Leisure VHL2 Manual

Leisure Køkkenvask VHL2

Læs gratis den danske manual til Leisure VHL2 (4 sider) i kategorien Køkkenvask. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Leisure VHL2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

1970-02

2. Fitthexingclipstothe

sink using the screws 

provided,asshownin

g. 2 and hinge them  

back away from   the

sinkedge.

3. Atthispointtrythesink

in the cut-out, some   

localised enlargement 

of the hole may be    

necessaryaroundthe

clips.

4. Fit the tap to the   

sink.

5. Fit the wastes to the sink following the       instructions

packedwiththem.

6. Fitthefoamsealtotheedgeofthesink.Peeloffthepaper

backingstripandstickthesealtotherecessinthesink

asshowning.3.Ensurethataneatbuttjointisachieved

wheretheendsofthesealmeet.

FITTINGTHESINK

1. Positionthesinkinthecut

out.

2. Tensionthexingclipsas

showning.4.

 Ensurethatthefoamseal

is carefully  compressed

butdonotovertightenthe

clips.

3. Completetheplumbingof

thehotandcoldsupplyto

thetap.

ALTERNATIVEMETHODOFSEALING

1. Applysiliconesealant (notsupplied)totheundersideof

thesinkrim,asshowning.5.

2. Removesurplussealantfromaroundthesinkusing dampa 

cloth.

NOTE: During installation care should be taken to ensure

the sinkisprotectedfromscuffsandscratches.Strainingand

overtighteningofallplumbingxturesconnectedtothesink

shouldbeavoided.Installersshouldcarefullycheckthatthe

moulding andthe edgesof the sinkare deadlevel so that

waterwillow thedrainer.off

PLEASEREADTHOROUGHLYBEFOREATTEMPTINGTO

INSTALLSINK.

PREPARINGTHEWORKTOP

1. Itisrecommendedthattheinsetsinkisttedtotheworktop

beforebeingpermanentlyxedtothecabinet.

2. Placethesinkupsidedownonworktop.Positionthesink

relativetotheworktopasrequired,ensuringthatthecabinet

frameworkwillbeclearofallpartsofthesink.

 Withasharpsoftpencildrawroundsinkasaccuratelyas

possible.Seeg.1.

3. Remove the sink and draw another line 10mm inside        

theout-lineofthesinktop.Thisisthecuttinglineforthe

aperture.

4. Drillaslarge holea aspossibleinsidethecuttingline.Using

apadsaw,jigsaworsimilar,cutouttheaperture.Atthis

pointwewouldrecommendthattheworktopapertureis

sealed. dothispaintoverwithap.v.a.adhesive,paint,To

varnishorsmearwithsiliconesealant.

PREPARINGTHESINK

1. Ifatapholeisrequired,buthasnotbeensuppliedinthe

sink,proceedasfollows.

 Decidewhetherthebowlistobeontheleftorrighthand

when thesink is tted.Cut the appropriate tapholeinto

thesink.Todothisyouwillneedaholesawortankcutter

settocutouta35mmdiameterholeandapilotdrill.On

thereversesideofthesinkyouwillndalocationpoint

forthepilotdrillinthecentreofthetapcut-out.Drillout

thepilothole.TurnthesinkoverandcarefullydrilLcOt4he

tap-hole.

WARNING: Velstra&Neostoneproduc includeasilicaller.ts

Anymachiningoperationwillproduceneparticlesofdust.

Drillingorcuttingmustbecarriedoutinawell-ventilated

area.

INSTALLATIONDETAILSVELSTRA®&NEOSTONESINKS

Produkt Specifikationer

Mærke:	Leisure
Kategori:	Køkkenvask
Model:	VHL2
Bredde:	980 mm
Dybde:	508 mm
Produktfarve:	Hvid
Første skål, dybde:	180 mm
Anden skål, dybde:	114 mm
Første skål, dimensioner (BxL):	350 x 433 mm
Anden skål, dimensioner (BxL):	154 x 298 mm
Antal vaskeskåle:	2 skåle
Vask, type:	Top-monteret vask
Vask form:	Rektangulær
Facon på første vask:	Rektangulær
Facon på anden vask:	Rektangulær
Vandhane, hul:	Ja
Drænebræt:	Ja
Antal huller til haner:	2
Størrelse på vandhane:	35 mm