Metra GMOS-LAN-10 Manual


Læs gratis den danske manual til Metra GMOS-LAN-10 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 38 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 19.5 anmeldelser. Har du et spørgsmål om Metra GMOS-LAN-10, eller vil du spørge andre brugere om produktet?

Side 1/4
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
GMOS-LAN-10
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 7/3/18 INSTGMOS-LAN-10
INTERFACE COMPONENTS
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink
• Tape • Wire cutter • Zip ties
TABLE OF CONTENTS
Connections to be made .......................................2
Installing the GMOS-LAN-10 ..................................3
Programming the GMOS-LAN-10 ..........................3
Adjusting the GMOS-LAN-10 ..................................3
Troubleshooting .....................................................3
GM Data Interface 2016-up*
APPLICATIONS
CHEVROLET
Colorado (with IOB radio) 2017-up
Cruze, Cruze Hatchback
(with IOA radio) 2016-up
Equinox (with IOB radio) 2018-up
Malibu (with IOA radio) 2016-up
Silverado (with IOB radio) 2016-up
GMC
Canyon (with IOB radio) 2017-up
Sierra (with IOB radio) 2016-up
• GMOS-LAN-10 interface • GMOS-LAN-10 harness
• 16-pin harness with stripped leads
*Visit AxxessInterfaces.com for up-to-date vehicle specific applications.
* The IOA/IOB code, if applicable, can be found in the “Service Parts Identification” label located:
• Glovebox – Canyon/Colorado/Cruze/Equinox/Silverado/Sierra • Rear compartment floor – Malibu
INTERFACE FEATURES
Provides accessory power (12-volt 10-amp)
Retains R.A.P. (retained accessory power)
Provides NAV outputs (parking brake, reverse, and speed sense)
Retains chimes
Pre-wired ASWC-1 harness (ASWC-1 sold separately)
Retains OnStar / OE Bluetooth
Adjustable OnStar level
Retains the factory backup camera†
• Can be used in both amplified and non-amplified models (excluding Bose)
Retains balance and fade
Micro “B” USB updatable
† Excluding Trucks 2018-up
2
CONNECTIONS TO BE MADE
From the 16-pin harness with stripped leads to the aftermarket radio:
Connect the wire to the accessory wire.Red
If installing an ASWC-1 (sold separately), there will be an accessory wire on the Note:
GMOS-LAN-10 harness to connect as well.
If
the vehicle is equipped with a factory amplifier (excluding Bose), connect the wire Blue/White
to the amp turn on wire. This wire must be connected to hear sound from the factory amplifier
.
If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
If the aftermarket radio has a mute wire, connect the wire to it. If the mute wire is Brown
not connected, the radio will turn off when OnStar is activated.
Connect the wire to the right front positive speaker output.Gray
Connect the Gray/Black wire to the right front negative speaker output.
Connect the wire to the left front positive speaker output.White
Connect the wire to the left front negative speaker output.White/Black
The following (3) wires are only for multimedia/navigation radios that require these wires.
Connect the wire to the VSS/speed sense wire.Blue/Pink
Connect the wire to the reverse wire.Green/Purple
Connect the wire to the parking brake wire.Light Green
Tape off and disregard the following (4) wires, they will not be used in this application.
Green Green/Black Purple Purple/Black, , ,
From the GMOS-LAN-10 harness to the aftermarket radio:
Connect the wire to the ground wire.Black
Connect the Yellow wire to the battery wire.
If installing an ASWC-1 (sold separately), connect the wire to accessory power.Red
Connect the wire to the left rear positive speaker output.Green
Connect the wire to the left rear negative speaker output.Green/Black
Connect the wire to the right rear positive speaker output.Purple
Connect the wire to the right rear negative speaker output.Purple/Black
The Black/Yellow wire is used for OnStar level adjustment for models that do not come equipped
with steering wheel controls. See the OnStar level Adjustment section for further instructions
.
If retaining the factory backup camera, connect the Yellow RCA jack to the reverse camera input
.
12-pin pre-wired ASWC-1 harness:
This harness is to be used along with the optional ASWC-1 (not included) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.
Disregard the harness that comes with the ASWC-1.
Note: The relay attached to the GMOS-LAN-10 harness is only for audible turn signal clicks. No
extra steps are required to retain this feature, so leave the relay as-is.


Produkt Specifikationer

Mærke: Metra
Kategori: Ikke kategoriseret
Model: GMOS-LAN-10

Har du brug for hjælp?

Hvis du har brug for hjælp til Metra GMOS-LAN-10 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Metra Manualer

Metra

Metra AXHN-2 Manual

19 August 2025
Metra

Metra 99-8211 Manual

1 Juli 2025
Metra

Metra 99-9303 Manual

23 Juni 2025
Metra

Metra 98-7599 Manual

19 Juni 2025
Metra

Metra 99-6537B Manual

19 Juni 2025
Metra

Metra 99-7415 Manual

19 Juni 2025
Metra

Metra 99-2002 Manual

19 Juni 2025
Metra

Metra 99-3106 Manual

19 Juni 2025
Metra

Metra 99-6525HG Manual

19 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer