Mini-Box picoPSU-150-XT Manual


Læs gratis den danske manual til Mini-Box picoPSU-150-XT (4 sider) i kategorien Computer strømforsyning. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Mini-Box picoPSU-150-XT, eller vil du spørge andre brugere om produktet?

Side 1/4
Mini-Box.com ATX DC-DC Converter Series
pixoPSU 150- -XT Quick Installation Guide Page 1
picoPSU 150- -XT
12V, 150Watt, 24pin ATX Power Supply
Quick Installation Guide
Version 1.0a
P/N picoPSU- -150 XT
Introduction
The picoPSU- -XT is a small yet powerful and fully compliant ATX power 150
supply designed to power a wide variety of motherboard from a single 12V
regulated power source.
The PICOPSU- -XT is the only snap power supply solution for general150
purpose motherboards. Compatible with an entire range of mini-ITX, UATX or full
size ATX motherboards the picoPSU- -XT provides cool, silent power for 150
system. The PICOPSU- -XT has many advantages over a regular power 150
supply:
- Smallest 24 pin ATX PSU to date
- silent operation100%
- Low heat dissipation with efficiency over 95%
- Plugs directly into the motherboard’s power connector, no cable mess
- Solid Capacitor design, very long life design.
- 12V Aux power connector designed to support processors with TDP of 35 or
65Watts.
- 2nd HDD power harness connector.
Mini-Box.com ATX DC-DC Converter Series
pixoPSU 150- -XT Quick Installation Guide Page 2
Quick installation Instructions
The PICOPSU- -XT has been specifically designed for the Mini-ITX form 150
factor, thus eliminating the need for ATX power cables. It is also 1U compliant –
height will not exceed 1U form factor.
1) After the picoPSU module was ‘snapped in’, hook the hard drive power or
floppy power to your floppy/hard drives. If more hard drives or floppy connectors
are needed, use a HDD/floppy “Y” splitter cable.
Fig 1.1 picoPSU-120 plugged into ATX connector.
2) Connect a 12 VDC power adapter (or any 12V source) to the DC- -to DC
connector, center pin / white wire is positive (+).
3) Turn on the PC using the motherboard ON/OFF switch
Typical configuration
The picoPSU- -XT has been tested with all mini- board under virtually any 150 ITX
disk/floppy/CDROM/PCI configuration. Additionally, the PICOPSU- -XT can 150
power boards that require 4 pin 12V aux power connector to be used with
processors with TDP ranging from 35 to 65watts.
Removing the picoPSU- -XT150
In order to remove the picoPSU you must release the power connector latch and
then remove the unit. Gently lift the picoPSU out from the ATX connector, by
grabbing from the picoPSU PCB, not from components or the wire harness.


Produkt Specifikationer

Mærke: Mini-Box
Kategori: Computer strømforsyning
Model: picoPSU-150-XT

Har du brug for hjælp?

Hvis du har brug for hjælp til Mini-Box picoPSU-150-XT stil et spørgsmål nedenfor, og andre brugere vil svare dig