Middle Atlantic WMRK-Z4 Manual


Læs gratis den danske manual til Middle Atlantic WMRK-Z4 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om Middle Atlantic WMRK-Z4, eller vil du spørge andre brugere om produktet?

Side 1/4
I-00373 Rev C
SHOWN: WMRK Inside Corner
The FLOOR MOUNTING HARDWARE is supplied by the Installer and approved by the Field Engineer
who will rate the entire job.
Four (4) 1/2” Anchor Bolts are required.
Includes four (4) brackets and three (3)
ARRHK hardware kits containing eight (8)
oval nuts and eight (8) bolts each.
INSTALLATION
Install as shown.
NOTE: The leveling foot rivnut located in the corner
does not need to be removed. Tighten the floor
anchor completely. Deflection will occur around the
rivnut. This is required, it pre-loads the corner in
compression.
SEISMIC BRACKET
(One in each corner of the WMRK)
- OR -
HARDWARE
Page 2
The REMOVABLE KNOCKOUT PLATE (BOTTOM) must NOT be removed for seismic certification to stay in
effect (may differ based on enclosure). Enclosure must be plumb and level in 2 directions.
REMOVABLE
KNOCKOUT
PLATE
(DO NOT REMOVE)
TYPICAL
CORNER
OF WMRK
The Seismic Bracket must be snug
against the rack sides
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the literature accompanying the appliance.
ATTENTION
IMPORTANT NOTE


Produkt Specifikationer

Mærke: Middle Atlantic
Kategori: Ikke kategoriseret
Model: WMRK-Z4

Har du brug for hjælp?

Hvis du har brug for hjælp til Middle Atlantic WMRK-Z4 stil et spørgsmål nedenfor, og andre brugere vil svare dig