Marmitek IP850 Manual


Læs gratis den danske manual til Marmitek IP850 (4 sider) i kategorien Telefon. Denne vejledning er vurderet som hjælpsom af 56 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 28.5 anmeldelser. Har du et spørgsmål om Marmitek IP850, eller vil du spørge andre brugere om produktet?

Side 1/4
The ProGuard Interphone provides the ProGuard control panel with an external
microphone and speaker for Two-Way Audio applications.
Installation Pry-off
S
l
ot
Speake
r
Volume
Trimme
r
Power LED
To install the ProGuard Interphone:
1. Remove the two cover screws.
2. Lift the front cover away from the base.
3. a 2.5m cable with a 6-position RJ-11 connector is supplied
with the ProGuard Interphone. This cable can be spliced to a
24AWG solid four-core cable.
4. Thread the cable through the wiring hole on the back cover.
5. Mount the back cover to the wall using four mounting
screws.
6. Connect the cable to the terminal block on the ProGuard
Interphone as follows:
¬
¬
¬
¬¬
[White] +VPP
®
®
®
®®
[White] OUT (microphone)
[Blue] IN
(speaker)
¯
¯
¯
¯¯
[Orange] GND
Note: The +VPP wire is labeled for convenience
7. Plug the cable into the RJ-11 jack on the ProGuard Main board.
8. Replace the front cover and secure using the two cover screws.
Terminal
Block
Microphone
Microphone
Sensitivity
Jum
p
er
Speake
r
Microphone
Sensitivity
Trimm
e
r
Wiring
Hole
ProGuard Interphone
ProGuard MAIN BOARD
6-Position
RJ-11
Figure 2: Wiring
Connections
Figure 1: ProGuard Interphone (cover off)
© MARMITEK 2


Produkt Specifikationer

Mærke: Marmitek
Kategori: Telefon
Model: IP850

Har du brug for hjælp?

Hvis du har brug for hjælp til Marmitek IP850 stil et spørgsmål nedenfor, og andre brugere vil svare dig