2
Preface
Copyright
Copyright © 2006, Microtek International, Inc., all rights reserved. This document may not be
reproduced or copied in any way, stored electronically, or translated into any language, without the
permission of Microtek International, Inc.
Disclaimer
The contents of this manual have been checked carefully for accuracy, and every effort has been made
to ensure that there are no errors. However, Microtek makes no guarantee as to the accuracy of the
contents of this document and reserves the right to make changes to the contents without prior warning.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Federal Communications Commission (FCC) Statement
This equipment (Model Type: ML42C1H) has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user's authority to operate the equipment.
I49-004082 A
September 2006
Microtek Lab, Inc.
16941 Keegan Avenue, Carson, CA 90746
Main: 310-687-5800, Fax: 310-687-5950, http://www.microtekusa.com
Microtek International, Inc.
6, Industry East Road 3, Science Based Industrial Park Hsinchu, 300, Taiwan
Tel: 886-3-5772155, Fax: 886-3-5772598, http://www.microtek.com
