MB Quart MBQS-RADM-1 Manual


Læs gratis den danske manual til MB Quart MBQS-RADM-1 (10 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om MB Quart MBQS-RADM-1, eller vil du spørge andre brugere om produktet?

Side 1/10
Installation Instructions
Model:
Polaris Slingshot Gen 3 (2020 to 2024)
Description:
MB Quart GMR-7 Radio Dash Kit for Polaris Slingshot
Part Number:
MBQS-RADM-1
Assembly Time:
45 Minutes (0.75-Hours)
2 T25 Torx Driver
3 T27 Torx Driver
4 T40 Torx Driver
5 8mm Allen Wrench
6 Phillips Screw Driver
Tools Required
It is always a best practice to disconnect your negative battery terminal prior to any electronics
installations to avoid damaging the vehicles electrical system. Before you begin, read through
these instructions and check that all parts are present.
This installation may require special skills and tools to complete and it may be necessary to seek
a trained installation technician to complete this installation. Please note that MB Quart cannot
assume any responsibility for damage resulting from incorrect installation.
No. Component Name Qty
1 Radio Dash Panel 1
2 Radio Harness 1
3 Antenna 1
4 PSAP-2USB 1
5 M4 x 10mm Phillips Screw 4
6 M4 Washer 4
7 8" Zip Tie 4
Parts List
Page 1 of 10
Disassembly Instructions
● Pull hood release on front of
vehicle and open hood.
● Remove two T27 Torx screws from
driver side and middle windsheild.
● Remove one T27 Torx screw from
passenger windshield.
● Remove screw, ff equipped with
the center windshield support.
Page 2 of 10


Produkt Specifikationer

Mærke: MB Quart
Kategori: Ikke kategoriseret
Model: MBQS-RADM-1

Har du brug for hjælp?

Hvis du har brug for hjælp til MB Quart MBQS-RADM-1 stil et spørgsmål nedenfor, og andre brugere vil svare dig