Mercusys ME80X Manual

Mercusys Wifi repeater ME80X

Læs gratis den danske manual til Mercusys ME80X (2 sider) i kategorien Wifi repeater. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om Mercusys ME80X, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Quick Installation Guide

Range Extender

Plug the extender into a power outlet your router. Wait until next to

its Signal LED turns solid on.

Note: For safety, only plug the extender in the direction as shown below.

1. Power On

Next to

Solid on

Router Extender

3. Relocate

Enjoy!

Connect your device to the extender using the extended network

name(s). The extender shares the same Wi-Fi password(s) as your router.

1. Plug in the extender about between your router and the Wi-Fi dead halfway

zone. The location you choose must be within the range of your router.

2. Wait for about 2 minutes until the Signal LED turns solid green. If it doesn't,

relocate the extender closer to the router to achieve better signal quality.

* Images are for demonstration only.

2. Set Up

Method 1: Via a Web Browser

1. Connect your wireless device to the extender (MERCUSYS_RE_XXXX).

Note: The default SSID (network name) is printed on the product label at the back of the extender.

2. Launch a web browser and visit http://mwlogin.net. Create a

password to log in.

3. Follow web instructions to complete the setup.

The Signal LED should turn solid green or orange, indicating a

successful connection to your router.

Method 2: Via the WPS Button

1. Press the WPS button on your router.

2. Within 2 minutes, press the or WPS RESET/WPS button on the

extender for 1 second.

The Signal LED should change from blinking to solid green or orange,

indicating a successful connection to your router.

Note: If the LED does not turn solid green or orange, try again or use Method 1.

Solid

green/orange

Solid

green/orange

Extended Network Name(s):

Same as your router or with

EXT

at the end

Password(s):

Same as your router

Router Extender Devices

Host Network Extended Network

Solid green: Suitable location

Solid orange: Too far from router

Solid red: Not connected to router

Q1. How do I reset the extender?

• With the extender powered on, press and hold the Reset RESET/WPSor

button until the Signal LED turns o, then release the button. When the

Signal LED turns solid on, the reset process is complete.

Q2. What should I do if I cannot access the extender’s web management

page?

• Make sure your wireless device is connected to the extended network

using the extended SSID.

• Verify that is correctly entered in the web browser.http://mwlogin.net

• If you are using a computer, make sure it is set to obtain an IP address

automatically. Unplug the Ethernet cable if any.

• Use another web browser and try again.

• Refer to to reset the extender and try again.Q1

Q3. What should I do if I forgot my login password of the web

management page?

• Refer to to reset the extender to its factory default settings, then Q1

create a password to log in.

Q4. What should I do if the Signal LED doesn’t turn solid green or orange

after completing setup via a web browser?

• You may have entered incorrect Wi-Fi password(s) for your router during

the setup. Check the password(s) and try again.

• Make sure the extender is close to your router, preferably within 16 feet,

and away from large electrical appliances.

• If you have enabled wireless MAC ltering, wireless access control, or

access control list (ACL) on your router, disable them rst, then follow any

FAQ (Frequently Asked Questions)

• Keep the device away from water, re, humidity or hot environments.

• Do not attempt to disassemble, repair, or modify the device. If you need service, please

• Do not use the device where wireless devices are not allowed.

• The socket-outlet shall be installed near the equipment and shall be easily accessible.

• For passthrough devices, plug the power strips into the integrated electrical

sockets of the devices, but devices of the same or another type not be stacked

in normal use. Do not plug in a row.

Please read and follow the above safety information when operating the device. We

cannot guarantee that no accidents or damage will occur due to improper use of the

device. Please use this product with care and operate at your own risk.

MERCUSYS hereby declares that the device is in compliance with the essential

requirements and other relevant provisions of directives 2014/53/EU, 2009/125/EC,

2011/65/EU and (EU)2015/863.

The original EU declaration of conformity may be found at

https://www.mercusys.com/en/ce.

MERCUSYS hereby declares that the device is in compliance with the essential

requirements and other relevant provisions of the Radio Equipment Regulations 2017.

The original UKCA declaration of conformity may be found at

https://www.mercusys.com/support/ukca/

For technical support, user manuals and more information,

please visit http://www.mercusys.com/support.

Safety Information

method on the front page to complete the conguration.

• Try setting up via the WPS button.

• Reset the extender and go through the setup again.

If you are still having problems, contact our technical support.

Power is o.

The extender is starting, or

connecting to the host network.

The extender is not connected to

the host network.

The extender is connected to the

host network and works well.

The extender is connected to the

host network, but is too far away

from the router.

O

Blinking

Solid Red

Solid Green

Solid Orange

StatusLED Indication (For Range Extender Mode)

LED Explanation

Signal

LED

Access Point Mode (if supported)

If your extender has an Ethernet port, you can also set up it as an access

point to transform your existing wired network to a wireless one.

For detailed instructions, please visit

http://www.mercusys.com

and go to

your extender’s support page to get its User Guide.

Wired Router Extender Devices

ernet4EthInternet

Ethernet

Produkt Specifikationer

Mærke:	Mercusys
Kategori:	Wifi repeater
Model:	ME80X

Har du brug for hjælp?

Hvis du har brug for hjælp til Mercusys ME80X stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Wifi repeater Mercusys Manualer

Mercusys ME25BE Manual

25 Juli 2025

Mercusys ME80X Manual

24 Marts 2025

Mercusys Halo H1200G Manual

3 Januar 2025

Mercusys ME60X Manual

28 August 2024

Mercusys ME50G Manual

23 Juli 2024

Mercusys MU6H Manual

26 November 2023

Mercusys ME30 Manual

14 September 2023

Mercusys ME10 Manual

16 December 2022

Mercusys ME70X Manual

23 November 2022

Mercusys ME20 Manual

8 Oktober 2022

Wifi repeater Manualer

Nyeste Wifi repeater Manualer

CSL 303084 Manual

7 September 2025

CSL 301427 Manual

7 September 2025

TP-Link AX1500 Manual

5 September 2025

Extron PowerCage FOX Tx AV MM Manual

28 August 2025

Extron PowerCage FOX Tx VGA MM Manual

27 August 2025

TP-Link RE655BE Manual

22 August 2025

Vonets VAR11N-300 Manual

22 August 2025

Vonets VAP11N-300 Manual

21 August 2025

Cudy RE1200 Outdoor Manual

21 August 2025

Keenetic Buddy 6 KN-3411 Manual

17 August 2025