LiftMaster 520 Manual

LiftMaster Garage døråbner 520

Læs gratis den danske manual til LiftMaster 520 (2 sider) i kategorien Garage døråbner. Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om LiftMaster 520, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

TM Universal Radio Control

OWNERS MANUAL

Transformer Model 85 may be required if your

garage door opener is a brand other than Lift-Master,

Chamberlain or Sears.

NOTE: Models 520-1LM and 520-2LM are factory pre-

set with matching receiver and remote control

codes. If you purchase additional remote controls,

the receiver may be programmed to match the new

remote control code (up to 4 “smart” remotes and

one Keyless Entry Transmitter).

THE RECEIVER MAY BE INSTALLED IN ONE OF TWO

WAYS:

1. Mounted directly on the door opener with clips

provided as shown on page one.

2. Attached to an inside wall of the garage with connecting

bell wire (not supplied) as shown on page two.

When installing two or more receivers in a garage,

position them at least 10 feet apart to prevent electronic

interference.

MOUNTING RECEIVER ON A COMMERCIAL OPENER

Fully extend antenna wire below bottom of case as shown.

Loosen the three terminal screws on the receiver

(labeled 1, 2 and 3). Insert one end of a mounting clip

under each terminal. Make sure the clips are positioned

to clear the receiver ﬂange, as shown.

Do not retighten

at this time.

Loosen the three terminal screws on the opener used for

push button controls and radio power.

Leaving the push button bell wire in place, insert the

other ends of the mounting clips under the opener

terminal screws.

NOTE: If the number sequence of opener terminals

doesn't match the receiver, turn the receiver around

(so back is facing out) and complete the connection.

Retighten the terminal screws on opener and receiver.

Reconnect power to the opener. The receiver push bar

should light. If it does not, use Transformer Model 85.

MOUNTING ON RESIDENTIAL OPENERS

Use a 2 wire connection

only.

Attach mounting clips

to receiver terminals 1 and 2, and to the opener

terminals used for push button controls. Plug the

transformer into the receiver as shown, and into a

120 Volt outlet.

Model 520LM

Receiver Only

Model 520-1LM

(With 1 Remote Control)

Model 520-2LM

(With 2 Remote Controls)

Page two contains wall mounting instructions and

service information as well as code setting

instructions.

Children operating or playing with a garage door

opener can injure themselves and others.

The

garage door could close and cause serious injury

or death.

Do not allow children to operate the

push buttons or the remote control transmitters.

Install the receiver (and any additional push

buttons) out of the reach of children and away

from all moving parts of the door and door

hardware, but

where the garage door is visible.

A moving garage door could injure someone

under it.

Activate the opener only when the door

is properly adjusted, you can see it clearly, and

there are no obstructions to door travel.

WARNING

Disconnect power to the garage door opener

before installing the receiver.

WARNING

To Outlet

Model 85

Transformer

OPENER

TERMINALS

Receiver

Terminals

Antenna Wire Fully Extended

Flange Mounting

Clip #1

Mounting

Clip #2

Mounting

Clip #3

Common

Push Button

Radio Power

To comply with FCC/IC rules, adjustment or modiﬁcation of receiver and/or

transmitter is prohibited, except for changing the code setting and replacing

the transmitter battery. THERE ARE NO USER SERVICEABLE PARTS.

NOTICE TO U. S. CONSUMERS:

Some states prohibit the service or repair of garage door

openers whch cannot be made to comply with the safety

standards contained in UL 325 (1988 revision). In order to

comply with both the letter and the spirit of these laws, this

universal radio control should not be used with any Lift-Master

®,

Chamberlain®, or Sears Craftsman®garage door opener

manufactured prior to April 1, 1982. To find out if your

Chamberlain-made garage door opener was manufactured prior

to or after April 1, 1982, please call 1-800-528-9131 before

installing this universal radio control.

SET RECEIVER TO MATCH REMOTE CONTROL(S) CODE

Pry open the front panel of receiver case with a coin or a

screwdriver.

1. Press and

hold

the remote control push button.

2. Then press and release the "Smart" button on the

receiver. The adjacent indicator light will

ﬂash

once.

Release the remote control push button.

The opener will now operate when the push button on

either the receiver or the remote control transmitter is

pressed.

Repeat Steps 1 and 2 for each remote control that

will be used to operate the garage door opener.

NOTE: If the remote control push button is not held

down until the receiver indicator light ﬂashes, the

receiver will not learn the code.

TO ERASE ALL REMOTE CONTROL CODES

• Press and hold the "Smart" code button on the

receiver panel until the indicator light turns oﬀ (about

6 seconds).

All

the codes the receiver has learned

will be erased.

• Repeat Steps 1 and 2 to reprogram the receiver for

each remote control transmitter in use.

MOUNTING RECEIVER ON GARAGE WALL

Fully extend the antenna wire below bottom of case.

Fasten the receiver to an inside garage wall with dry wall

screws provided. A convenient place is alongside the

service door and

OUT OF THE REACH OF CHILDREN.

Attach one end of 3-strand bell wire (not supplied) to

receiver terminals 1, 2 and 3. Connect the other end to

the three opener terminals used for push button controls

and radio power. Use insulated staples to secure bell

wire between receiver and opener.

Reconnect power to the opener. The receiver push bar

should light. If it does not, use Transformer Model 85.

NOTE: With the transformer, use a 2-wire

connection

only.

Attach wire to receiver terminals 1

and 2 and to the opener terminals used for push

button control. Plug the transformer into receiver

and 120 Volt outlet as shown.

To Wall Outlet

Model 85

Transformer

OPENER

WALL

PUSH

BUTTON

TRANS

PRIMARY

24v

Universal Radio

Control (Top)

Common

Push Button

Radio Pwr.

#3 Connection

(optional)

UNIVERSAL RECEIVER

The receiver can be set for either constant or momentary

closure on the output contacts. With the jumper in the

“MOM” (Momentary) position, the contacts will close for

1/4 second regardless of the length of radio

transmission. With the jumper in “CONST” (Constant)

position, the contacts will stay closed as long as the

radio continues transmitting.

The receiver is factory set at M.

TO SET OUTPUT DURATION

The use of radios incorporating constant closure

contacts on residential operators with fail-safe

infra-red protectors is prohibited.

WARNING

Remote Control Transmitter

Push Button

Smart

Button

Option Jumper

Indicator Light

UNIVERSAL RECEIVER

MOM.

CONST.

Output

Duration

Terminals

Jumper

MOMENTARY

OPERATION

MOM.

CONST.

Output

Duration

Terminals

Jumper

CONSTANT

OPERATION

Produkt Specifikationer

Mærke:	LiftMaster
Kategori:	Garage døråbner
Model:	520

Har du brug for hjælp?

Hvis du har brug for hjælp til LiftMaster 520 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Garage døråbner LiftMaster Manualer

LiftMaster 8500WMC-267 Manual

18 Maj 2024

LiftMaster 98022 Manual

6 Oktober 2023

LiftMaster 8550 Elite Manual

8 August 2023

LiftMaster 84602 Manual

26 Maj 2023

LiftMaster 8360 Premium Manual

8 Marts 2023

LiftMaster 81550 Manual

12 Februar 2023

LiftMaster 8365-267 Premium Manual

23 December 2022

LiftMaster 8165W Manual

15 December 2022

LiftMaster 520 Manual

7 December 2022

LiftMaster 8557 Elite Manual

6 December 2022

Garage døråbner Manualer

Nyeste Garage døråbner Manualer

Sommer Duo Vision 650 S3 Manual

12 August 2025

Sommer Duo Rapido 650+ Manual

12 August 2025

Chamberlain MyQ Starter Kit 180REV Manual

10 August 2025

Somfy Freevia Line Manual

3 August 2025

Somfy SGS Line Manual

3 August 2025

RADEMACHER RolloPort S2 Manual

10 Juli 2025

Sommer SM 40 Manual

10 Juli 2025

Sommer SG1 Manual

9 Juli 2025

Sommer STArter+ Manual

9 Juli 2025

Sommer SP900 Manual

9 Juli 2025