THANK YOU FOR CHOOSING A MORLEY 20/20 POWER WAH VOLUME.
YOU NOW OWN THE BEST PEDAL MADE!
Please take a few minutes to familiarize yourself with the features of your new pedal.
We hope you enjoy using it as much as we enjoyed building it.
ABOUT OUR BUFFER CIRCUIT:
All Morley 20/20 pedals come equipped with our Buffer Circuit. This circuit prevents volume loss or tone
change to the instrument. It also allows the use of long cables or pedals boards with lots of pedals and
connection cables. You’ll sound and feel better GUARANTEED!
ABOUT OUR OPTICAL CIRCUITRY:
Optical design ensures smooth pedal control of Wah, volume and/or switching that won’t get scratchy and
wear out like potentiometer (pot) controlled pedals.
9V: ONLY Morley's 9VDC 300 milliamp regulated adapter should be used.
IN: Input jack. Plug instrument into this jack using 1/4" guitar cable.
OUT: Connect amplifier to this jack using a 1/4" guitar cable.
All Morley pedals use Morley's 9VDC 300 milliamp regulated adapter. Center pin polarity is negative.
Using a non-regulated adapter could cause a low frequency hum in your amplifier. Using an adapter with
the wrong polarity may damage the pedal.
All Morley pedals are designed to use one 9V battery when not using an adapter. We suggest you use a
good quality alkaline battery. To prolong battery life, unplug your cord completely from the input jack when
not using the pedal. When the pedal is not used for extended periods, remove the battery from the pedal.
Our “Quick Clip” Bettery door allows easy access to battery compartment.
All Morley® pedals are warranted for one year with copy of dated purchase receipt. To obtain warranty
service, contact store where pedal was purchased or email service@morleyproducts.com
Lifetime warranty is available at no charge, register at www.morleyproducts.com
20/20 POWER WAH VOLUME FEATURES (MODEL MTPWOV):
SWITCHED WAH: Stomp switch switches between Wah and
volume. You can use Wah as tone filter by leaving in desired
position. Volume level can be set by leaving pedals in any desired
position. Silent switching prevents switch noise from coming
WAH BOOST: Allows you to adjust Wah Level up to 20dB
Power: 9V Battery or 9VDC 300mA regulated (center negative)
Indicator (right): Wah Mode LED on, Volume Mode LED off
Dimensions: 6.75" L x 4.5" W x 2.75" H
Current Draw: 6 mA @ 9VDC
Glow-In-The-Dark Treadle Grip
Glow-In-The-Dark Toe End Logo
