Mercusys MS106LP Manual

Mercusys Ikke kategoriseret MS106LP

Læs gratis den danske manual til Mercusys MS106LP (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om Mercusys MS106LP, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/3
© 2023 MERCUSYS 7107500255 REV1.0.0
LED Explanation Switch Explanation
O: Ports run at100/10 Mbps and support PoE power supply up to 100m away.
On: Ports run at 10 Mbps and support PoE power supply up to 250m away.
Extend
MS106LP
Quick Installation Guide
For technical support, replacement services, user guides, and other
information, please visit https://www.mercusys com/support/..
Connection
PC
PoE Ports (1-4)
1. PoE ports can also connect to non-PoE devices, but only transmit data.
2. Non-PoE ports (ports 5-6) are recommended to connect to uplink devices like routers.
3. Ports 1-2 have higher priority than other ports in transmitting data if network
congestion occurs. It is recommended to connect key network devices (network
cameras, APs, etc.) to ports 1-2.
Notes:
Internet
IP Camera AP IP Phone
Powered Device (PD)
Power
On: The power is on
O: The power is o
Link/Act Status
On: Link present but no activity
Flashing: Transmitting or receiving data
O: No link
PoE Status
On: The port is providing PoE power
O: The port is not providing PoE power
O: The PoE Auto Recovery function is disabled.
On: The switch will constantly detect the working status of a PoE powered device (PD).
When the switch nds that the PD works abnormally, the switch will reboot it.
Recovery
O: Ports can transmit data with each other.
On: Ports 1-4 cannot transmit data with each other. They can transmit data only with the
uplink ports (ports 5-6).
Isolation
Ethernet Ports (1-6)
Power Adapter
Mercusys hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU,
2009/125/EC, 2011/65/EU and (EU)2015/863.
The original EU declaration of conformity may be found at
https://www.mercusys.com/en/ce/
EU declaration of conformity
General Specications
Specications
IEEE 802.3i, IEEE 802.3u, IEEE 802.3x
CSMA/CD. 802.3af/at PD supported
6 10/100 Mbps RJ45 Ports Auto-Negotiation/Auto MDI/MDIX
PoE Ports: Port 1–4
10BASE-T:2-pair UTP/STP (≤100m) of Cat. 3 or above
100BASE-TX:2-pair UTP/STP (≤100m) of Cat. 5 or above
1000BASE-T:4-pair UTP/STP (≤100m) of Cat. 5e or above
1.2 Gbps
2K
Store-and-Forward
Automatically learning, automatically aging
External Power Adapter
Input: 100-240 VAC, 50/60 Hz
Output:
53.5 VDC/0.81 A
40 W (up to 30 W for each PoE port)
Standard
Network Media (Cable)
MAC Address Table
Interface
Switching Capacity
Protocol
Power Supply
Forwarding Method
MAC Address Learning
Safety Information
Keep the device away from water, re, humidity or hot environments.
Do not attempt to disassemble, repair, or modify the device. If you need service,
please contact us.
Place the device with its bottom surface downward.
Do not use damaged charger or USB cable to charge the device.
Do not use any other chargers than those recommended.
Adapter shall be installed near the equipment and shall be easily accessible.
PoE Budget
Frequently Asked Questions (FAQ)
The Power LED should be lit when the power system is working normally. If the Power
LED is not lit, please check as follows:
A1:
Make sure the AC power cord/power adapter is connected the switch with power
source properly.
A2:
Make sure the voltage of the power supply meets the requirements of the input
voltage of the switch.
A3:
Make sure the power source is on.
Q1. Why is the Power LED not lit?
It is recommended that you check the following items:
A1:
Make sure that the cable connectors are rmly plugged into the switch and the
device.
A2:
Make sure the connected device is turned on and working well.
A3:
The cable must be less than 100 meters long (328 feet). If Extend Mode is enabled,
it should be less than 250 meters (820 feet).
Q2. Why is the Link/Act LED not lit when a device is
connected to the corresponding port?
When the total power consumption of connected PoE devices exceeds the maximum,
the PoE port with a smaller port number has a higher priority. The system will cut o
power to the ports with larger port numbers to ensure supplying to other ports.
For example, if port 1, 2 and 4 are consuming 10 W respectively, and an additional PoE
device with 15 W is inserted to port 3, the system will cut o the power of port 4 to
compensate for the overload.
Q3. Why are PoE ports not supplying power for PoE devices?
A1:
Before upgrading a connected PoE powered device (PD), disable PoE Auto
Recovery to avoid the PD’s damage.
A2:
When a PD does not send data packets to the switch for a long period in certain
scenarios (e.g. an IPC in sleep mode), disable PoE Auto Recovery to avoid the PD
repeatedly rebooting.
Q4. What should I notice before using the PoE Auto Recovery
feature?
Environmental and Physical Specications
CE, RoHS
0˚C to 40˚C (32˚F to 104˚F)
-40˚C to 70˚C (-40˚F to 158˚F)
10% to 90% non-condensing
5% to 90% non-condensing
Certication
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
Mercusys hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of the Electromagnetic Compatibility
Regulations 2016 and Electrical Equipment (Safety) Regulations 2016.
The original UK declaration of conformity may be found at
https://www.mercusys.com/support/ukca/
UK declaration of conformity

Produkt Specifikationer

Mærke: Mercusys
Kategori: Ikke kategoriseret
Model: MS106LP

Har du brug for hjælp?

Hvis du har brug for hjælp til Mercusys MS106LP stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Mercusys Manualer

Mercusys

Mercusys MA12N Manual

19 August 2025
Mercusys

Mercusys MA37BE Manual

24 Juli 2025
Mercusys

Mercusys MA550H Manual

24 Juli 2025
Mercusys

Mercusys MA14H Manual

24 Juli 2025
Mercusys

Mercusys MS120GP Manual

24 Juli 2025
Mercusys

Mercusys MS106P Manual

6 Juni 2025
Mercusys

Mercusys MS124GS Manual

4 Juni 2025
Mercusys

Mercusys MS110CMP Manual

4 Juni 2025
Mercusys

Mercusys MS118CP Manual

3 Juni 2025
Mercusys

Mercusys MA310E Manual

3 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

SilverCrest

SilverCrest SSVM 40 B1 Manual

25 August 2025
Watson

Watson B-4246 Manual

25 August 2025
Vestil

Vestil BOL-42-2 Manual

25 August 2025
SilverCrest

SilverCrest HG10599 Manual

25 August 2025
Parkside

Parkside PAK 20-Li A1 Manual

25 August 2025
Vestil

Vestil P-HOP-1.5 Manual

25 August 2025
Everpure

Everpure EZ-RO 650 Manual

25 August 2025
ATen

ATen CE980 Manual

25 August 2025
Wesco

Wesco 272941 Manual

25 August 2025
Deye

Deye SUN-8K-SG01LP1-EU Manual

25 August 2025