Laney Ironheart IRT120H Manual

Laney Ikke kategoriseret Ironheart IRT120H

Læs gratis den danske manual til Laney Ironheart IRT120H (20 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Laney Ironheart IRT120H, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/20

IRT120H

IRT120HIRT120H

IRT60H

IRT60HIRT60H

WARNING: When using electrical products, basic cautions should always be followed, including the following:

1. Read these instructions.

2. Keep these instructions safe.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any of the ventilation openings. Install in accordance with manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding

prong. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the

obsolete outlet.

10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus.

11. Only use attachments/accessories provided by the manufacturer.

12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when

moving the cart/apparatus combination to avoid injury from tip-over.

13.

Unplug this apparatus during lightning storms

or when unused for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as when power-supply

cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not

operate normally, or has been dropped.

15. Never break off the ground pin. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord.

16. If this product is to be mounted in an equipment rack, rear support should be provided.

17. Note for UK only: If the colours of the wires in the mains lead of this unit do not correspond with the terminals in your plug‚ proceed as follows:

a) The wire that is coloured green and yellow must be connected to the terminal that is marked by the letter E‚ the earth symbol‚ coloured green or

coloured green and yellow.

b) The wire that is coloured blue must be connected to the terminal that is marked with the letter N or the colour black.

c) The wire that is coloured brown must be connected to the terminal that is marked with the letter L or the colour

red.

18.This electrical apparatus should not be exposed to dripping or splashing and care should be taken not to place

objects containing liquids, such as vases, upon the apparatus.

19. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in

susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently

intense noise for a sufficient time.

The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the following

permissible noise level exposures: According to OSHA, any exposure in excess of the above permissible limits could

result in some hearing loss. Earplugs or protectors to the ear canals or over the ears must be worn when operating

this amplification system in order to prevent a permanent hearing loss, if exposure is in excess of the limits as set

forth above. To ensure against potentially dangerous exposure to high sound pressure levels, it is recommended that

all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system

be protected by hearing protectors while this unit is in operation.

An apparatus with Class I construction shall be connected to a mains socket outlet with a protective connection. Do not defeat the safety purpose of the

polarized or grounding-type plug.

The mains plug or appliance coupler is used as the disconnect device and shall remain readily operable. The user should allow easy access to any

mains plug, mains coupler and mains switch used in conjunction with this unit thus making it readily operable.