Lancom AirLancer IN-H180 Manual

Lancom Ikke kategoriseret AirLancer IN-H180

Læs gratis den danske manual til Lancom AirLancer IN-H180 (5 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 21 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 11 anmeldelser. Har du et spørgsmål om Lancom AirLancer IN-H180, eller vil du spørge andre brugere om produktet?

Side 1/5
LANCOM Antenna
AirLancer IN-H180
MOUNTING INSTRUCTIONS
Preparation for wall- and ceiling mounting
Use the antenna as a drilling template to mark out the
drill holes for wall- or suspended ceiling mounting. The
horizontal and vertical separation of the adjacent holes is
104mm.
For ceiling mounting, if required, drill a hole into the center
of the ceiling board to feed-through the connector cables.
Alternatively, you can use the integrated cable duct on the
antenna backside to lead the cables sideways.
Size of the drill holes
Using the markings as a guide, drill the holes and insert
dowels for wall mounting, if appropriate. Depending on the
surface material the required size of the holes may vary.
Mounting the antenna
1. Ceiling board mounting with screws and nuts
Included: 4 thread screws 30 mm, 4 washers, 4 nuts
From the frontside, stick the thread screws through the
appropriate holes of the antenna housing and the previ-
ously drilled holes of the ceiling board. Place the washers on
the screws from the backside of the ceiling board. Finally,
use the nuts for fixing.


Produkt Specifikationer

Mærke: Lancom
Kategori: Ikke kategoriseret
Model: AirLancer IN-H180

Har du brug for hjælp?

Hvis du har brug for hjælp til Lancom AirLancer IN-H180 stil et spørgsmål nedenfor, og andre brugere vil svare dig