Microsemi PD-3501G/AC Manual

Microsemi Netværkskort/adapter PD-3501G/AC

Læs gratis den danske manual til Microsemi PD-3501G/AC (4 sider) i kategorien Netværkskort/adapter. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om Microsemi PD-3501G/AC, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/4
MMiiccrroosseemmii 33550011GG UUsseerr GGuuiiddee
1
1-
-P
Po
or
rt
t
8
80
02
2.
.3
3a
af
f
G
Gi
ig
ga
ab
bi
it
t
P
Po
oE
E
M
Mi
id
ds
sp
pa
an
n
Notice
It is Microsemi’s policy to improve its products as new
technology, components, software, and firmware become
available. Microsemi, therefore, reserves the right to change
specifications without prior notice.
Technical Support
If you encounter problems when installing or using this
product, please consult the Microsemi website at:
http://www.Microsemi.com
For technical support, call: +972-9- - 775 5123
In the USA: 1-877- -2323 480
Email: sales.support@microsemi.com
Microsemi Corp.
Recycling and Disposal
Disposal instructions for old products. The WEEE
(Waste Electrical and Electronic Equipment)
national environmental initiatives has been put
in place to ensure that products are recycled
using best available treatment, recovery and
and recycling techniques to ensure human
health and high environmental protection. Your
product is designed and manufactured with
high quality materials and components which
can be recycled and reused. Do not dispose of
your old product in your general household
waste bin. Inform yourself about the local
separate collection system for electrical and
electronic products marked by this symbol:
Use one of the following disposal options :
1. Dispose of the complete product (including
its cables, plugs and accessories) in the
designated WEEE collection facilities.
2. If you purchase a replacement product,
return your old product (including all er
components) back to the retailer. The retailer
should accept it as required by the national
WEEE legislation.
Note: Unless otherwise noted, references to the
PD-3501G/AC in this document refer to both the PD-3501/AC
and the PD-3501G/AC.
Ordering information:
1-Port 802.3af Gigabit PoE Midspan:
o oduct Name: Microsemi Pr 3501G
o Part Number: -3501G/AC PD
1-Port 802.3af PoE Midspan
o Product Name: Microsemi 3501
o Part Number: -3501/AC PD
Document P/N: 06- -056 Rev. B00 0066
Safety Information
Important Safety Information
The -3501G should be connected to PoE networks PD
only, without routing to the outside plant.
Only qualified personnel can install or remove the
PD- . 3501G
AC Power Cord Set:
The power cord must have regulatory agency approval for
the specific country in which it is used (for example UL,
CSA, VDE, etc.).
The power cord must be a three-conductor type (two
current carrying conductors; one ground conductor)
terminated on one end by an IEC 60320 appliance coupler
(for connection to the -3501G), and on the other end by PD
a plug containing a ground (earthing) contact.
The power cord must be rated for a minimum of 250 VAC
RMS operation, with a minimum rated current capacity of
5 amps (or a minimum wire gauge of 18 AWG (0.75 mm2).
: A PD- installed in Australia requires power cords 3501G
with a minimum wire gauge of 16 AWG (1.0 mm2
).
: The - "DATA IN" and "DATA POWER OPD 3501G & UT"
ports are shielded RJ45 data sockets. They be used as cannot
Plain Old Telephone Service (POTS) telephone sockets. Only
RJ45 data connectors can be connected to these sockets.
The AC wall socket-outlet must be near the - PD 3501G
and easily accessible. You can remove AC power from
the - by disconnecting the AC power cord from PD 3501G
either the wall socket-outlet or the - appliance PD 3501G
coupler.
The -3501G DATA IN DATA POWER O PD and & UT
interfaces are qualified as Safety Extra-Low Voltage
(SELV) circuits according to IEC 60950-1. These
interfaces can only be connected to SELV interfaces on
other equipment.
WARNINGS!
The -3501G should only be connected to the IP PD
device with which it was bought. Using the -3501G PD
with other IP devices can cause damage to the IP
device.
Read the installation instructions before connecting the
PD- to its power source. 3501G
Follow basic electricity safety measures whenever
connecting the -3501G to its power source. PD
A voltage mismatch can cause equipment damage and
may pose a fire hazard. If the voltage indicated on the
label is different from the power outlet voltage, do not
connect the - to this power outlet. PD 3501G
The unit can be used only in Restricted Access
Locations.

Produkt Specifikationer

Mærke: Microsemi
Kategori: Netværkskort/adapter
Model: PD-3501G/AC

Har du brug for hjælp?

Hvis du har brug for hjælp til Microsemi PD-3501G/AC stil et spørgsmål nedenfor, og andre brugere vil svare dig


Netværkskort/adapter Microsemi Manualer

Microsemi

Microsemi 9606 G Manual

30 August 2024
Microsemi

Microsemi PD-9612G Manual

30 August 2024
Microsemi

Microsemi 9612 G Manual

30 August 2024
Microsemi

Microsemi PD-9606G Manual

30 August 2024
Microsemi

Microsemi PD-3501G/AC Manual

30 August 2024

Netværkskort/adapter Manualer

Nyeste Netværkskort/adapter Manualer

Tripp Lite

Tripp Lite N286-40G-ESR4-G Manual

31 Juli 2025
Tripp Lite

Tripp Lite N286-100G-SR4SG Manual

31 Juli 2025
Tripp Lite

Tripp Lite N286-01G-SX-C Manual

31 Juli 2025
Tripp Lite

Tripp Lite NGI-U08C2 Manual

31 Juli 2025
Tripp Lite

Tripp Lite N286-01G-SX-A Manual

30 Juli 2025
Tripp Lite

Tripp Lite NPOE-30W-1G Manual

30 Juli 2025
Tripp Lite

Tripp Lite N286-40G-ESR4-C Manual

30 Juli 2025
Tripp Lite

Tripp Lite N286-10G-SR-J Manual

30 Juli 2025
Tripp Lite

Tripp Lite NGI-M04C2 Manual

30 Juli 2025
Tripp Lite

Tripp Lite N286-10G-SR-G Manual

30 Juli 2025