

Kramer VA-1VGAN Manual

22 Juli 2025

Kramer VA-1DVIN Manual

22 Juli 2025

Kramer VP-88K Manual

21 Juli 2025

Kramer RK-KVM-1U-FLANGE Manual

21 Juli 2025

Kramer SL-280 Manual

21 Juli 2025

Kramer RC-306 Manual

21 Juli 2025

Kramer VP-8x8TP Manual

21 Juli 2025

Kramer VS-84HN Manual

21 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Netter Vibration NEG 50200 Manual

17 August 2025

D-Link DCS-34-3 Manual

17 August 2025

MSW -PU-30 Manual

17 August 2025

MSW -PLO-375 Manual

17 August 2025

YA-MAN Photo PLUS Shiny Manual

17 August 2025

Mueller SC 28.23 pro4 Manual

17 August 2025

Kenmore PM1010 Manual

17 August 2025

Ecler VEO-XRI2L Manual

17 August 2025

Mueller SC 98.10 pro4 Manual

17 August 2025

Mueller SC 93.20 pro Manual

17 August 2025