Mvision HD100S Manual

Mvision Digitale dekodere tunere HD100S

Læs gratis den danske manual til Mvision HD100S (50 sider) i kategorien Digitale dekodere tunere. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Mvision HD100S, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/50
SAFETY PRECAUTION
CAUTION:
The lightening flash with
arrowhead symbol, within
an equilateral triangle, is
intended to alert the user
to "dangerous voltage"
and to prevent from a risk
of electric shock.
Warning:
To reduce the risk of
electric shock, don't open
the cabinet. Refer
servicing to qualified
personnel only.
The exclamation point
within an equilateral
triangle is intended to
alert the user to important
operating and
maintenance (servicing).
WARNING: The apparatus shall not be exposed to dripping or splashing and
that no objects filled with liquids, such as vases, shall be placed on the
apparatus.
WARNING: Do not place naked flame sources, such as lighted candles on the
apparatus; otherwise, there is the danger of fire.
WARNING: The unit should be connected to a power supply only of the type
descry bed in the operating instructions or as marked on the unit. If you are not
sure of the type of power supply (for example: 120 or 230V) to your home,
consult your local dealer or local power company.
WARNING: Do not open the cabinet or touch any parts in the inner mechanism.
Consult your local dealer for technical service if the opening is required.
WARNING: The mains plug is used as the disconnect device, the disconnect
device shall remain readily operable.
WARNING: Take attention to the environmental aspects of battery disposal. The
battery of remote control should not be exposed excessive heat such as
sunshine, fire or the like.
WARNING: Maintenance man must use the appointed screw in the rear plate.
WARNING: Ensure a minimum distance of 5 cm around the apparatus for
sufficient ventilation.
WARNING: Ensure that the ventilation is not impeded by covering the
ventilation openings with items such as newspapers, table-cloths, curtains, etc.
WARNING: Use the apparatus only in moderate climates (not in tropical
climates).
Note: Do not open the cabinet to avoid the unit direct exposure to radiation.
Unit Cleaning:
A
fter the unit power is turned off, you can clean the cabinet,
panel and remote control with a soft cloth lightly moistened with a mild detergent
solution.
Attachments: Never add any attachments and/or equipment without the
manufacturer consent; as such additions may result in the risk of fire, electric
shock or other personal injury.
Locating: Slots and openings in the cabinet are provided for ventilation to
protect it from overheating. Do not block these openings or allow them to be
blocked by placing the STB on a bed, sofa or other similar surface, nor should it
be placed over a radiator or heat register.
Power-Cord Protection: Place the power-supply cord out of the way, where it
will not be walked on. Please take special attentions to cords at plugs,
convenience receptacles and the point where they exit from the unit.
Object and Liquid Entry: Never put objects of any kind into this STB through
openings, as they may touch dangerous voltage points or short-out parts that
could result in a fire or electric shock. Never spill any liquid on the STB.
Note: Moisture may be formed inside the unit in the following conditions:
When the unit is suddenly moved from a cold environment or an air-condition
room to a warm place.
Immediately after a heater has been turned on.
In a steamy or very humid room.
If the moisture forms inside the unit, it may not operate properly. To correct this
problem, turn on the power and wait about two hours for the moisture to
evaporate.
Parts Replacement: When the unit parts need to be replaced, user should
make sure the service technician use the replacement parts specified by the
manufacturer or having the same characteristics as the original part.
Unauthorized replacement may put the unit in the risk of fire, electric shock or
other hazards.
Safety Check: After all the maintenances and repairs are done, user is required
to request the service technician to conduct the overall safety check to ensure
the machine is in the proper condition.

Produkt Specifikationer

Mærke: Mvision
Kategori: Digitale dekodere tunere
Model: HD100S

Har du brug for hjælp?

Hvis du har brug for hjælp til Mvision HD100S stil et spørgsmål nedenfor, og andre brugere vil svare dig


Digitale dekodere tunere Mvision Manualer

Mvision

Mvision S3 Manual

9 Juli 2024
Mvision

Mvision HD100S Manual

9 Juli 2024

Digitale dekodere tunere Manualer

Nyeste Digitale dekodere tunere Manualer

Strong

Strong srt 55 Manual

15 Januar 2025
Metronic

Metronic T2 HD zapbox Manual

19 December 2024
Aston

Aston xena 1700 Manual

27 August 2024
Aston

Aston Simba 201 Manual

27 August 2024
Aston

Aston xena 2000 Manual

27 August 2024
Topfield

Topfield TF-3000CI Manual

26 August 2024
Lyngbox

Lyngbox LB-1ST Manual

26 August 2024
Topfield

Topfield tf 6000 cot Manual

26 August 2024
Topfield

Topfield tf 4000 fe Manual

26 August 2024
Topfield

Topfield tf 3000 cot d Manual

26 August 2024